NFC: nxp-nci_i2c: Add I2C support to NXP NCI driver
Add a module to the NXP-NCI driver to support NFC controllers with an I2C control interface, such as the NPC100. Signed-off-by: Clément Perrochaud <clement.perrochaud@effinnov.com> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
This commit is contained in:

committed by
Samuel Ortiz

parent
dece45855a
commit
6be88670fc
35
Documentation/devicetree/bindings/net/nfc/nxp-nci.txt
Normal file
35
Documentation/devicetree/bindings/net/nfc/nxp-nci.txt
Normal file
@@ -0,0 +1,35 @@
|
||||
* NXP Semiconductors NXP NCI NFC Controllers
|
||||
|
||||
Required properties:
|
||||
- compatible: Should be "nxp,nxp-nci-i2c".
|
||||
- clock-frequency: I²C work frequency.
|
||||
- reg: address on the bus
|
||||
- interrupt-parent: phandle for the interrupt gpio controller
|
||||
- interrupts: GPIO interrupt to which the chip is connected
|
||||
- enable-gpios: Output GPIO pin used for enabling/disabling the chip
|
||||
- firmware-gpios: Output GPIO pin used to enter firmware download mode
|
||||
|
||||
Optional SoC Specific Properties:
|
||||
- pinctrl-names: Contains only one value - "default".
|
||||
- pintctrl-0: Specifies the pin control groups used for this controller.
|
||||
|
||||
Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2):
|
||||
|
||||
&i2c2 {
|
||||
|
||||
status = "okay";
|
||||
|
||||
npc100: npc100@29 {
|
||||
|
||||
compatible = "nxp,nxp-nci-i2c";
|
||||
|
||||
reg = <0x29>;
|
||||
clock-frequency = <100000>;
|
||||
|
||||
interrupt-parent = <&gpio1>;
|
||||
interrupts = <29 GPIO_ACTIVE_HIGH>;
|
||||
|
||||
enable-gpios = <&gpio0 30 GPIO_ACTIVE_HIGH>;
|
||||
firmware-gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;
|
||||
};
|
||||
};
|
Reference in New Issue
Block a user