brcmfmac: move brcmf_bus_preinit() call just after changing bus state

Moving the brcmf_bus_preinit() call allows the bus code to do some
required initialization before handling firmware control messages.

Reviewed-by: Hante Meuleman <hante.meuleman@broadcom.com>
Reviewed-by: Pieter-Paul Giesberts <pieter-paul.giesberts@broadcom.com>
Reviewed-by: Franky Lin <franky.lin@broadcom.com>
Signed-off-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/broadcom/brcm80211/brcmfmac/common.c

@@ -365,9 +365,6 @@ int brcmf_c_preinit_dcmds(struct brcmf_if *ifp)
 
 	/* Enable tx beamforming, errors can be ignored (not supported) */
 	(void)brcmf_fil_iovar_int_set(ifp, "txbf", 1);
-
-	/* do bus specific preinit here */
-	err = brcmf_bus_preinit(ifp->drvr->bus_if);
 done:
 	return err;
 }

drivers/net/wireless/broadcom/brcm80211/brcmfmac/core.c

@@ -1013,6 +1013,11 @@ int brcmf_bus_started(struct device *dev)
 	/* signal bus ready */
 	brcmf_bus_change_state(bus_if, BRCMF_BUS_UP);
 
+	/* do bus specific preinit here */
+	ret = brcmf_bus_preinit(ifp->drvr->bus_if);
+	if (ret < 0)
+		goto fail;
+
 	/* Bus is ready, do any initialization */
 	ret = brcmf_c_preinit_dcmds(ifp);
 	if (ret < 0)