Curr_micbias2 val should be same with mb->micba2_mv.
for some customers, their micbias is not 1800mv,
so we should set the curr_micbias as mb->micb2_mv which
was the actual micbias val the customer use.
remove the dev_up check from micbias, since with this check,
Headset may be detected as a incorrect type.
Change-Id: Ia5a1fd434a09617a57096531c69956479c69f079
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
cls-h port enablement is not required for aux path, So removed
the cls-h route.
Change-Id: If0d498ff042b59df920fe51ca99715da543876b8
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
if there is any tx usecase running, reset tx swr
clk will make all the tx sequencer power off,
so check sys_usage_status first before reset
tx_swr clk
dont need set swr clk for inactive bank.
Change-Id: I21362885c84e6ce4afbbfd18a48191f53f8ccc6b
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
Enable Low Power Mode for the power supplies while
going to suspend mode on wsa883x and wcd9378.
Change-Id: I133c1b791bcd8b53cf79650d7347d5889da29491
Signed-off-by: Sarath Varma Ganapathiraju <quic_ganavarm@quicinc.com>
multiple targets can have same kernel config which can break
existing audio bazel compilation. Added support for multiple
project compilation for audio.
Change-Id: I1f357f6b14cd79acf94dbf9be4103c1f6b1cf108
Signed-off-by: Sarath Varma Ganapathiraju <quic_ganavarm@quicinc.com>
when we enable compander for headphones, the quality
of hph playback is bad, since we have not disconnect
the right port, correct it.
Change-Id: I63ab0734870027109a7f032c47f8865083374a5b
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
when amic4 recording start, sys_usage_bit get failed,
since the mask of read val is incorrect.
Change-Id: I4c6bdaf6cafdd133e272bcacfd2faea5f176f9ab
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
Optimize the init sequence for tambora, enable TXSCBIAS_CLK
and set IBIAS_LDO_DRIVER as 5ua.
Change-Id: I639b7051d03d167972f592b155072260d4e02aec
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
Update the hph/ear/aux playback sequence, disable the reg
which should be disable.
Change-Id: Ib1353e686a49222f5084722cced7687815f76ab2
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
Tear down the correct REQ_PS when widget power down,
that can fix the amic3 mute after ssr issue.
Change-Id: I7b5c958e79eb23184bd11375bae11dbcd51e961a
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
Audiolite doesn't need qcom audio driver so remove it from compilation.
Change-Id: I3bc12b9051fe987fbde087ff6f505029337c5352
Signed-off-by: Kogara Naveen Kumar <quic_nkogara@quicinc.com>
Update the micbias enable logic for tambora,
and add some widgets to switch between amic and
va amic.
Change-Id: I2c9a7658d79a7c9d255884df7b81aa8062185d72
Signed-off-by: Yuhui Zhao <quic_yuhuzhao@quicinc.com>
