net/fec: add dual fec support for mx28

This patch is to add mx28 dual fec support. Here are some key notes
for mx28 fec controller.

 - The mx28 fec controller naming ENET-MAC is a different IP from FEC
   used on other i.mx variants.  But they are basically compatible
   on software interface, so it's possible to share the same driver.
 - ENET-MAC design on mx28 made an improper assumption that it runs
   on a big-endian system. As the result, driver has to swap every
   frame going to and coming from the controller.
 - The external phys can only be configured by fec0, which means fec1
   can not work independently and both phys need to be configured by
   mii_bus attached on fec0.
 - ENET-MAC reset will get mac address registers reset too.
 - ENET-MAC MII/RMII mode and 10M/100M speed are configured
   differently FEC.
 - ETHER_EN bit must be set to get ENET-MAC interrupt work.

Signed-off-by: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/fec.h

@@ -14,7 +14,8 @@
 /****************************************************************************/
 
 #if defined(CONFIG_M523x) || defined(CONFIG_M527x) || defined(CONFIG_M528x) || \
-    defined(CONFIG_M520x) || defined(CONFIG_M532x) || defined(CONFIG_ARCH_MXC)
+    defined(CONFIG_M520x) || defined(CONFIG_M532x) || \
+    defined(CONFIG_ARCH_MXC) || defined(CONFIG_SOC_IMX28)
 /*
  *	Just figures, Motorola would have to change the offsets for
  *	registers in the same peripheral device on different models
@@ -78,7 +79,7 @@
 /*
  *	Define the buffer descriptor structure.
  */
-#ifdef CONFIG_ARCH_MXC
+#if defined(CONFIG_ARCH_MXC) || defined(CONFIG_SOC_IMX28)
 struct bufdesc {
 	unsigned short cbd_datlen;	/* Data length */
 	unsigned short cbd_sc;	/* Control and status info */