Due to the HW programming sequence requirement that the host
and link DMA channels need to be coupled/decoupled during pcm
hw_params, the host DMA channel corresponding to the link
DMA channel in use for hostless streams needs to be reserved.
This is achieved by adding a host_reserved flag in the
sof_intel_hda_stream structure which is checked when assigning
a host DMA channel.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The recommended HDA HW programming sequence for setting
the DMA format requires that the link DMA and host DMA
channels be coupled before setting the format. This
change means that host DMA or link DMA channels be
reserved even if only one is used.
Statically assigned link DMA channels would mean that
all the corresponding host DMA channels will need to be
reserved, leaving only a few channels available at run-time.
So, the suggestion here is to switch to dynamically assigning
both host DMA channels and link DMA channels are run-time.
The host DMA channel is assigned when the pcm
is opened as before. While choosing the link DMA channel,
if the host DMA channel corresponding to the link DMA channel
is already taken, the proposed method checks to make
sure that the BE is connected to the FE that has been assigned
this host DMA channel. Once the link DMA channel is assigned,
an IPC is sent to the DSP to set the link DMA channel.
The link DMA channel is freed during hw_free() and also in the
SUSPEND trigger callback. It will be re-assigned when hw_params
are set upon resume.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The prepare() ioctl for BE dai link gets called both
when the stream is started and when it is resumed from
suspend. SOF uses this ioctl to set the hw params
again only if the stream has been suspended.
When the stream is started, the hw_params ioctl gets called
before prepare() and hw_params is set for the BE dai link.
So the prepare call does not need to do anything further.
When the stream resumes after system suspend, SOF requires
that the hw_params be set again for the BE dai. In order
to determine which streams should set the hw params
during prepare(), an internal flag called "hw_params_upon_resume"
is introduced in struct sof_intel_hda_stream. The flag is set
for hda streams when the sof device suspends and is
cleared after hw_params is set.
Signed-off-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
