OMAP2/3 board-*.c files: read bootloader configuration earlier

Most board-*.c files read configuration data from the bootloader in
their .init_machine() function.  This needs to happen earlier, at some
point before omap2_init_common_hw() is called.  This is because a
future patch will use the bootloader serial console port information
to enable the UART clocks earlier, immediately after omap2_clk_init().
This is in turn necessary since otherwise clock tree usecounts on
clocks like dpll4_m2x2_ck will be bogus, which can cause the
currently-active console UART clock to be disabled during boot.

Signed-off-by: Paul Walmsley <paul@pwsan.com>

arch/arm/plat-omap/include/mach/serial.h

@@ -13,6 +13,8 @@
 #ifndef __ASM_ARCH_SERIAL_H
 #define __ASM_ARCH_SERIAL_H
 
+#include <linux/init.h>
+
 #if defined(CONFIG_ARCH_OMAP1)
 /* OMAP1 serial ports */
 #define OMAP_UART1_BASE		0xfffb0000
@@ -53,6 +55,7 @@
 			})
 
 #ifndef __ASSEMBLER__
+extern void __init omap_serial_early_init(void);
 extern void omap_serial_init(void);
 extern int omap_uart_can_sleep(void);
 extern void omap_uart_check_wakeup(void);