Narendra Muppalla daa511cb90 Merge remote-tracking branch 'quic/display-kernel.lnx.5.10' into display-kernel.lnx.5.15 ...

* quic/display-kernel.lnx.5.10:
  disp: msm: sde: avoid error during fal10_veto override enablement
  disp: msm: update copyright description
  disp: msm: sde: configure dest_scaler op_mode for two independent displays
  disp: msm: dp: updated copyright set for 4nm target
  Revert "disp: msm: sde: consider max of actual and default prefill lines"
  disp: msm: sde: Reset backlight scale when HWC is stopped
  disp: msm: dp: avoid duplicate read of link status
  disp: msm: dsi: update vreg_ctrl settings for cape
  disp: msm: fail commit if drm_gem_obj was found attached to a sec CB
  disp: msm: dp: updated register values for 4nm target
  disp: msm: sde: update framedata event handling
  disp: msm: dsi: Add new phy comaptible string for cape
  disp: msm: sde: software override for fal10 in cwb enable
  disp: msm: update cleanup during bind failure in msm_drm_component_init
  disp: msm: sde: dump user input_fence info on spec fence timeout
  disp: msm: sde: add null pointer check for encoder current master
  disp: msm: dsi: enable DMA start window scheduling for broadcast commands
  disp: msm: sde: avoid alignment checks for linear formats
  disp: msm: reset thread priority work on every new run
  disp: msm: sde: send power on event for cont. splash
  disp: msm: sde: always set CTL_x_UIDLE_ACTIVE register to "1"
  disp: msm: use vzalloc for large allocations
  disp: msm: sde: Add support to limit DSC size to 10k
  disp: msm: sde: add tx wait during DMS for sim panel
  disp: msm: dsi: add check for any queued DSI CMDs before clock force update
  disp: msm: sde: correct pp block allocation during dcwb dither programming
  disp: msm: sde: avoid setting of max vblank count
  disp: msm: sde: add cached lut flag in sde plane
  disp: msm: sde: avoid use after free in msm_lastclose
  disp: msm: sde: update TEAR_SYNC_WRCOUNT register before vsync counter
  disp: msm: dsi: Support uncompressed rgb101010 format
  disp: msm: sde: update idle_pc_enabled flag for all encoders
  disp: msm: sde: flush esd work before disabling the encoder
  disp: msm: sde: allow qsync update along with modeset
  disp: msm: dp: avoid dp sw reset on disconnect path
  disp: msm: sde: consider max of actual and default prefill lines
  disp: msm: ensure vbif debugbus not in use is disabled
  disp: msm: sde: update cached encoder mask if required
  disp: msm: sde: while timing engine enabling poll for active region
  disp: msm: enable cache flag for dumb buffer
  disp: msm: sde: disable ot limit for cwb
  disp: msm: sde: avoid race condition at vm release
  disp: msm: dsi: set qsync min fps list length to zero
  disp: msm: sde: reset mixers in crtc when ctl datapath switches
  disp: msm: sde: update vm state atomic check for non-primary usecases
  disp: msm: sde: reset CTL_UIDLE_ACTIVE register only if uidle is disabled

Change-Id: If480e7f33743eb4788549f853ba05e744ecb38d3
Signed-off-by: Narendra Muppalla <quic_nmuppall@quicinc.com>

2022-02-08 16:38:13 -08:00

56 KiB

原始文件 Blame 文件历史

查看原始文件