[PATCH] pcmcia: remove unneeded Vcc pseudo setting

As we do not allow setting Vcc in the pcmcia core, and Vpp1 and
Vpp2 can only be set to the same value, a lot of code can be
streamlined.

Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>

drivers/isdn/hisax/sedlbauer_cs.c

@@ -184,7 +184,6 @@ static int sedlbauer_attach(struct pcmcia_device *p_dev)
 
 
     link->conf.Attributes = 0;
-    link->conf.Vcc = 50;
     link->conf.IntType = INT_MEMORY_AND_IO;
 
     link->handle = p_dev;
@@ -263,9 +262,7 @@ static void sedlbauer_config(dev_link_t *link)
     /* Configure card */
     link->state |= DEV_CONFIG;
 
-    /* Look up the current Vcc */
     CS_CHECK(GetConfigurationInfo, pcmcia_get_configuration_info(handle, &conf));
-    link->conf.Vcc = conf.Vcc;
 
     /*
       In this loop, we scan the CIS for configuration table entries,
@@ -309,10 +306,10 @@ static void sedlbauer_config(dev_link_t *link)
 	}
 	    
 	if (cfg->vpp1.present & (1<<CISTPL_POWER_VNOM))
-	    link->conf.Vpp1 = link->conf.Vpp2 =
+	    link->conf.Vpp =
 		cfg->vpp1.param[CISTPL_POWER_VNOM]/10000;
 	else if (dflt.vpp1.present & (1<<CISTPL_POWER_VNOM))
-	    link->conf.Vpp1 = link->conf.Vpp2 =
+	    link->conf.Vpp =
 		dflt.vpp1.param[CISTPL_POWER_VNOM]/10000;
 	
 	/* Do we need to allocate an interrupt? */
@@ -403,11 +400,10 @@ static void sedlbauer_config(dev_link_t *link)
     link->dev = &dev->node;
 
     /* Finally, report what we've done */
-    printk(KERN_INFO "%s: index 0x%02x: Vcc %d.%d",
-	   dev->node.dev_name, link->conf.ConfigIndex,
-	   link->conf.Vcc/10, link->conf.Vcc%10);
-    if (link->conf.Vpp1)
-	printk(", Vpp %d.%d", link->conf.Vpp1/10, link->conf.Vpp1%10);
+    printk(KERN_INFO "%s: index 0x%02x:",
+	   dev->node.dev_name, link->conf.ConfigIndex);
+    if (link->conf.Vpp)
+	printk(", Vpp %d.%d", link->conf.Vpp/10, link->conf.Vpp%10);
     if (link->conf.Attributes & CONF_ENABLE_IRQ)
 	printk(", irq %d", link->irq.AssignedIRQ);
     if (link->io.NumPorts1)