regulator: Add ramp_delay configuration to constraints

For some hardwares ramp_delay for BUCKs is a configurable parameter which can
be configured through DT or board file.This patch adds ramp_delay to regulator
constraints and allow user to configure it for regulators which supports this
feature, through DT or board file. It will provide two ways of setting the
ramp_delay for a regulator:
	First, by setting it as constraints in board file(for configurable
regulators) and set_machine_constraints() will take care of setting it on
hardware by calling(the provided) .set_ramp_delay() operation(callback).
	Second, by setting it as data in regulator_desc(as fixed/default
ramp_delay rate) for a regulator in driver.

regulator_set_voltage_time_sel() will give preference to
constraints->ramp_delay while reading ramp_delay rate for regulator. Similarly
users should also take care accordingly while refering ramp_delay rate(in case
of implementing their private .set_voltage_time_sel() callbacks for different
regulators).

[Rewrote subject for 80 columns -- broonie]

Signed-off-by: Yadwinder Singh Brar <yadi.brar@samsung.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>

include/linux/regulator/machine.h

@@ -92,6 +92,7 @@ struct regulator_state {
  *                 mode.
  * @initial_state: Suspend state to set by default.
  * @initial_mode: Mode to set at startup.
+ * @ramp_delay: Time to settle down after voltage change (unit: mV/us)
  */
 struct regulation_constraints {
 
@@ -125,6 +126,8 @@ struct regulation_constraints {
 	/* mode to set on startup */
 	unsigned int initial_mode;
 
+	unsigned int ramp_delay;
+
 	/* constraint flags */
 	unsigned always_on:1;	/* regulator never off when system is on */
 	unsigned boot_on:1;	/* bootloader/firmware enabled regulator */