Add WMI support for building and sending the
WMI_TWT_ENABLE_CMDID to the firmware.
Change-Id: Ifbda4d1668e2bcb2e33d044269908e8d4c8333a5
CRs-Fixed: 2244214
Send average radar parameters to FW.
Extract host dfs spoof check status from FW.
Change-Id: I70c4e5aad0fe1eda55da37abd20cc6d70728edba
CRs-Fixed: 2211883
Address the following issues in the wmi folder:
CHECK: 'addres' may be misspelled - perhaps 'address'?
CHECK: 'COMAND' may be misspelled - perhaps 'COMMAND'?
CHECK: 'defintion' may be misspelled - perhaps 'definition'?
CHECK: 'happend' may be misspelled - perhaps 'happened'?
CHECK: 'managment' may be misspelled - perhaps 'management'?
CHECK: 'messsage' may be misspelled - perhaps 'message'?
CHECK: 'overriden' may be misspelled - perhaps 'overridden'?
CHECK: 'poiter' may be misspelled - perhaps 'pointer'?
CHECK: 'refering' may be misspelled - perhaps 'referring'?
CHECK: 'refrence' may be misspelled - perhaps 'reference'?
CHECK: 'shrinked' may be misspelled - perhaps 'shrunk'?
CHECK: 'succesfully' may be misspelled - perhaps 'successfully'?
CHECK: 'succesful' may be misspelled - perhaps 'successful'?
Change-Id: Ie97e4d83cc88a2610524b38adc3474cdd31170d9
CRs-Fixed: 2241590
Add changes to support get congestion stats(arp stats) from
within cp_stats component.
Change-Id: Ic3b2f020c0169c9113c1b40738f782cbb3b8f6c5
CRs-Fixed: 2222781
Remove duplicate structs wmi_dual_mac_config and sir_dual_mac_config
and use policy_mgr_dual_mac_config.
Change-Id: I6da6539f519ec46ee274ba3f3ae042e5fd9c25d2
CRs-Fixed: 2191031
Number of AP TWT and AP TWT stations are added in
target_resource_config to provide the configuration for TWT.
Add support in WMI to provide appropriate defaults for TWT.
Change-Id: Ica91f981d59a015b0b4cda41ba951b6ba22e8120
CRs-Fixed: 2212667
Add get channel width from phy mode API which will be used by
ndp schedule update event.
Change-Id: I13d00c0b818eb0da434c8a5372b2ab7b6693f22a
CRs-Fixed: 2216801
When SWBA event is enabled, the FW will sent an event to the
host on every TBTT beacon.
Note that, unlike the legacy offload chips, this event is not
used by the host to send out the beacon frame itself.
Change-Id: Icf4440d79f7dbfb544f9d98c4de0e84bdb150459
CRs-Fixed: 2200805
Add ini "min_delay_btw_scans" to set minimum duration allowed between
two consecutive roam scans. Fw should not allow roam scan if duration
between two consecutive roam scan is less than min_delay_btw_scan.
Add ini "roam_trigger_reason_bitmask" to set default value of
bit-mask containing roam_trigger_reasons for which
min_delay_btw_scans constraints should be apply.
Pass value of min_delay_btw_scans and roam_trigger_reason_bitmask
to fw.
Change-Id: I2397467a13a720e763d1181d8cd50c571f861366
CRs-Fixed: 2221785
Add new ini item "enable_ftopen" to enable/disable
FT open feature. There is no ini currently to
disable only FT open.
Add sanity check to send 11r params in case of FT open
to fw only when enable_ftopen is enabled
Change-Id: Ifb27aea8de8c8837f8eda329e1247abfadabb628
CRs-Fixed: 2214772
Add new ini item "ho_delay_for_rx" to set delay Hand-off
period. For LFR 3.0 roaming scenario, once roam candidate
is found, firmware waits for minimum this much duration
to receive pending rx frames from current BSS before
switching to new channel for handoff to new AP.
Pass value of ho_delay_for_rx to fw in case of roam
offload.
Change-Id: I19141928a2885371bc1b9e7b720473d99c4ebb1d
CRs-Fixed: 2221755
qcacld-2.0 to qcacld-3.0 propagation
Discard the original wmi interface:
WMI_PEER_ANTDIV_INFO_REQ_CMDID/PEER_ANTDIV_INFO_EVENTID,
replace with the new one:
WMI_PDEV_DIV_GET_RSSI_ANTID_CMDID/WMI_PDEV_DIV_RSSI_ANTID_EVENTID
to support chain value along with corresponding antenna info.
Change-Id: Ie9ea9d160e1ac1e2e65de422c85989159fb5a556
CRs-Fixed: 2220759
Copy the file name to a QDF local array, rather than using
the pointer to file name, to avoid access to the invalid pointer.
Also, separate out SKB debug from memory debug.
SKB debug will be enabled once the SKB related false positives are fixed.
CRs-Fixed: 2216661
Change-Id: I0ada1acb84c24c961cf614c9c47261f272959874
The following changes are added for Tx capture/Mcopy mode
1. Append ppduid for FW generated mgmt. frames
2. Append ppduid received in mgmt. TX completion for host
generated mgmt. frames
3. Reuse nbuf received in HTT msg to send mgmt. payload to
upper layers
Change-Id: I073cafa6389ed1ed835cc3ba4b9421b7a4b97d7f
CRs-Fixed: 2185543
Fix memory allocation during NDP firmware events by allocating
memory before wmi_extract APIs are called.
Change-Id: I3af2f49895a79a45b3add246eeb9025b1df92faa
CRs-Fixed: 2183493
Add macros to set and get BSS color value and the BSS Color
disable bit values. These macros are used to construct the value
to send to the WMI BSS Color vdev param with BSS color and BSS color
disable status embedded.
Change-Id: Id0721a1a5d66fff5d2c50708aeefb5e0ec03e999
CRs-fixed: 2186897
Deprecate enum wmi_dwelltime_adaptive_mode and use enum
scan_dwelltime_adaptive_mode defined in scan component.
Change-Id: I9c33b852172d9208fb8440c6dc71a12aefd717da
CRs-Fixed: 2213074
WMI_VDEV_PARAM_AUTORATE_MISC_CFG is introduced to set
HE GI LTF combinations in case of autorate adaptation.
Add support for the same in host side wmi files.
Change-Id: Idf567d771539b17e669ddab8b85092e3cbf9d3c8
CRs-fixed: 2204393
There are instances of use of older A_UINT/A_INT.
Replace all such instances with the qdf u_int*_t/int*_t.
Change-Id: I7ce29b03f29a0d1a0cf87cfd3c846f4694da4c2a
CR's-Fixed: 2210869
IPA module has been moved to CLD component under the converged
driver model. Point the wmi API's and structures to the newly
defined files.
Change-Id: I96205f7cc18dbea1c05a5f6314490ea6b3dd75fd
CRs-Fixed: 2180176
Modify arguments of wmi_unified_attach to use struct to
send attach params instead of individual params. Add max
WMI commands as a param. Based on requirement MAX WMI
commands value is different. In case of AP that supports
16 VAPs and more than 512 clients, 1024 commands is not
enough. Use this param to configure this value based on
the requirement.
Change-Id: I4e778475481e509051dfbac70980614b644e1b4a
CRs-fixed: 2034438
The WMI_MAX_CMDS macro was defined in wmi_unified_priv.h, move it
to wmi_unified_param.h so that it can be used to set
wmi_unified_attach_params.
Change-Id: I33aaa3c1fb189c7ef660ccbc5262afd0a1ee258b
Firmware recently exposed two new resource config fields,
num_packet_filters, and num_max_sta_vdevs. Add these fields to the
host-side resource config struct so appropriate values can be populated
and communicated to firmware.
Change-Id: I951ba6ac929c38c2d78af6705f4922b62fc7d3a1
CRs-Fixed: 2201876
In WMI struct target_resource_config is obsolete and outdated.
Correct resource config struct is target_resource_config hence
remove the obsolete and outdated struct target_resource_config.
Change-Id: I23aeb46854008dabad4ece953c6eb2c151bedac0
CRs-Fixed: 2202520
Extend wmi interface command to support other
connectivity check stats(ICMPv4 and tcp).
Change-Id: I881aaeab6e3e1f36b7153630b87a07019660d896
CRs-Fixed: 2168412
Add function for extract_nfcal_power_ev_param and
register wmi_pdev_nfcal_power_all_channels_event_id event
to support noise floor in HK.
Change-Id: I6eef823b507be94c65df026664244eec7fc07e24
CRs-Fixed: 2157972
qcacld-2.0 to qcacmn propagation
Adds qdf time api to get time of the day in millisec
Also send host timestamp to firmware, so that firmware can print the
logs timestamp in sync with host via the wmi interface,with
api wmi_send_time_stamp_sync_cmd_tlv()
Change-Id: Id6acfc5227fdca2fbf8d266998fdfc4046adc5f4
CRs-Fixed: 2193978
Add command support to not send ADDBA REQs.
The corresponding WMI VDEV param ID to set the
VDEV param has been added.
Change-Id: Id53f8101a61ccc0aba2a9a6735d1c6942ba3592d
CRs-fixed: 2188560
Firmware will use this configuration to enable/disable the
CCK transmission. By default, the CCK Tx is enabled.
CRs-Fixed: 2191524
Change-Id: I165c3ea10ea3734fc81e7d25fe8ad676afd1b2c1
Added extender service support for obss and obss color
Collision offload support.
Change-Id: Ifd249b3bbf4510297f15beb33df13d6c4f9d7d0e
CRs-Fixed: 2185238
Current Spectral module uses qdf_print. To improve the control over
logging, use module level logging
CRs-Fixed: 2165341
Change-Id: I205991347453c4dcc424ba1958e309b7c5fb71a0
As part of converged architecture wmi_service_enable is converged
and should be used instead of WMI_IS_SERVICE_AVAILABLE. The events
also need to be defined as part of array for mapping to converged
event id's.
Change-Id: I9ab342a5cf6e665a3eb90eeef6d10bf3c145049d
CRs-Fixed: 2186338
