Merge branch 'siginfo-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/ebiederm/user-namespace

Pull siginfo updates from Eric Biederman:
 "This set of changes close the known issues with setting si_code to an
  invalid value, and with not fully initializing struct siginfo. There
  remains work to do on nds32, arc, unicore32, powerpc, arm, arm64, ia64
  and x86 to get the code that generates siginfo into a simpler and more
  maintainable state. Most of that work involves refactoring the signal
  handling code and thus careful code review.

  Also not included is the work to shrink the in kernel version of
  struct siginfo. That depends on getting the number of places that
  directly manipulate struct siginfo under control, as it requires the
  introduction of struct kernel_siginfo for the in kernel things.

  Overall this set of changes looks like it is making good progress, and
  with a little luck I will be wrapping up the siginfo work next
  development cycle"

* 'siginfo-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/ebiederm/user-namespace: (46 commits)
  signal/sh: Stop gcc warning about an impossible case in do_divide_error
  signal/mips: Report FPE_FLTUNK for undiagnosed floating point exceptions
  signal/um: More carefully relay signals in relay_signal.
  signal: Extend siginfo_layout with SIL_FAULT_{MCEERR|BNDERR|PKUERR}
  signal: Remove unncessary #ifdef SEGV_PKUERR in 32bit compat code
  signal/signalfd: Add support for SIGSYS
  signal/signalfd: Remove __put_user from signalfd_copyinfo
  signal/xtensa: Use force_sig_fault where appropriate
  signal/xtensa: Consistenly use SIGBUS in do_unaligned_user
  signal/um: Use force_sig_fault where appropriate
  signal/sparc: Use force_sig_fault where appropriate
  signal/sparc: Use send_sig_fault where appropriate
  signal/sh: Use force_sig_fault where appropriate
  signal/s390: Use force_sig_fault where appropriate
  signal/riscv: Replace do_trap_siginfo with force_sig_fault
  signal/riscv: Use force_sig_fault where appropriate
  signal/parisc: Use force_sig_fault where appropriate
  signal/parisc: Use force_sig_mceerr where appropriate
  signal/openrisc: Use force_sig_fault where appropriate
  signal/nios2: Use force_sig_fault where appropriate
  ...
This commit is contained in:
Linus Torvalds
2018-06-04 15:23:48 -07:00
83 ha cambiato i file con 493 aggiunte e 1066 eliminazioni

Vedi File

@@ -353,23 +353,22 @@ bad_area:
up_read(&mm->mmap_sem);
if (user_mode(regs)) {
struct siginfo si;
unsigned int lsb = 0;
int signo, si_code;
switch (code) {
case 15: /* Data TLB miss fault/Data page fault */
/* send SIGSEGV when outside of vma */
if (!vma ||
address < vma->vm_start || address >= vma->vm_end) {
si.si_signo = SIGSEGV;
si.si_code = SEGV_MAPERR;
signo = SIGSEGV;
si_code = SEGV_MAPERR;
break;
}
/* send SIGSEGV for wrong permissions */
if ((vma->vm_flags & acc_type) != acc_type) {
si.si_signo = SIGSEGV;
si.si_code = SEGV_ACCERR;
signo = SIGSEGV;
si_code = SEGV_ACCERR;
break;
}
@@ -377,43 +376,40 @@ bad_area:
/* fall through */
case 17: /* NA data TLB miss / page fault */
case 18: /* Unaligned access - PCXS only */
si.si_signo = SIGBUS;
si.si_code = (code == 18) ? BUS_ADRALN : BUS_ADRERR;
signo = SIGBUS;
si_code = (code == 18) ? BUS_ADRALN : BUS_ADRERR;
break;
case 16: /* Non-access instruction TLB miss fault */
case 26: /* PCXL: Data memory access rights trap */
default:
si.si_signo = SIGSEGV;
si.si_code = (code == 26) ? SEGV_ACCERR : SEGV_MAPERR;
signo = SIGSEGV;
si_code = (code == 26) ? SEGV_ACCERR : SEGV_MAPERR;
break;
}
#ifdef CONFIG_MEMORY_FAILURE
if (fault & (VM_FAULT_HWPOISON|VM_FAULT_HWPOISON_LARGE)) {
unsigned int lsb = 0;
printk(KERN_ERR
"MCE: Killing %s:%d due to hardware memory corruption fault at %08lx\n",
tsk->comm, tsk->pid, address);
si.si_signo = SIGBUS;
si.si_code = BUS_MCEERR_AR;
/*
* Either small page or large page may be poisoned.
* In other words, VM_FAULT_HWPOISON_LARGE and
* VM_FAULT_HWPOISON are mutually exclusive.
*/
if (fault & VM_FAULT_HWPOISON_LARGE)
lsb = hstate_index_to_shift(VM_FAULT_GET_HINDEX(fault));
else if (fault & VM_FAULT_HWPOISON)
lsb = PAGE_SHIFT;
force_sig_mceerr(BUS_MCEERR_AR, (void __user *) address,
lsb, current);
return;
}
#endif
show_signal_msg(regs, code, address, tsk, vma);
/*
* Either small page or large page may be poisoned.
* In other words, VM_FAULT_HWPOISON_LARGE and
* VM_FAULT_HWPOISON are mutually exclusive.
*/
if (fault & VM_FAULT_HWPOISON_LARGE)
lsb = hstate_index_to_shift(VM_FAULT_GET_HINDEX(fault));
else if (fault & VM_FAULT_HWPOISON)
lsb = PAGE_SHIFT;
else
show_signal_msg(regs, code, address, tsk, vma);
si.si_addr_lsb = lsb;
si.si_errno = 0;
si.si_addr = (void __user *) address;
force_sig_info(si.si_signo, &si, current);
force_sig_fault(signo, si_code, (void __user *) address, current);
return;
}