Pull Devicetree updates from Rob Herring:
- DT binding schema examples are now validated against the schemas.
Various examples are fixed due to that.
- Sync dtc with upstream version v1.5.0-30-g702c1b6c0e73
- Initial schemas for networking bindings. This includes ethernet, phy
and mdio common bindings with several Allwinner and stmmac converted
to the schema.
- Conversion of more Arm top-level SoC/board bindings to DT schema
- Conversion of PSCI binding to DT schema
- Rework Arm CPU schema to coexist with other CPU schemas
- Add a bunch of missing vendor prefixes and new ones for SoChip,
Sipeed, Kontron, B&R Industrial Automation GmbH, and Espressif
- Add Mediatek UART RX wakeup support to binding
- Add reset to ST UART binding
- Remove some Linuxisms from the endianness common-properties.txt
binding
- Make the flattened DT read-only after init
- Ignore disabled reserved memory nodes
- Clean-up some dead code in FDT functions
* tag 'devicetree-for-5.3' of git://git.kernel.org/pub/scm/linux/kernel/git/robh/linux: (56 commits)
dt-bindings: vendor-prefixes: add Sipeed
dt-bindings: vendor-prefixes: add SoChip
dt-bindings: 83xx-512x-pci: Drop cell-index property
dt-bindings: serial: add documentation for Rx in-band wakeup support
dt-bindings: arm: Convert RDA Micro board/soc bindings to json-schema
of: unittest: simplify getting the adapter of a client
of/fdt: pass early_init_dt_reserve_memory_arch() with bool type nomap
of/platform: Drop superfluous cast in of_device_make_bus_id()
dt-bindings: usb: ehci: Fix example warnings
dt-bindings: net: Use phy-mode instead of phy-connection-type
dt-bindings: simple-framebuffer: Add requirement for pipelines
dt-bindings: display: Fix simple-framebuffer example
dt-bindings: net: mdio: Add child nodes
dt-bindings: net: mdio: Add address and size cells
dt-bindings: net: mdio: Add a nodename pattern
dt-bindings: mtd: sunxi-nand: Drop 'maxItems' from child 'reg' property
dt-bindings: arm: Limit cpus schema to only check Arm 'cpu' nodes
dt-bindings: backlight: lm3630a: correct schema validation
dt-bindings: net: dwmac: Deprecate the PHY reset properties
dt-bindings: net: sun8i-emac: Convert the binding to a schemas
...
Loud speaker pop happens during playback even when in slience
playback. Specify Max98357a amp delay times to make sure
clocks are always earlier than sdmode on.
Signed-off-by: Mac Chiang <mac.chiang@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The Cirrus Logic Madera codecs are a family of related codecs with
extensive digital and analogue I/O, digital mixing and routing,
signal processing and programmable DSPs.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
"git diff" says:
\ No newline at end of file
after modifying the files.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Rob Herring <robh@kernel.org>
When McASP is bus master it's reference clock (AUXCLK) might not be a
static clock, but running at a specific FS ratio.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Some new files got converted to yaml, but references weren't
updated accordingly.
Signed-off-by: Mauro Carvalho Chehab <mchehab+samsung@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The A83t and compatibles controllers don't have any reception capabilities
on some instances of the controllers, even though it was never documented
as such in the binding before.
Therefore, on those controllers, we don't have the option to set an RX DMA
channel.
This was already done in the DTSI, but the binding itself was never
updated. Let's add a special case in the schemas.
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The Allwinner SoCs feature an I2S controller across multiple SoC
generations.
However, earlier generations were a bit simpler than the subsequent ones,
and for example would always have RX and TX capabilities, and no reset
lines.
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Allwinner H6 has a SPDIF controller with an increase of the fifo
size and a sligher difference in memory mapping compare to H3/A64.
This make it not compatible with the previous generation.
Introduce a specific bindings for H6 SoC.
Signed-off-by: Clément Péron <peron.clem@gmail.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The H3 and compatibles controllers don't have any reception capabilities,
even though it was never documented as such in the binding before.
Therefore, on those controllers, we don't have the option to set an RX DMA
channel.
This was already done in the DTSI, but the binding itself was never
updated. Let's add a special case in the schemas.
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The Allwinner SoCs feature an SPDIF controller across multiple SoC
generations.
However, earlier generations were a bit simpler than the subsequent ones,
and for example would always have RX and TX capabilities, and no reset
lines.
In order to express this, let's create two YAML schemas instead of the free
form text we had before.
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Document SoC specific bindings for R-Car RZ/G1C(r8a77470) SoC.
Signed-off-by: Cao Van Dong <cv-dong@jinso.co.jp>
Signed-off-by: Mark Brown <broonie@kernel.org>
The simple-audio-card,pin-switches property can contain the list of
widget names for which pin switches must be created.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Signed-off-by: Mark Brown <broonie@kernel.org>
On Spreadtrum platform, the audio subsystem will use the multi-channel
data transfer controller to transfer sound stream between audio subsystem
and other AP/CP subsystem.
It can support 10 DAC channel and 10 ADC channel, and each channel has
512 bytes depth data fifo. Moreover each channel can be used DMA mode
or interrupt mode to transfer data.
Signed-off-by: Baolin Wang <baolin.wang@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add new compatible strings for the g12a devices.
Audio wise, the g12a is fairly to close to the axg, yet some differences
need to be handled.
Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add compatible, reg, regulator, and reset
to Cirrus CS42L51 audio codec bindings.
Signed-off-by: Olivier Moysan <olivier.moysan@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds document for the machine board with
mt6358, da7219 and max98357 codecs.
Signed-off-by: Shunli Wang <shunli.wang@mediatek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds document for the machine board with
mt6358, ts3a227 and max98357 codecs.
Signed-off-by: Shunli Wang <shunli.wang@mediatek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add the DT binding documentation for NXP Audio Mixer
CPU DAI driver.
Signed-off-by: Viorel Suman <viorel.suman@nxp.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Lochnagar is an evaluation and development board for Cirrus
Logic Smart CODEC and Amp devices. It allows the connection of
most Cirrus Logic devices on mini-cards, as well as allowing
connection of various application processor systems to provide a
full evaluation platform. This driver supports the board
controller chip on the Lochnagar board.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds DT bindings for the new Microchip I2S Multi-Channel
controller embedded inside sam9x60 SoCs.
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
With the need to expose WCLK and BCLK as separate clocks, the
'clock-cells' and 'clock-output-names' descriptions need to be
updated as now the codec is providing 2 clocks. The example is
also updated accordingly.
Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Some boards use a jack-receptacle with a switch which reports the
jack-inserted status as active-high, rather then the standard active-low
reporting most jacks use.
This commit adds support for it. This is activated by a boolean
"realtek,jack-detect-not-inverted" device-property. The not-inverted
in the device-property name, rather then active-high, was chosen to keep
the device-property naming consistent with the rt5640 codec driver.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Some amplifier may not have a GPIO to control the power, but instead simply
rely on the regulator to power up and down the amplifier.
In order to support those setups, let's make the GPIO optional.
Signed-off-by: Mylène Josserand <mylene.josserand@bootlin.com>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
If SoC has extended Audio DMAC peri peri address,
DT needs to select it.
Otherwise, it can select normal Audio DMAC peri peri address.
Extended Audio DMAC peri peri address can use BUSIF4-7,
normal address can't.
Reported-by: Jiada Wang <jiada_wang@mentor.com>
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Simon Horman <horms+renesas@verge.net.au>
Signed-off-by: Mark Brown <broonie@kernel.org>
Both the capture and playback channels are optional in the axi_i2s IP
block. Document how to tell the driver which channels are
instantiated.
Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
Signed-off-by: Mark Brown <broonie@kernel.org>
ASoC: More changes for v5.1
Another batch of changes for ASoC, no big core changes - it's mainly
small fixes and improvements for individual drivers.
- A big refresh and cleanup of the Samsung drivers, fixing a number of
issues which allow the driver to be used with a wider range of
userspaces.
- Fixes for the Intel drivers to make them more standard so less likely
to get bitten by core issues.
- New driver for Cirrus Logic CS35L26.
An optional property "nvidia,model" is introduced for hda to pass custom
name for the sound card. The suffix "-hda" in the name passed is useful
to distinguish between multiple cards available for a platform.
When the property is not specified, default name("tegra-hda") mentioned
in hda driver is used. This property can be added in platform specific
file of the board and card name can relate to the board in use.
Signed-off-by: Sameer Pujar <spujar@nvidia.com>
Reviewed-by: Jonathan Hunter <jonathanh@nvidia.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
This change fixes a typo in the dt-binding examples (reset_gpio ->
reset-gpios).
Even though 'reset-gpio' is a valid construct for gpiolib the naming
'reset-gpios' is more suited for dt-bindings documentation.
Signed-off-by: Bogdan Togorean <bogdan.togorean@analog.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Fix upper-case regulator names in the binding example which do not match
the corresponding required properties.
While at it, add a blank line after the required-properties section to
improve readability.
Signed-off-by: Johan Hovold <johan@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add documentation about how to probe the jz4725b-codec driver from
devicetree.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add documentation about how to probe the jz4740-codec driver from
devicetree.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Signed-off-by: Mark Brown <broonie@kernel.org>
