Update regmap table with proper read write registers to
enable tx paths in a three mic usecase.
Change-Id: Iab53e3a92f02ddc282e621b8063f3c051fe658f6
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Adding changes for Bolero codec snd controls structure
to support TX HPF cut off frequency setting
Change-Id: Ia601d7b4bc6d80ff584b5bf6df47663080b2aa6f
Signed-off-by: Shalini Manjunatha <shalma@codeaurora.org>
Update boost level setting of value 5.5v and 6v
for 8815 and 8810 variants.
Change-Id: I6e71c58bddb4958f1eda4ab4d4630bcb6073dcdb
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
Update audio capture sequence to avoid multiple bank switches
during multi mic usecase that helps in reducing the latency
for path setup.
Change-Id: Idac8bca97b3503cdbf82bb482e8a297a1fd20893
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
After playback on speaker, remove from soundwire group to
properly close the soundwire port configuration.
Change-Id: I278e7510869200bc1236eb45968bc8d986a93a96
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
From kernel 5.4, device node properties with
-gpio/-gpios suffix in the name is expected to define
gpio node properities like "#gpio-cells".
Update non-gpio property names to not have -gpio/-gpios
suffix.
Change-Id: I63fc81ce16c4e9705a08a3762aa91c7cacd174b5
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Compile hdmi_dlkm kernel module only when both
CONFIG_SND_SOC_MSM_HDMI_CODEC_RX and CONFIG_AUDIO_QGKI configs
are enabled.
Change-Id: I31864e8b764dbcb40e0b96ac3a98f626dab315d2
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Update speaker playback sequence on wsa883x codec to
avoid click and pop and loss of VI sense data on speaker.
Change-Id: I8ec7072b63bef6c2e7bd64c96df4d98852c4f40d
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Since clock stop mode is supported, disable mic bias supply
after a successful dmic probe.
Change-Id: I1a545969601367cc22844d1ab8467fb3722d882f
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Update sequence to enable temperature sensor in wsa883x to
read proper temperature measurement.
Change-Id: I7db16344a92b82539929511bd0de322ed086beb7
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Because of a HW limitation in DSP, while switching
RCG from TX MCLK to VA MCLK for SVA use cases
a glitch is seen on AHB bus leading to data
corruption in registers.
So, while doing a mux switch for VA RCG clock selection,
do not configure the muxsel register in HLOS as it is
taken care in DSP itself as a workaround for HW limitation.
Change-Id: Iccbe714397796259fa55f9852ece387e949b12e8
Signed-off-by: Aditya Bavanari <abavanar@codeaurora.org>
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Remove sound wire dmic device from master device list only during
critical error and not for probe defer.
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Soundwire DMICs provide the same quality as regular DMICs but
the interface is soundwire. This reduces the number of pins
on the MSM. Enable soundwire DMICs on lahaina.
Change-Id: I4245369fdcb29cf96f315ebc1d2e9a83a0fbc14b
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Add micbias control API to enable SWR DMICs on lahaina target.
Change-Id: I48152971e1af8dedc98ada20e4e808cf18720869
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
POWER_SUPPLY_TYPEC_SINK_AUDIO_ADAPTER is not supported on new
kernel-5.4. Update mode to TYPEC_ACCESSORY_AUDIO for analog
type-c headset.
Change-Id: Id46ea2eebea8257a48134431f07a81b6ed7e6c7d
Signed-off-by: Meng Wang <mengw@codeaurora.org>
While enabling headphone PA, bypass preref filter
to resolve clipping issue in the first second.
Change-Id: I7524fe3215bac267c5e199c715931712e16adf88
Signed-off-by: Karthikeyan Mani <kmani@codeaurora.org>
Disable interrupts while bringing codec out of reset to avoid fake
interrupts.
Change-Id: Iec1e6c67429b7424693c2628e6f6d121a4c9ce71
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Add dynamic port enablement for wcd938x and
wcd937x targets to support unified swr tx port
mapping added as part of SWR 1.6 updates.
Change-Id: If0cf823dc51028fd5bd95f5a49ffe05998526be6
Signed-off-by: Ramlal Karra <rkarra@codeaurora.org>
Update TX HPF sequence for AMIC to avoid pop during
audio capture.
Change-Id: Ib70fc5cd05f67c97977db96487294bfe14f554ad
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
When enabling SVA, tx_mclk_users is not increased. If starting
and stopping recording after enabling SVA, tx_mclk will be closed
when powering down tx mclk widget. Increase tx_mclk_users when
enabling VA_MCLK to avoid mismatch.
Change-Id: I02d9400cf7309464bbba1e6749cfcfcf99f5876a
Signed-off-by: Meng Wang <mengw@codeaurora.org>
Supply for swr dmic is from wcd mic bias.
Enable the power supply by calling corresponding
interfaces from cdc supply driver.
Change-Id: I9db6a4799ebfdd974d9e12c47053d8d73da2b883
Signed-off-by: Karthikeyan Mani <kmani@codeaurora.org>
Add widgets to enable mic bias standlaone without
dependency on any use case.
Change-Id: I1f61cd9403d3f83baa199f9c669680d9c7b5c371
Signed-off-by: Karthikeyan Mani <kmani@codeaurora.org>
Add CONFIG_AUDIO_QGKI check for variables and functions
in audio drivers, so they are used only during a QGKI build.
Change-Id: Ia04232566367f196f298a49cf3962bb7927bec6a
Signed-off-by: Vignesh Kulothungan <vigneshk@codeaurora.org>
Add initial changes for supporting swr dmic
where each codec can support single mic recording
over soundwire port.
Change-Id: I0319bfb5c850d48b563f46d5dd77f21d4a83f029
Signed-off-by: Karthikeyan Mani <kmani@codeaurora.org>
