When I play with terminus fonts I noticed the efi early printk does
not work because the earlycon code assumes font width is 8.
Here add the code to adapt with larger fonts. Tested with all kinds
of kernel built-in fonts on my laptop. Also tested with a local draft
patch for 14x28 !bold terminus font.
Signed-off-by: Dave Young <dyoung@redhat.com>
Link: https://lore.kernel.org/r/20200412024927.GA6884@dhcp-128-65.nay.redhat.com
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
It seems that for whatever reason, gcc-10 ends up not inlining a couple
of functions that used to be inlined before. Even if they only have one
single callsite - it looks like gcc may have decided that the code was
unlikely, and not worth inlining.
The code generation difference is harmless, but caused a few new section
mismatch errors, since the (now no longer inlined) function wasn't in
the __init section, but called other init functions:
Section mismatch in reference from the function kexec_free_initrd() to the function .init.text:free_initrd_mem()
Section mismatch in reference from the function tpm2_calc_event_log_size() to the function .init.text:early_memremap()
Section mismatch in reference from the function tpm2_calc_event_log_size() to the function .init.text:early_memunmap()
So add the appropriate __init annotation to make modpost not complain.
In both cases there were trivially just a single callsite from another
__init function.
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
When CONFIG_ARM_PSCI_FW is disabled but CONFIG_HAVE_ARM_SMCCC is enabled,
arm-scmi runs into a link failure:
arm-linux-gnueabi-ld: drivers/firmware/arm_scmi/smc.o: in function `smc_send_message':
smc.c:(.text+0x200): undefined reference to `arm_smccc_1_1_get_conduit'
Change from HAVE_ARM_SMCCC to ARM_PSCI_FW config dependency for now.
We rely on PSCI bindings anyways for the conduit and this should be
fine.
Link: https://lore.kernel.org/r/20200507144905.11397-1-sudeep.holla@arm.com
Fixes: 1dc6558062 ("firmware: arm_scmi: Add smc/hvc transport")
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
ASUS TF300T device may not work properly if firmware is asked to fully
re-initialize L2 cache after resume from LP2 suspend. The downstream
kernel of TF300T uses different opcode to enable cache after resuming
from LP2, this opcode also works fine on Nexus 7 and Ouya devices.
Supposedly, this may be needed by an older firmware versions.
Reported-by: Michał Mirosław <mirq-linux@rere.qmqm.pl>
Tested-by: Michał Mirosław <mirq-linux@rere.qmqm.pl>
Tested-by: Jasper Korten <jja2000@gmail.com>
Tested-by: David Heidelberg <david@ixit.cz>
Tested-by: Peter Geis <pgwipeout@gmail.com>
Signed-off-by: Dmitry Osipenko <digetx@gmail.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
To help the compiler figure out that efi_printk() will not modify
the string it is given, make the input argument type const char*.
While at it, simplify the implementation as well.
Suggested-by: Joe Perches <joe@perches.com>
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
When building the x86 EFI stub with Clang, the libstub Makefile rules
that manipulate the ELF object files may throw an error like:
STUBCPY drivers/firmware/efi/libstub/efi-stub-helper.stub.o
strip: drivers/firmware/efi/libstub/efi-stub-helper.stub.o: Failed to find link section for section 10
objcopy: drivers/firmware/efi/libstub/efi-stub-helper.stub.o: Failed to find link section for section 10
This is the result of a LLVM feature [0] where symbol references are
stored in a LLVM specific .llvm_addrsig section in a non-transparent way,
causing generic ELF tools such as strip or objcopy to choke on them.
So force the compiler not to emit these sections, by passing the
appropriate command line option.
[0] https://sourceware.org/bugzilla/show_bug.cgi?id=23817
Cc: Nick Desaulniers <ndesaulniers@google.com>
Cc: Peter Collingbourne <pcc@google.com>
Cc: Sami Tolvanen <samitolvanen@google.com>
Reported-by: Arnd Bergmann <arnd@arndb.de>
Suggested-by: Fangrui Song <maskray@google.com>
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
Commit
22090f84bc ("efi/libstub: unify EFI call wrappers for non-x86")
refactored the macros that are used to provide wrappers for mixed-mode
calls on x86, allowing us to boot a 64-bit kernel on 32-bit firmware.
Unfortunately, this broke mixed mode boot due to the fact that
efi_is_native() is not a macro on x86.
All of these macros should go together, so rather than testing each one
to see if it is defined, condition the generic macro definitions on a
new ARCH_HAS_EFISTUB_WRAPPERS, and remove the wrapper definitions on x86
as well if CONFIG_EFI_MIXED is not enabled.
Fixes: 22090f84bc ("efi/libstub: unify EFI call wrappers for non-x86")
Reported-by: Guenter Roeck <linux@roeck-us.net>
Signed-off-by: Arvind Sankar <nivedita@alum.mit.edu>
Link: https://lore.kernel.org/r/20200504150248.62482-1-nivedita@alum.mit.edu
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
As with most of the drivers, let us register this driver unconditionally
by dropping the checks for presence of firmware nodes(DT) or entries(ACPI).
Further, as mentioned in the commit acafce48b0 ("firmware: arm_sdei:
Fix DT platform device creation"), the core takes care of creation of
platform device when the appropriate device node is found and probe
is called accordingly.
Let us check only for the presence of ACPI firmware entry before creating
the platform device and flag warning if we fail.
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Reviewed-by: James Morse <james.morse@arm.com>
Cc: James Morse <james.morse@arm.com>
Link: https://lore.kernel.org/r/20200422122823.1390-1-sudeep.holla@arm.com
Signed-off-by: Will Deacon <will@kernel.org>
When building arm64 allmodconfig:
ERROR: modpost: "zynqmp_pm_fpga_load" [drivers/fpga/zynqmp-fpga.ko] undefined!
ERROR: modpost: "zynqmp_pm_fpga_get_status" [drivers/fpga/zynqmp-fpga.ko] undefined!
These functions were added to drivers/fpga/zynqmp-fpga.c but not
exported so the module build breaks. Export them so that they can be
used in modules properly.
Fixes: 4db8180ffe ("firmware: xilinx: Remove eemi ops for fpga related APIs")
Signed-off-by: Nathan Chancellor <natechancellor@gmail.com>
Reported-by: "kernelci.org bot" <bot@kernelci.org>
Reported-by: Stephen Rothwell <sfr@canb.auug.org.au>
Link: https://lore.kernel.org/r/20200502025958.2714249-1-natechancellor@gmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Currently, setup_graphics() ignores the return value of efi_setup_gop(). As
AllocatePool() does not zero out memory, the screen information table will
contain uninitialized data in this case.
We should free the screen information table if efi_setup_gop() returns an
error code.
Signed-off-by: Heinrich Schuchardt <xypron.glpk@gmx.de>
Link: https://lore.kernel.org/r/20200426194946.112768-1-xypron.glpk@gmx.de
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
The Intel service layer driver has defined error codes for the
specific services, which started from FPGA configuration then RSU
(Remote Status Update).
Intel service layer driver should define the standard error codes
rather than keep adding more error codes for the new services.
The standard error codes will be used by all the clients of Intel service
layer driver.
Replace FPGA and RSU specific error codes with Intel service layer’s
Common error codes.
Signed-off-by: Richard Gong <richard.gong@intel.com>
Link: https://lore.kernel.org/r/1586897274-307-2-git-send-email-richard.gong@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Pull driver core fixes from Greg KH:
"Here are some small firmware/driver core/debugfs fixes for 5.7-rc3.
The debugfs change is now possible as now the last users of
debugfs_create_u32() have been fixed up in the different trees that
got merged into 5.7-rc1, and I don't want it creeping back in.
The firmware changes did cause a regression in linux-next, so the
final patch here reverts part of that, re-exporting the symbol to
resolve that issue. All of these patches, with the exception of the
final one, have been in linux-next with only that one reported issue"
* tag 'driver-core-5.7-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/driver-core:
firmware_loader: revert removal of the fw_fallback_config export
debugfs: remove return value of debugfs_create_u32()
firmware_loader: remove unused exports
firmware: imx: fix compile-testing
