API for dumping the CE descriptors copies all descriptors for
the given Copy engine id and also copies the SKB packet pointed
by the descriptors till smart_log_skb_sz bytes.
Change-Id: I511bda77319944c1ec2377f716087956ce0637ac
CRs-Fixed: 2008290
Remove NAWDS Rx Drop Count as it is not required,
drop packets in rx where length is not
available.
Change-Id: Ib4b41eefe88410137c3845090783ee43adb9147c
CRs-Fixed: 2191474
There are instances of use of older A_UINT/A_INT.
Replace all such instances with the qdf u_int*_t/int*_t.
Change-Id: I7ce29b03f29a0d1a0cf87cfd3c846f4694da4c2a
CR's-Fixed: 2210869
Donot perform mcast echo check in case of qwrap isolation mode.
In qwrap isolation mode, packets from wired station reaches the wireless
station via the rootap. Thus we need to allow loopback packets in qwrap
isolation mode.
Also add a configuration to set isolation mode.
Change-Id: If4a63abd477596f6b48c6cf9b6e7e5bd84ec95c0
CRs-fixed: 2204033
1) for raw mode, drop frames with invalid size
2) for non-raw mode, fixed issue that
frag list data_len's not properly calculated
The length issues will introduce kernel issues
during skb_linearize() at upper OS network stack layer.
Symptoms:
1)
WARNING: at net/core/skbuff.c:1782
PC is at skb_copy_bits+0x1b8/0x230
2)
kernel BU at net/core/skbuff.c:1615!
PC is at __pskb_pull_tail+0x70/0x2e4
CRs-fixed: 2188754
Change-Id: I848ec976cd922708ffd02d8272ea5a6f3bce2a00
Add htt tx and rx structs from HTT to cdp_pdev_stats.
These Fw tx and rx stats are obtained through HTT events.
athstats application uses cdp_pdev_stats that contains host stats
and fw stats.
Change-Id: Ia063f406bdc6d32a684c4026b8425ecc96faa3db
CRs-Fixed: 2190793
Tx completion success counters are not being updated correctly.
Accumulate successful completions in tx_success variable.
Change-Id: I290e581e93e03ad23e349c9df7834174d6d3a787
CRs-Fixed: 2191599
Firmware will use this configuration to enable/disable the
CCK transmission. By default, the CCK Tx is enabled.
CRs-Fixed: 2191524
Change-Id: I165c3ea10ea3734fc81e7d25fe8ad676afd1b2c1
1. Assert if length received from FW is not equal to
the expected length
2. Count the number of PPDU stats received by host and
print in "iwpriv athX txrx_stats 260"
3. Optimize the PPDU stats tag mask sent to FW for
enhanced stats enabling
Change-Id: I60019de93bb3914955a03546504efc820c960746
CRs-Fixed: 2170704
To expose cdp_pdev_stats to athstats, move cdp_stats from
cdp_txrx_cmn_struct.h to cdp_txrx_stats_struct.h and include
cdp_txrx_stats_struct.h wherever needed
Change-Id: I0e86527d47f5c6056a3bfbf5e8151594879427f3
CRs-Fixed: 2183725
command:-
1. "iwpriv athx s_txpow param1 param2"
2. "iwpriv athx g_txpow param1"
param1 = frame_type<<8+frame_subtype param2 is power_value
if subtype == 0xff means set all subtype of that frame type
Change-Id: I8c68e1ca6a5829a3f0cf01b2c32c3332e1010243
CRs-Fixed: 2175241
Support added for the following:
1. The counters for Rx offer, Tx Offer, MgmtTXFail.
2. Block mgmt frame from a particular mac address.
3. Display NSS for associated clients.
Change-Id: Ic0f6ea8f7b94f998f6a9d2d3e1adc3a71c79056b
Add new pdev param with which firmware can be set to use
a lower number of chains without doing a reset. In response
to this firmware's ratecontrol will select only rates
which can be sent using a lower number of chains, and set
the h/w tx descpriptor's chain select to whatever value
has been configured using this command.
CRs-Fixed: 2123206
Change-Id: Ice713393958c2c2acedba0fe2e9354f3fe3bee75
Private ioctls for external acs operation like
set icm active, get channel load info, clear chan load info,
get nominal noise floor were transported and
handled by spectral module. We seperate this ioctls
from spectral by adding new IWPRIVs(get_icm_active,
set_icm_active, get_nominal_nf, clear_chan_info)and
moving their handlers out of spectral.
CRs-Fixed: 2126313
Change-Id: I8c6b56b85d566f5bc7f6217f6fbc99fa23171cdd
Initialize pdev_id for PDEV stats request and response event.
Add param to set pdev stats request timer.
Change-Id: I11f648070cd39f026129d1cf3aa13bf296d25e6e
Add required WMI commands to communicate support of
EXT NSS Signaling between host and FW. Also, if
EXT NSS Signaling is supported the use new WMI to
communicate the required information between host and FW.
Change-Id: If3e1ef11a55f8fbdffddb3b10963878a6a2ca415
CRs-Fixed: 2089043
Management frames with RX RSSI lower than
user set value will be dropped.
CNSS-CODE-SCAN:: QUICLOST-196308:: Completed
Change-Id: I9af967703182513cb9a51ee96c0954b7d27eaacb
Add counter stats for number of management frames sent via
wmi and number of completions received.
Change-Id: Id5e72858b1e258b089b170a6d15ba395782645cc
CRs-Fixed: 2060117
Host support for Static and Dynamic chain mask selection.
parse new TLVs from ext service ready,copy tables to
wlan_objmgr_soc object.
CRs-Fixed: 2016643.
Change-Id: Ia4735eb4c7774c381df01f56696e8c86fc6c56ab
packets received on a particular radio are queued to
a user configured reo destination ring.
Change-Id: I080090f22b80fd8d8868df4145b82888e1111cea
CRs-Fixed: 2017081
Changed the data type to store stats to 64bit
from 32bit to support larger number for stats
counter
Change-Id: I25eca626623503663b6aa8436217413609e2a807
CRs-Fixed: 2024225
Acked-by: Chaithanya Garrepalli <cgarre@codeaurora.org>
Add per peer stats
Add support to update APSTATS
Change QDF_TRACE to DP_TRACE for improved readablility
Change-Id: I4be2adf2a1d7f978eb2961a544435d525c97923d
CRs-Fixed: 1114641
This patch adds support of new WMI command WMI_COEX_VERSION_CFG_CMID
for 4-wire coex configuration in non_tlv_ops.
Change-Id: I63da2c7ae99c38d297f7f13a8086611263f7fc5b
Acked-by: Daniel Kim <kimdan@codeaurora.org>
CRs-Fixed: 1081065
The term "agile" is used by hardware for swift/fast channel change.
Use precac for the zeroCACDFS instead.
Change-Id: I35f4d61cc93b3542feb8b286cbdf3a4474df5a75
Crs-fixed: 1073945
A new iwpriv command has been added to configure the period
and wlan duration for a btcoex duty cycle.
As a part of this registring the wmi_service_btcoex_duty_cycle
for WMI_SERVICE_BTCOEX_DUTY_CYCLE.
Also send_btcoex_wlan_priority_cmd registrtaion for btcoex
duty cycle command in non_tlv_ops.
Change-Id: I7f3bfdfd9804566d6d0b7cce7025e99db57d0e23
Acked-by: Basamma Yakkanahalli <ybasamma@qti.qualcomm.com>
CRs-Fixed: 1064437
Added a new layer CDP_IF inside dp which is an intermediate
between the data path functions and the upper layers. All function
calls from outside the DP layer to the DP layer goes via the CDP_IF
layer
Change-Id: I76e671c85d2d02aa0a65a90b356840d3aeede52d
CRs-Fixed: 1075597
Add IWPRIV support for preferred uplink. Preferred uplink will
be the interface chosen by the user during creating a fast lane
using two radios.
Change-Id: Id9333f9f083b6a34e7998ca9b02be94c220ed6e8
CRs-fixed: 1069444
