MIPS: Netlogic: Fix frequency calculation register

Change the PIC frequency calculation to use the register that has the
current configuration. The existing code used the register that is
written to change frequency, which can have an invalid value if the
firmware did not set it up correctly.

Signed-off-by: Ganesan Ramalingam <ganesanr@broadcom.com>
Signed-off-by: Jayachandran C <jchandra@broadcom.com>
Cc: linux-mips@linux-mips.org
Patchwork: https://patchwork.linux-mips.org/patch/8885/
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>

arch/mips/netlogic/xlp/nlm_hal.c

@@ -332,7 +332,7 @@ static unsigned int nlm_xlp2_get_pic_frequency(int node)
 	/* Find the clock source PLL device for PIC */
 	if (cpu_xlp9xx) {
 		reg_select = nlm_read_sys_reg(clockbase,
-				SYS_9XX_CLK_DEV_SEL) & 0x3;
+				SYS_9XX_CLK_DEV_SEL_REG) & 0x3;
 		switch (reg_select) {
 		case 0:
 			ctrl_val0 = nlm_read_sys_reg(clockbase,
@@ -361,7 +361,7 @@ static unsigned int nlm_xlp2_get_pic_frequency(int node)
 		}
 	} else {
 		reg_select = (nlm_read_sys_reg(sysbase,
-					SYS_CLK_DEV_SEL) >> 22) & 0x3;
+					SYS_CLK_DEV_SEL_REG) >> 22) & 0x3;
 		switch (reg_select) {
 		case 0:
 			ctrl_val0 = nlm_read_sys_reg(sysbase,
@@ -425,10 +425,10 @@ static unsigned int nlm_xlp2_get_pic_frequency(int node)
 	/* PIC post divider, which happens after PLL */
 	if (cpu_xlp9xx)
 		pic_div = nlm_read_sys_reg(clockbase,
-				SYS_9XX_CLK_DEV_DIV) & 0x3;
+				SYS_9XX_CLK_DEV_DIV_REG) & 0x3;
 	else
 		pic_div = (nlm_read_sys_reg(sysbase,
-					SYS_CLK_DEV_DIV) >> 22) & 0x3;
+					SYS_CLK_DEV_DIV_REG) >> 22) & 0x3;
 	do_div(pll_out_freq_num, 1 << pic_div);
 
 	return pll_out_freq_num;