libertas: only enable mesh when interface is active

Previously, the mesh was running whenever the appropriate hardware
and firmware was present.

Now we only run the mesh when the interface is running.

Also simplifies interface management a little.

Signed-off-by: Daniel Drake <dsd@laptop.org>
Acked-by: Dan Williams <dcbw@redhat.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

drivers/net/wireless/libertas/mesh.h

@@ -63,11 +63,6 @@ void lbs_mesh_ethtool_get_strings(struct net_device *dev,
 	uint32_t stringset, uint8_t *s);
 
 
-/* Accessors */
-
-#define lbs_mesh_open(priv) (priv->mesh_open)
-#define lbs_mesh_connected(priv) (priv->mesh_connect_status == LBS_CONNECTED)
-
 #else
 
 #define lbs_init_mesh(priv)
@@ -77,8 +72,6 @@ void lbs_mesh_ethtool_get_strings(struct net_device *dev,
 #define lbs_mesh_set_dev(priv, dev, rxpd) (dev)
 #define lbs_mesh_set_txpd(priv, dev, txpd)
 #define lbs_mesh_config(priv, enable, chan)
-#define lbs_mesh_open(priv) (0)
-#define lbs_mesh_connected(priv) (0)
 
 #endif