ARM: dts: push MMC/SD to board and add comments

This moves the enable-active-high setting from the SoC to the
board for the VMMCQ regulators. It should at least be in the
vicinity of the GPIO line it is defined for.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

arch/arm/boot/dts/ste-snowball.dts

@@ -216,11 +216,15 @@
 			};
 		};
 
+		/* ST6G3244ME level translator for 1.8/2.9 V */
 		vmmci: regulator-gpio {
 			compatible = "regulator-gpio";
 
+			/* GPIO228 SD_SEL */
 			gpios = <&gpio7 4 GPIO_ACTIVE_HIGH>;
+			/* GPIO217 MMC_EN */
 			enable-gpio = <&gpio6 25 GPIO_ACTIVE_HIGH>;
+			enable-active-high;
 
 			regulator-min-microvolt = <1800000>;
 			regulator-max-microvolt = <2900000>;
@@ -228,7 +232,6 @@
 			regulator-type = "voltage";
 
 			startup-delay-us = <100>;
-			enable-active-high;
 
 			states = <1800000 0x1
 				  2900000 0x0>;
@@ -546,6 +549,7 @@
 				sdi0_default_mode: sdi0_default {
 					snowball_mux {
 						function = "mc0";
+						/* Add the DAT31 pin even if it is not really used */
 						groups = "mc0dat31dir_a_1";
 					};
 					snowball_cfg1 {