net: axienet: Autodetect 64-bit DMA capability

When newer revisions of the Axienet IP are configured for a 64-bit bus,
we *need* to write to the MSB part of the an address registers,
otherwise the IP won't recognise this as a DMA start condition.
This is even true when the actual DMA address comes from the lower 4 GB.

To autodetect this configuration, at probe time we write all 1's to such
an MSB register, and see if any bits stick. If this is configured for a
32-bit bus, those MSB registers are RES0, so reading back 0 indicates
that no MSB writes are necessary.
On the other hands reading anything other than 0 indicated the need to
write the MSB registers, so we set the respective flag.

The actual DMA mask stays at 32-bit for now. To help bisecting, a
separate patch will enable allocations from higher addresses.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/xilinx/xilinx_axienet.h

@@ -161,6 +161,7 @@
 #define XAE_FCC_OFFSET		0x0000040C /* Flow Control Configuration */
 #define XAE_EMMC_OFFSET		0x00000410 /* EMAC mode configuration */
 #define XAE_PHYC_OFFSET		0x00000414 /* RGMII/SGMII configuration */
+#define XAE_ID_OFFSET		0x000004F8 /* Identification register */
 #define XAE_MDIO_MC_OFFSET	0x00000500 /* MII Management Config */
 #define XAE_MDIO_MCR_OFFSET	0x00000504 /* MII Management Control */
 #define XAE_MDIO_MWD_OFFSET	0x00000508 /* MII Management Write Data */