Add devicetree bindings documentation file for Cirrus
Logic CS43130 codec.
Signed-off-by: Li Xu <li.xu@cirrus.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Some CPU drivers (e. g. davinci-mcasp) may require the system clock to
be configured as OUT, while there's no good way currently to set
SND_SOC_CLK_OUT in simple-soc driver if the clock is fixed-rate.
This patch makes asoc_simple_card_init_dai() initialize clock to
SND_SOCK_CLK_OUT if explicitly stated in the relevant dts file. This
change is transparent and doesn't change the default behavior.
Signed-off-by: Vitaly Wool <vitaly.wool@konsulko.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
In aic3x class of devices Output Common-Mode Voltage can be configured for
better analog performance.
The OCMV value depends on the Analog and digital domain power supply
voltage configuration.
The default OCMV of 1.35V gives best performance when AVDD is around 2.7V
and DVDD is 1.525V, but for higher AVDD/DVDD higher OCMV setting is
recommended.
The patch gives an automatic way of guessing the best OCMV which can be
overwritten by a DT parameter if needed.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Nodes without reg properties must not have unit addresses:
Warning (unit_address_vs_reg): Node .../rcar_sound,dvc/dvc@0 has a unit name, but no reg property
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@kernel.org>
MBHC (MultiButton Headset Control) support is available in pm8921 in two
blocks, one to detect mechanical headset insertion and removal and other
block to support headset type detection and 5 button detection and othe
features like impedance calculation.
This patch adds support to:
1> Support to NC and NO type of headset Jacks.
2> Mechanical insertion and detection of headset jack.
3> Detect a 3 pole Headphone and a 4 pole Headset.
4> Detect 5 buttons.
Tested it on DB410c with Audio Mezz board with 4 pole and 3 pole
headset/headphones.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Tested-by: Damien Riegel <damien.riegel@savoirfairelinux.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds bindings in DT to provide required micbias voltage which
could be specific to board. With this new binding, now the mic bias
voltage is left at hardware default value if the device tree does not
specify any mic bias voltage value. Correct micbias value is required
for mbhc buttons to work.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The sun8i-h3 introduces a lot of changes to the i2s block such
as different register locations, extended clock division and
more operational modes. As we have to consider the earlier
implementation then these changes need to be isolated.
None of the new functionality has been implemented yet, the
driver has just been expanded to allow it work on the H3 SoC.
Signed-off-by: Marcus Cooper <codekipper@gmail.com>
Reviewed-by: Chen-Yu Tsai <wens@csie.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
pdm sdi0~3 pins are optional, for example, if 4ch required,
only sdi0~1 need to be enabled.
Signed-off-by: Sugar Zhang <sugar.zhang@rock-chips.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add interrupt-names property in DT - if future revisions of the IP
have different sets of interrupts the binding can adapt gracefully.
Signed-off-by: Ryder Lee <ryder.lee@mediatek.com>
CC: Garlic Tseng <garlic.tseng@mediatek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
there may use enable pin to control dmic start and stop,
so add this property in dt-bindings.
Signed-off-by: Lin Huang <hl@rock-chips.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
As suggested in reviews the requirement of clocks in the 'sound' node
is dropped and instead a leaf clock is used to configure frequency
of the audio root clock PLL. This can work now after the clock tree
definitions have been updated to allow clock rate setting propagation
on the path from the I2S controller up to the EPLL.
This patch also lowers the CODEC master clock frequency so as
to not exceed the maximum allowed 60 MHz at maximum audio sampling
rates.
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Acked-by: Krzysztof Kozlowski <krzk@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds documentation of device tree bindings for audio DMIC codec.
Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The patch seprates the DC offset between headphone and headset.
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
RT274 is a HD-A/SOC dual mode codec. This is the initial codec driver
of SOC mode.
Signed-off-by: Bard Liao <bardliao@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add the ability to configure the MFP1->MFP5 registers
as GPIOs. In addition adding ALSA controls to get and set
the GPIO state.
Per the data sheet each MFP can be configured as a GPIO
input only, output only or either an input or output.
Signed-off-by: Dan Murphy <dmurphy@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The patch adds the manual offset field in the devicetree to compensate the
DC offset that will be different between the PCB layout. It only can be
measured by the real production.
Signed-off-by: Oder Chiou <oder_chiou@realtek.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The audio-graph-card should be able to support widgets and routing in
the same way as what simple-audio-card does. The patch adds the
properties into audio-graph-card bindings. Then an optional property
'pa-gpios' for controlling external amplifier, which depends on DAPM
widgets and routing, is added.
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The property type of "nuvoton,crosstalk-bypass" changes to boolean.
The document is updated as well.
Signed-off-by: John Hsu <KCHSU0@nuvoton.com>
Signed-off-by: John Hsu <supercraig0719@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
audio-graph-scu-card can handle below connection which is mainly
for sound mixing purpose.
+----------+ +-------+
| CPU0--+--|-->| Codec |
| | | +-------+
| CPU1--+ |
+----------+
>From OF-graph point of view, it should have
CPU0 <-> Codec, and CPU1 <-> Codec on DT.
But current driver doesn't care about 2nd connection
of Codec, because it is dummy from DPCM point of view.
This patch can care 2nd Codec connection, and it should be
supported from OF-graph point of view.
It still have backward compatibility.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add documentation of device tree bindings for the
STM32 SPDIFRX interface.
Signed-off-by: olivier moysan <olivier.moysan@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The Pulse Density Modulation Interface Controller (PDMC) is
a PDM interface controller and decoder that support PDM format.
It integrates a clock generator driving the PDM microphone
and embeds filters which decimate the incoming bit stream to
obtain most common audio rates.
Signed-off-by: Sugar Zhang <sugar.zhang@rock-chips.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch removes unused and undocumented samsung,cpu-dai,
samsung,codec-dai properties from the dts example and moves
sub-nodes' description to a separate section.
Suggested-by: Rob Herring <robh@kernel.org>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Document the optional properties for describing module resets, to
support resetting these modules on R-Car Gen2 and Gen3.
Note that the audio module has resets for the Serial Sound Interfaces
only.
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Mark Brown <broonie@kernel.org>
The codec in the V3s is similar to the one found on the A31. One key
difference is the analog path controls are routed through the PRCM
block. This is supported by the sun8i-codec-analog driver, and tied
into this codec driver with the audio card's aux_dev.
In addition, the V3s does not have LINEIN, LINEOUT, MBIAS and MIC2,
MIC3, and the FIFO related registers are like H3.
Signed-off-by: Icenowy Zheng <icenowy@aosc.xyz>
Reviewed-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The V3s SoC features an analog codec with headphone support but without
mic2 and linein.
Add support for it.
Signed-off-by: Icenowy Zheng <icenowy@aosc.xyz>
Reviewed-by: Chen-Yu Tsai <wens@csie.org>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add documentation of device tree bindings for STM32 SPI/I2S.
Signed-off-by: olivier moysan <olivier.moysan@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
simple-scu-card is almost same as simple-card. This is already explained
in document. But simple-card and simple-scu-card both has same
explanation for same property. This patch forward explantion to
simple-card if possible to avoid duplication.
This patch also cleanup DT binding example which is not good matching
to simple-scu-card.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
