net: ethernet: Use phy_set_max_speed() to limit advertised speed

Many Ethernet MAC drivers want to limit the PHY to only advertise a
maximum speed of 100Mbs or 1Gbps. Rather than using a mask, make use
of the helper function phy_set_max_speed().

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/altera/altera_tse_main.c

@@ -835,13 +835,10 @@ static int init_phy(struct net_device *dev)
 	}
 
 	/* Stop Advertising 1000BASE Capability if interface is not GMII
-	 * Note: Checkpatch throws CHECKs for the camel case defines below,
-	 * it's ok to ignore.
 	 */
 	if ((priv->phy_iface == PHY_INTERFACE_MODE_MII) ||
 	    (priv->phy_iface == PHY_INTERFACE_MODE_RMII))
-		phydev->advertising &= ~(SUPPORTED_1000baseT_Half |
-					 SUPPORTED_1000baseT_Full);
+		phy_set_max_speed(phydev, SPEED_100);
 
 	/* Broken HW is sometimes missing the pull-up resistor on the
 	 * MDIO line, which results in reads to non-existent devices returning