ieee1394: eth1394: don't autoload by hotplug when ohci1394 starts

Until now, ieee1394 put an IP-over-1394 capability entry into each new
host's config ROM.  As soon as the controller was initialized --- i.e.
right after modprobe ohci1394 --- this entry triggered a hotplug event
which typically caused auto-loading of eth1394.

This irritated or annoyed many users and distributors.  Of course they
could blacklist eth1394, but then ieee1394 wrongly advertized IP-over-
1394 capability to the FireWire bus.

Therefore
  - remove the offending kernel config option
    IEEE1394_CONFIG_ROM_IP1394,
  - let eth1394 add the ROM entry by itself, i.e. only after eth1394 was
    loaded.

This fixes http://bugzilla.kernel.org/show_bug.cgi?id=7793 .

To emulate the behaviour of older kernels, simply add the following to
to /etc/modprobe.conf:

install ohci1394 /sbin/modprobe eth1394; \
                 /sbin/modprobe --ignore-install ohci1394

Note, autoloading of eth1394 when an _external_ IP-over-1394 capable
device is discovered is _not_ affected by this patch.

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

drivers/ieee1394/config_roms.h

@@ -6,11 +6,14 @@ struct hpsb_host;
 int hpsb_default_host_entry(struct hpsb_host *host);
 int hpsb_init_config_roms(void);
 void hpsb_cleanup_config_roms(void);
-int hpsb_add_extra_config_roms(struct hpsb_host *host);
-void hpsb_remove_extra_config_roms(struct hpsb_host *host);
 
 /* List of flags to check if a host contains a certain extra config rom
  * entry. Available in the host->config_roms member. */
 #define HPSB_CONFIG_ROM_ENTRY_IP1394		0x00000001
 
+#ifdef CONFIG_IEEE1394_ETH1394_ROM_ENTRY
+int hpsb_config_rom_ip1394_add(struct hpsb_host *host);
+void hpsb_config_rom_ip1394_remove(struct hpsb_host *host);
+#endif
+
 #endif /* _IEEE1394_CONFIG_ROMS_H */