The AXI DMA multichannel support is deprecated in the IP and it is no
longer actively supported. For multichannel support, refer to the AXI
multichannel direct memory access IP product guide(PG228) and MCDMA
driver(added in the subsequent commits). Inline with it remove axidma
multichannel optional properties i.e xlnx,mcdma and dma-channels from
the binding description.
Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey@xilinx.com>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/1571763622-29281-2-git-send-email-radhey.shyam.pandey@xilinx.com
Signed-off-by: Vinod Koul <vkoul@kernel.org>
A few more DT patches for 5.5, mostly:
- USB3 support for the H6
- Deinterlacer support for the H3
- eDP Bridge support on the Teres-I
- More DT cleanups thanks to the validation
* tag 'sunxi-dt-for-5.5-2' of https://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux:
arm64: dts: allwinner: h6: Remove useless reset name
ARM: dts: sun6i: Remove useless reset-names
arm64: dts: allwinner: orange-pi-3: Enable USB 3.0 host support
arm64: dts: allwinner: h6: add USB3 device nodes
dt-bindings: Add ANX6345 DP/eDP transmitter binding
arm64: dts: allwinner: a64: enable ANX6345 bridge on Teres-I
dts: arm: sun8i: h3: Enable deinterlace unit
ARM: dts: sunxi: h3/h5: Add MBUS controller node
dt-bindings: bus: sunxi: Add H3 MBUS compatible
Link: https://lore.kernel.org/r/58ad00a8-9579-4811-969a-a74e331ee9a2.lettre@localhost
Signed-off-by: Olof Johansson <olof@lixom.net>
One patch to add back the PMU node that was removed because the
interrupts were improper in a previous fixes PR.
* tag 'sunxi-fixes-for-5.4-3' of https://git.kernel.org/pub/scm/linux/kernel/git/sunxi/linux:
arm64: dts: allwinner: a64: Re-add PMU node
ARM: sunxi: Fix CPU powerdown on A83T
ARM: dts: sun8i-a83t-tbs-a711: Fix WiFi resume from suspend
ARM: dts: sun7i: Drop the module clock from the device tree
dt-bindings: media: sun4i-csi: Drop the module clock
media: dt-bindings: Fix building error for dt_binding_check
arm64: dts: allwinner: a64: sopine-baseboard: Add PHY regulator delay
arm64: dts: allwinner: a64: Drop PMU node
arm64: dts: allwinner: a64: pine64-plus: Add PHY regulator delay
Link: https://lore.kernel.org/r/45023fa6-b2bc-4934-b85c-3e7841dde0b1.lettre@localhost
Signed-off-by: Olof Johansson <olof@lixom.net>
Now that we have the DT validation in place, let's convert the device tree
bindings for the TI SoC Davinci/OMAP/Keystone2 MDIO Controllerr over to a
YAML schemas.
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Reviewed-by: Simon Horman <simon.horman@netronome.com>
Signed-off-by: Rob Herring <robh@kernel.org>
Some binding that were introduced early on got a comment to enable
additionalProperties, but we couldn't due to the generic properties being
reported as errors.
The way we're dealing with this now is to use the draft-08's
unevaluatedProperties (even though the tools doesn't do anything with it
yet).
Let's convert those old bindings to it.
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Signed-off-by: Rob Herring <robh@kernel.org>
Convert the qcom,qcs404 interconnect provider binding to DT schema.
Signed-off-by: Georgi Djakov <georgi.djakov@linaro.org>
Signed-off-by: Rob Herring <robh@kernel.org>
The "syscon" compatible string was introduced mainly to allow sharing
of the CHIPID IO region between multiple drivers. However, such sharing
can be also done without an additional compatible so remove "syscon".
Suggested-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Reviewed-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Rob Herring <robh@kernel.org>
Extend the documenation by events description with new 'event-data-type'
field. Add example how the event might be defined in DT.
Signed-off-by: Lukasz Luba <l.luba@partner.samsung.com>
Acked-by: Chanwoo Choi <cw00.choi@samsung.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
Kalle Valo says:
====================
wireless-drivers-next patches for 5.5
First set of patches for 5.5. The most active driver here clearly is
rtw88, lots of patches for it. More quiet on other drivers, smaller
fixes and cleanups all over.
This pull request also has a trivial conflict, the report and example
resolution here:
https://lkml.kernel.org/r/20191031111242.50ab1eca@canb.auug.org.au
Major changes:
rtw88
* add deep power save support
* add mac80211 software tx queue (wake_tx_queue) support
* enable hardware rate control
* add TX-AMSDU support
* add NL80211_EXT_FEATURE_CAN_REPLACE_PTK0 support
* add power tracking support
* add 802.11ac beamformee support
* add set_bitrate_mask support
* add phy_info debugfs to show Tx/Rx physical status
* add RFE type 3 support for 8822b
ath10k
* add support for hardware rfkill on devices where firmware supports it
rtl8xxxu
* add bluetooth co-existence support for single antenna
iwlwifi
* Revamp the debugging infrastructure
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
The BCM7445/BCM7278 built-in Ethernet switch have an optional reset line
to the SoC's reset controller, describe the 'resets' and 'reset-names'
properties as optional.
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The ADAU7118 has an example where the codec has an i2c address of 14, and
the unit address set to 14 as well.
However, while the address is expressed in decimal, the unit-address is
supposed to be in hexadecimal, which ends up with two different addresses
that trigger a DTC warning. Fix this by setting the address to 0x14.
Cc: Nuno Sá <nuno.sa@analog.com>
Cc: Lars-Peter Clausen <lars@metafoo.de>
Fixes: 969d49b2cd ("dt-bindings: asoc: Add ADAU7118 documentation")
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Acked-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20191105105615.21391-1-maxime@cerno.tech
Signed-off-by: Mark Brown <broonie@kernel.org>
Convert Samsung S3C/S5P/Exynos Serial/UART bindings to DT schema format
using json-schema.
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Rob Herring <robh@kernel.org>
The Allwinner SoCs have an mUSB controller that is supported in Linux, with
a matching Device Tree binding.
Now that we have the DT validation in place, let's convert the device tree
bindings for that controller over to a YAML schemas.
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Signed-off-by: Rob Herring <robh@kernel.org>
These two clocks aren't present in all versions of the MDP5 HW:
where present, they are needed to enable the Translation Buffer
Unit(s).
Signed-off-by: AngeloGioacchino Del Regno <kholk11@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>
Add the compatibles for Kontron i.MX6UL N6311 SoM and boards and
the compatibles for Kontron i.MX6ULL N6411 SoM and boards.
Signed-off-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Reviewed-by: Krzysztof Kozlowski <krzk@kernel.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
mvebu dt64 for 5.5 (part 1)
- Add new Marvell CN9130 SoC support (CN9130 is made of one AP807 and
one internal CP115, similar to the Armada 7K/8K using AP806 and
CP110).
- Reorganize EspressoBin device tree to add new variant of the boards
(Armada 3270 based)
- Add firmware node for turris Mox (Armada 3720 based)
* tag 'mvebu-dt64-5.5-1' of git://git.infradead.org/linux-mvebu: (23 commits)
arm64: dts: armada-3720-turris-mox: add firmware node
arm64: dts: marvell: add ESPRESSObin variants
arm64: dts: marvell: Add support for Marvell CN9132-DB
arm64: dts: marvell: Add support for Marvell CN9131-DB
arm64: dts: marvell: Add support for Marvell CN9130-DB
arm64: dts: marvell: Add support for Marvell CN9130 SoC support
arm64: dts: marvell: Add support for CP115
arm64: dts: marvell: Externalize PCIe macros from CP11x file
arm64: dts: marvell: Drop PCIe I/O ranges from CP11x file
arm64: dts: marvell: Prepare the introduction of CP115
arm64: dts: marvell: Fix CP110 NAND controller node multi-line comment alignment
arm64: dts: marvell: Add AP807-quad cache description
arm64: dts: marvell: Add AP806-quad cache description
arm64: dts: marvell: Add AP806-dual cache description
arm64: dts: marvell: Add support for AP807/AP807-quad
dt-bindings: marvell: Declare the CN913x SoC compatibles
dt-bindings: marvell: Convert the SoC compatibles description to YAML
arm64: dts: marvell: Move clocks to AP806 specific file
arm64: dts: marvell: Prepare the introduction of AP807 based SoCs
MAINTAINERS: Add new Marvell CN9130-based files to track
...
Link: https://lore.kernel.org/r/87zhhc3bo6.fsf@FE-laptop
Signed-off-by: Olof Johansson <olof@lixom.net>
