starfire: Move the Adaptec driver

Move the Adaptec driver into drivers/net/ethernet/adaptec/ and make
the necessary Kconfig and Makefile changes.

CC: Ion Badulescu <ionut@badula.org>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/adaptec/Kconfig

@@ -0,0 +1,34 @@
+#
+# Adaptec network device configuration
+#
+
+config NET_VENDOR_ADAPTEC
+	bool "Adaptec devices"
+	depends on PCI
+	---help---
+	  If you have a network (Ethernet) card belonging to this class, say Y
+	  and read the Ethernet-HOWTO, available from
+	  <http://www.tldp.org/docs.html#howto>.
+
+	  Note that the answer to this question doesn't directly affect the
+	  kernel: saying N will just cause the configurator to skip all
+	  the questions about Adaptec cards. If you say Y, you will be asked for
+	  your specific card in the following questions.
+
+if NET_VENDOR_ADAPTEC
+
+config ADAPTEC_STARFIRE
+	tristate "Adaptec Starfire/DuraLAN support"
+	depends on PCI
+	select CRC32
+	select MII
+	---help---
+	  Say Y here if you have an Adaptec Starfire (or DuraLAN) PCI network
+	  adapter. The DuraLAN chip is used on the 64 bit PCI boards from
+	  Adaptec e.g. the ANA-6922A. The older 32 bit boards use the tulip
+	  driver.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called starfire.  This is recommended.
+
+endif # NET_VENDOR_ADAPTEC

drivers/net/ethernet/adaptec/Makefile

@@ -0,0 +1,5 @@
+#
+# Makefile for the Adaptec network device drivers.
+#
+
+obj-$(CONFIG_ADAPTEC_STARFIRE) += starfire.o