* quic/display-kernel.lnx.5.10:
disp: msm: sde: avoid error during fal10_veto override enablement
disp: msm: update copyright description
disp: msm: sde: configure dest_scaler op_mode for two independent displays
disp: msm: dp: updated copyright set for 4nm target
Revert "disp: msm: sde: consider max of actual and default prefill lines"
disp: msm: sde: Reset backlight scale when HWC is stopped
disp: msm: dp: avoid duplicate read of link status
disp: msm: dsi: update vreg_ctrl settings for cape
disp: msm: fail commit if drm_gem_obj was found attached to a sec CB
disp: msm: dp: updated register values for 4nm target
disp: msm: sde: update framedata event handling
disp: msm: dsi: Add new phy comaptible string for cape
disp: msm: sde: software override for fal10 in cwb enable
disp: msm: update cleanup during bind failure in msm_drm_component_init
disp: msm: sde: dump user input_fence info on spec fence timeout
disp: msm: sde: add null pointer check for encoder current master
disp: msm: dsi: enable DMA start window scheduling for broadcast commands
disp: msm: sde: avoid alignment checks for linear formats
disp: msm: reset thread priority work on every new run
disp: msm: sde: send power on event for cont. splash
disp: msm: sde: always set CTL_x_UIDLE_ACTIVE register to "1"
disp: msm: use vzalloc for large allocations
disp: msm: sde: Add support to limit DSC size to 10k
disp: msm: sde: add tx wait during DMS for sim panel
disp: msm: dsi: add check for any queued DSI CMDs before clock force update
disp: msm: sde: correct pp block allocation during dcwb dither programming
disp: msm: sde: avoid setting of max vblank count
disp: msm: sde: add cached lut flag in sde plane
disp: msm: sde: avoid use after free in msm_lastclose
disp: msm: sde: update TEAR_SYNC_WRCOUNT register before vsync counter
disp: msm: dsi: Support uncompressed rgb101010 format
disp: msm: sde: update idle_pc_enabled flag for all encoders
disp: msm: sde: flush esd work before disabling the encoder
disp: msm: sde: allow qsync update along with modeset
disp: msm: dp: avoid dp sw reset on disconnect path
disp: msm: sde: consider max of actual and default prefill lines
disp: msm: ensure vbif debugbus not in use is disabled
disp: msm: sde: update cached encoder mask if required
disp: msm: sde: while timing engine enabling poll for active region
disp: msm: enable cache flag for dumb buffer
disp: msm: sde: disable ot limit for cwb
disp: msm: sde: avoid race condition at vm release
disp: msm: dsi: set qsync min fps list length to zero
disp: msm: sde: reset mixers in crtc when ctl datapath switches
disp: msm: sde: update vm state atomic check for non-primary usecases
disp: msm: sde: reset CTL_UIDLE_ACTIVE register only if uidle is disabled
Change-Id: If480e7f33743eb4788549f853ba05e744ecb38d3
Signed-off-by: Narendra Muppalla <quic_nmuppall@quicinc.com>
Add devcoredump support for sde_dbg. Devcoredump is a mechanism
providing generalized way to get data from kernel modules. This change
integrates devcoredump into sde_dbg to get evtlog, register dump and
dbg_bus when display failure happens.
Change-Id: I4daf25443ccd2646de580314a0bfe08b84dbc282
Signed-off-by: Bruce Hoo <quic_bingchua@quicinc.com>
Large allocations using kzalloc can lead to timeouts. This updates
the allocation calls accordingly to use vzalloc to remove
requirements on contiguous memory.
Change-Id: I86fa0ae13277d97477210a082703514df792d8a9
Signed-off-by: Nilaan Gunabalachandran <quic_ngunabal@quicinc.com>
Event logs are restricted to be logged only with IN_LOG option during
a SDE_DBG_DUMP() call. Extend the logging support to IN_LOG_LIMITED
option. The option is set to IN_MEM by default and can be changed
through debugfs.
Change-Id: I8245cebe3ad71c026fbc51b39edf39ec06b7d0e6
Signed-off-by: Veera Sundaram Sankaran <veeras@codeaurora.org>
Add support to use atomic variable instead of spinlog
for event log while adding enries. This change will
help optimize event log writing time.
Change-Id: I83661b85cd76ca738729ac51aa5afd97d162508d
Signed-off-by: Samantha Tran <samtran@codeaurora.org>
Add support to use atomic variable instead of spinlock
for register logs during register write. This change
helps in reducing the run-time and is safe to use as
most of the register writes happen in commit context.
Change-Id: Ib7e377f80cbf437e391792b0b424cbd1eefdf497
Signed-off-by: Yashwanth <yvulapu@codeaurora.org>
Signed-off-by: Samantha Tran <samtran@codeaurora.org>
This change uses kvzalloc to allocate memory for eventlog and register
dumps. This is needed since kernel cannot guarantee that physically
contiguous allocations greater than 32 KB will succeed.
Additionally it reduces the number of entries for evt logs and
register dumps for trusted vm.
Change-Id: I8b76e79d62850904f6445d8b66c882529ba6e9ba
Signed-off-by: Abhijit Kulkarni <kabhijit@codeaurora.org>
Avoid printing the eventlogs in kernel logs during display debug
logging through sde_dbg_dump to avoid excessive logging. Add a
debugfs node to control in-mem/in-log mode of eventlogs to help
in debugging.
Change-Id: If98b129cafa9d29eccd0c44285f1058876f3e1ea
Signed-off-by: Veera Sundaram Sankaran <veeras@codeaurora.org>
Changes are made to add register write logs to memory dump.
This can be extracted from crash dumps and used for analysis.
Change-Id: If46aaa4ae68f83c79d4b51cbe5dfd22340aa991d
Signed-off-by: Yashwanth <yvulapu@codeaurora.org>
Use platform independent API for cpu number which
compiles on both 32 and 64 bit machine.
Change-Id: I539de278776623a84067460569a2b99676a2ba4e
Signed-off-by: Ravikanth Tuniki <rtunik@codeaurora.org>
Change adds cpu number on which the event log is
getting executed.
Change-Id: If5795352d65632c2f0cb17e0d36a29b56bb556ce
Signed-off-by: Vara Reddy <varar@codeaurora.org>
The display driver uses ktime_to_us to timestamp the messages
in the sde event log. But the kernel logs use local_clock to
timestamp the messages. Using same timestamp routine in sde event
log helps to correlate the messages from both the logs
for debug purpose.
Change-Id: Id94e03ba21f82e2162e4ef4290c10d2d09110d4c
Signed-off-by: Lakshmi Narayana Kalavala <lkalaval@codeaurora.org>
This change brings msm display driver including sde,
dp, dsi, rotator, dsi pll and dp pll from base 4.19 kernel
project. It is first source code snapshot from base kernel project.
Change-Id: Iec864c064ce5ea04e170f24414c728684002f284
Signed-off-by: Narendra Muppalla <NarendraM@codeaurora.org>
