Merge branch 'for-linus' into next

Sync up to bring in wacom_w8001 changes to avoid merge conflicts later.

Documentation/devicetree/bindings/input/ads7846.txt

@@ -29,6 +29,8 @@ Optional properties:
 	ti,vref-delay-usecs		vref supply delay in usecs, 0 for
 					external vref (u16).
 	ti,vref-mv			The VREF voltage, in millivolts (u16).
+					Set to 0 to use internal refernce
+					(ADS7846).
 	ti,keep-vref-on			set to keep vref on for differential
 					measurements as well
 	ti,swap-xy			swap x and y axis

Documentation/devicetree/bindings/input/touchscreen/fsl-mx25-tcq.txt

@@ -0,0 +1,35 @@
+Freescale mx25 TS conversion queue module
+
+mx25 touchscreen conversion queue module which controls the ADC unit of the
+mx25 for attached touchscreens.
+
+Required properties:
+ - compatible: Should be "fsl,imx25-tcq".
+ - reg: Memory range of the device.
+ - interrupts: Should be the interrupt number associated with this module within
+   the tscadc unit (<0>).
+ - interrupt-parent: Should be a phandle to the tscadc unit.
+ - fsl,wires: Should be '<4>' or '<5>'
+
+Optional properties:
+ - fsl,pen-debounce-ns: Pen debounce time in nanoseconds.
+ - fsl,pen-threshold: Pen-down threshold for the touchscreen. This is a value
+   between 1 and 4096. It is the ratio between the internal reference voltage
+   and the measured voltage after the plate was precharged. Resistence between
+   plates and therefore the voltage decreases with pressure so that a smaller
+   value is equivalent to a higher pressure.
+ - fsl,settling-time-ns: Settling time in nanoseconds. The settling time is before
+   the actual touch detection to wait for an even charge distribution in the
+   plate.
+
+This device includes two conversion queues which can be added as subnodes.
+The first queue is for the touchscreen, the second for general purpose ADC.
+
+Example:
+	tsc: tcq@50030400 {
+		compatible = "fsl,imx25-tcq";
+		reg = <0x50030400 0x60>;
+		interrupt-parent = <&tscadc>;
+		interrupts = <0>;
+		fsl,wires = <4>;
+	};