Merge tag 'for-linus-20130301' of git://git.infradead.org/linux-mtd

Pull MTD update from David Woodhouse:
 "Fairly unexciting MTD merge for 3.9:

   - misc clean-ups in the MTD command-line partitioning parser
     (cmdlinepart)
   - add flash locking support for STmicro chips serial flash chips, as
     well as for CFI command set 2 chips.
   - new driver for the ELM error correction HW module found in various
     TI chips, enable the OMAP NAND driver to use the ELM HW error
     correction
   - added number of new serial flash IDs
   - various fixes and improvements in the gpmi NAND driver
   - bcm47xx NAND driver improvements
   - make the mtdpart module actually removable"

* tag 'for-linus-20130301' of git://git.infradead.org/linux-mtd: (45 commits)
  mtd: map: BUG() in non handled cases
  mtd: bcm47xxnflash: use pr_fmt for module prefix in messages
  mtd: davinci_nand: Use managed resources
  mtd: mtd_torturetest can cause stack overflows
  mtd: physmap_of: Convert device allocation to managed devm_kzalloc()
  mtd: at91: atmel_nand: for PMECC, add code to check the ONFI parameter ECC requirement.
  mtd: atmel_nand: make pmecc-cap, pmecc-sector-size in dts is optional.
  mtd: atmel_nand: avoid to report an error when lookup table offset is 0.
  mtd: bcm47xxsflash: adjust names of bus-specific functions
  mtd: bcm47xxpart: improve probing of nvram partition
  mtd: bcm47xxpart: add support for other erase sizes
  mtd: bcm47xxnflash: register this as normal driver
  mtd: bcm47xxnflash: fix message
  mtd: bcm47xxsflash: register this as normal driver
  mtd: bcm47xxsflash: write number of written bytes
  mtd: gpmi: add sanity check for the ECC
  mtd: gpmi: set the Golois Field bit for mx6q's BCH
  mtd: devices: elm: Removes <xx> literals in elm DT node
  mtd: gpmi: fix a dereferencing freed memory error
  mtd: fix the wrong timeo for panic_nand_wait()
  ...

Documentation/devicetree/bindings/mtd/elm.txt

@@ -0,0 +1,16 @@
+Error location module
+
+Required properties:
+- compatible: Must be "ti,am33xx-elm"
+- reg: physical base address and size of the registers map.
+- interrupts: Interrupt number for the elm.
+
+Optional properties:
+- ti,hwmods: Name of the hwmod associated to the elm
+
+Example:
+elm: elm@0 {
+	compatible = "ti,am3352-elm";
+	reg = <0x48080000 0x2000>;
+	interrupts = <4>;
+};

Documentation/devicetree/bindings/mtd/mtd-physmap.txt

@@ -26,6 +26,9 @@ file systems on embedded devices.
  - linux,mtd-name: allow to specify the mtd name for retro capability with
    physmap-flash drivers as boot loader pass the mtd partition via the old
    device name physmap-flash.
+ - use-advanced-sector-protection: boolean to enable support for the
+   advanced sector protection (Spansion: PPB - Persistent Protection
+   Bits) locking.
 
 For JEDEC compatible devices, the following additional properties
 are defined: