ASoC: tas2552: Configure the WCLK frequency based on the stream

Instead of hard wiring the WCLK frequency at probe time do it runtime.
The hard wired 88_96KHz was not even setting the correct bits since it was
defined as (1 << 6) which will  change the I2S_OUT_SEL bit and will leave
the amplifier configured for 8KHz.
At the same time clean up and fix the CFG3 register bits.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This commit is contained in:
Peter Ujfalusi
2015-06-04 16:04:30 +03:00
committed by Mark Brown
부모 d20b098dd9
커밋 a571cb17ac
2개의 변경된 파일59개의 추가작업 그리고 21개의 파일을 삭제

파일 보기

@@ -168,7 +168,7 @@ static int tas2552_hw_params(struct snd_pcm_substream *substream,
int d;
int cpf;
u8 p, j;
u8 ser_ctrl1_reg;
u8 ser_ctrl1_reg, wclk_rate;
switch (params_width(params)) {
case 16:
@@ -206,6 +206,45 @@ static int tas2552_hw_params(struct snd_pcm_substream *substream,
TAS2552_WORDLENGTH_MASK | TAS2552_CLKSPERFRAME_MASK,
ser_ctrl1_reg);
switch (params_rate(params)) {
case 8000:
wclk_rate = TAS2552_WCLK_FREQ_8KHZ;
break;
case 11025:
case 12000:
wclk_rate = TAS2552_WCLK_FREQ_11_12KHZ;
break;
case 16000:
wclk_rate = TAS2552_WCLK_FREQ_16KHZ;
break;
case 22050:
case 24000:
wclk_rate = TAS2552_WCLK_FREQ_22_24KHZ;
break;
case 32000:
wclk_rate = TAS2552_WCLK_FREQ_32KHZ;
break;
case 44100:
case 48000:
wclk_rate = TAS2552_WCLK_FREQ_44_48KHZ;
break;
case 88200:
case 96000:
wclk_rate = TAS2552_WCLK_FREQ_88_96KHZ;
break;
case 176400:
case 192000:
wclk_rate = TAS2552_WCLK_FREQ_176_192KHZ;
break;
default:
dev_err(codec->dev, "Not supported sample rate: %d\n",
params_rate(params));
return -EINVAL;
}
snd_soc_update_bits(codec, TAS2552_CFG_3, TAS2552_WCLK_FREQ_MASK,
wclk_rate);
if (!tas2552->pll_clkin)
return -EINVAL;
@@ -503,7 +542,7 @@ static int tas2552_codec_probe(struct snd_soc_codec *codec)
snd_soc_update_bits(codec, TAS2552_CFG_1, TAS2552_MUTE, TAS2552_MUTE);
snd_soc_write(codec, TAS2552_CFG_3, TAS2552_I2S_OUT_SEL |
TAS2552_DIN_SRC_SEL_AVG_L_R | TAS2552_88_96KHZ);
TAS2552_DIN_SRC_SEL_AVG_L_R);
snd_soc_write(codec, TAS2552_DOUT, TAS2552_PDM_DATA_I);
snd_soc_write(codec, TAS2552_OUTPUT_DATA, TAS2552_PDM_DATA_V_I | 0x8);
snd_soc_write(codec, TAS2552_BOOST_PT_CTRL, TAS2552_APT_DELAY_200 |