hayeswang 1a9646497b r8169: adjust the flow of hw_start ...

The suggestion as following:
- initial settings or default settings
- rtl_hw_start_xxx. rtl_hw_start_xxx may change some default settings.
- enable tx/rx. This has to be after the above two steps.
- rtl_set_rx_mode. AcceptXXXs have to be enabled after enabling tx/rx.

Signed-off-by: Hayes Wang <hayeswang@realtek.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

2013-04-07 16:44:13 -04:00

..

8139cp.c

remove init of dev->perm_addr in drivers

2013-01-08 18:00:48 -08:00

8139too.c

drivers:net: Remove unnecessary OOM messages after netdev_alloc_skb

2013-03-09 16:09:19 -05:00

atp.c

drivers:net: Remove unnecessary OOM messages after netdev_alloc_skb

2013-03-09 16:09:19 -05:00

atp.h

atp: remove set_rx_mode_8012()

2012-11-03 15:43:04 -04:00

Kconfig

drivers/net/ethernet/realtek: remove depends on CONFIG_EXPERIMENTAL

2013-01-11 11:38:40 -08:00

Makefile

net/ethernet: sc92031 is not Realtek

2011-11-01 19:30:38 -04:00

r8169.c

r8169: adjust the flow of hw_start

2013-04-07 16:44:13 -04:00