Pull ARM SoC driver updates from Arnd Bergmann:
"These are changes for drivers that are intimately tied to some SoC and
for some reason could not get merged through the respective subsystem
maintainer tree.
Most of the new code is for the Keystone Navigator driver, which is
new base support that is going to be needed for their hardware
accelerated network driver and other units.
Most of the commits are for moving old code around from at91 and omap
for things that are done in device drivers nowadays.
- at91: move reset, poweroff, memory and clocksource code into
drivers directories
- socfpga: add edac driver (through arm-soc, as requested by Boris)
- omap: move omap-intc code to drivers/irqchip
- sunxi: added an RTC driver for sun6i
- omap: mailbox driver related changes
- keystone: support for the "Navigator" component
- versatile: new reboot, led and soc drivers"
* tag 'drivers-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (92 commits)
bus: arm-ccn: Fix spurious warning message
leds: add device tree bindings for register bit LEDs
soc: add driver for the ARM RealView
power: reset: driver for the Versatile syscon reboot
leds: add a driver for syscon-based LEDs
drivers/soc: ti: fix build break with modules
MAINTAINERS: Add Keystone Multicore Navigator drivers entry
soc: ti: add Keystone Navigator DMA support
Documentation: dt: soc: add Keystone Navigator DMA bindings
soc: ti: add Keystone Navigator QMSS driver
Documentation: dt: soc: add Keystone Navigator QMSS bindings
rtc: sunxi: Depend on platforms sun4i/sun7i that actually have the rtc
rtc: sun6i: Add sun6i RTC driver
irqchip: omap-intc: remove unnecessary comments
irqchip: omap-intc: correct maximum number or MIR registers
irqchip: omap-intc: enable TURBO idle mode
irqchip: omap-intc: enable IP protection
irqchip: omap-intc: remove unnecesary of_address_to_resource() call
irqchip: omap-intc: comment style cleanup
irqchip: omap-intc: minor improvement to omap_irq_pending()
...
The raw_cpu_read() conversion dropped the fetch of the offset
from base->percpu_base in gic_get_percpu_base.
Signed-off-by: Christoph Lameter <cl@linux.com>
Reported-and-tested-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
Acked-by: Nicolas Pitre <nico@linaro.org>
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Tejun Heo <tj@kernel.org>
maximum number of MIR register is 4, rather than 3.
Fix that.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
When TURBO bit is set in the INTC_IDLE register,
the input synchronizer clock will be autogated
based on activity on the INTC.
Because this idle mode increases the interrupt
latency by 2 clock cycles, we're only enabling
it during suspend.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
When PROTECTION bit in enabled in PROTECTION
register, INTC's registers are only accessible
from privileged mode.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
of_iomap(), which is called from omap_init_irq_of(),
already takes care of making sure we have a valid
resource to deal with. Because of that, we can
safely remove our explicit call to of_address_to_resource().
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
no functional changes, just making sure comment
follows Coding Style.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
We already hold the number of Pending registers
in omap_nr_pending. Let's use that instead.
Acked-by: Jason Cooper <jason@lakedaemon.net>
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
Just move the code over as it has no dependencies
on arch/arm/ anymore.
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
When a CPU enters a low power state, the contents of the GICv3/4 system
registers are lost. They need to be saved and restored if required.
For now, since most of the GICv3 register are set some initial values and
not modified at runtime, it is better to re-initialise rather than saving
and restoring them. It may need to be saved and restored in future if
required.
This patch adds a notifier to disable the redistributor(if allowed) and
Group1 interrupts when powering down the processor and to re-initialise
the system registers on wakeup.
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Acked-by: Marc Zyngier <marc.zyngier@arm.com>
Link: https://lkml.kernel.org/r/1409065415-20176-3-git-send-email-sudeep.holla@arm.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
Currently gic_enable_redist configures the redistributors to never
assert WakeRequest signal. However when powering down the processors
with wake-up enabled(i.e suspend), we need to configure it to assert
that signal.
This patch extends gic_enable_redist so that the redistributor can be
configure to assert WakeRequest and hold interrupts as pending. This is
useful in suspending the processors.
This patch also adds check to make sure GICR_WAKER is accessible when
configuring it.
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
[maz: removed reference to GICD_CTLR.DS and added read-back of
GICR_WAKER to check that it is not RAZ/WI]
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Acked-by: Marc Zyngier <marc.zyngier@arm.com>
Link: https://lkml.kernel.org/r/1409065415-20176-2-git-send-email-sudeep.holla@arm.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
This is just enough to let pm_clk_*() enable the functional clock, and
manage it for suspend/resume, if present.
Before, it was assumed enabled by the bootloader or reset state.
To prevent the clock from being disabled while the module is needed for
wake-up, implement irq_chip.irq_set_wake(), which increments/decrements
the clock's enable_count when needed.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Link: https://lkml.kernel.org/r/1410527720-18061-3-git-send-email-geert+renesas@glider.be
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
This patch adds support for the Level-2 interrupt controller
hardware found in Broadcom Set Top Box System-on-a-Chip devices. This
interrupt controller is implemented using a single enable register.
This interrupt controller is always present on the platforms supported
by the irq-brcmstb-l2 driver, hence the reason why both are compiled
using the same Kconfig symbol.
[jac] removed the following warning:
drivers/irqchip/irq-bcm7120-l2.c: In function 'bcm7120_l2_intc_irq_handle':
drivers/irqchip/irq-bcm7120-l2.c:49:27: warning: unused variable 'gc' [-Wunused-variable]
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Link: https://lkml.kernel.org/r/1410309862-27784-2-git-send-email-f.fainelli@gmail.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
The following compilation error occurs on 64-bit Exynos7 SoC:
drivers/irqchip/exynos-combiner.c: In function ‘combiner_irq_domain_map’:
drivers/irqchip/exynos-combiner.c:162:2: error: implicit declaration of function ‘set_irq_flags’ [-Werror=implicit-function-declaration]
set_irq_flags(irq, IRQF_VALID | IRQF_PROBE);
^
drivers/irqchip/exynos-combiner.c:162:21: error: ‘IRQF_VALID’ undeclared (first use in this function)
set_irq_flags(irq, IRQF_VALID | IRQF_PROBE);
^
drivers/irqchip/exynos-combiner.c:162:21: note: each undeclared identifier is reported only once for each function it appears in
drivers/irqchip/exynos-combiner.c:162:34: error: ‘IRQF_PROBE’ undeclared (first use in this function)
set_irq_flags(irq, IRQF_VALID | IRQF_PROBE);
Fix the build error by including linux/interrupt.h.
Signed-off-by: Naveen Krishna Chatradhi <ch.naveen@samsung.com>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Jason Cooper <jason@lakedaemon.net>
Cc: Sudeep Holla <sudeep.holla@arm.com>
Link: https://lkml.kernel.org/r/1409722329-18309-1-git-send-email-ch.naveen@samsung.com
Signed-off-by: Jason Cooper <jason@lakedaemon.net>
[ARM specific]
These are generally replaced with raw_cpu_ptr. However, in
gic_get_percpu_base() we immediately dereference the pointer. This is
equivalent to a raw_cpu_read. So use that operation there.
Cc: nicolas.pitre@linaro.org
Cc: Russell King <rmk+kernel@arm.linux.org.uk>
Signed-off-by: Christoph Lameter <cl@linux.com>
Signed-off-by: Tejun Heo <tj@kernel.org>
