Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

Conflicts:
	drivers/net/ethernet/cadence/macb.c

Overlapping changes in macb driver, mostly fixes and cleanups
in 'net' overlapping with the integration of at91_ether into
macb in 'net-next'.

Signed-off-by: David S. Miller <davem@davemloft.net>

Documentation/devicetree/bindings/i2c/i2c-imx.txt

@@ -7,6 +7,7 @@ Required properties:
   - "fsl,vf610-i2c" for I2C compatible with the one integrated on Vybrid vf610 SoC
 - reg : Should contain I2C/HS-I2C registers location and length
 - interrupts : Should contain I2C/HS-I2C interrupt
+- clocks : Should contain the I2C/HS-I2C clock specifier
 
 Optional properties:
 - clock-frequency : Constains desired I2C/HS-I2C bus clock frequency in Hz.

Documentation/devicetree/bindings/net/apm-xgene-enet.txt

@@ -4,7 +4,10 @@ Ethernet nodes are defined to describe on-chip ethernet interfaces in
 APM X-Gene SoC.
 
 Required properties for all the ethernet interfaces:
-- compatible: Should be "apm,xgene-enet"
+- compatible: Should state binding information from the following list,
+  - "apm,xgene-enet":    RGMII based 1G interface
+  - "apm,xgene1-sgenet": SGMII based 1G interface
+  - "apm,xgene1-xgenet": XFI based 10G interface
 - reg: Address and length of the register set for the device. It contains the
   information of registers in the same order as described by reg-names
 - reg-names: Should contain the register set names

Documentation/devicetree/bindings/serial/snps-dw-apb-uart.txt

@@ -21,6 +21,18 @@ Optional properties:
 - reg-io-width : the size (in bytes) of the IO accesses that should be
   performed on the device.  If this property is not present then single byte
   accesses are used.
+- dcd-override : Override the DCD modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- dsr-override : Override the DTS modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- cts-override : Override the CTS modem status signal. This signal will always
+  be reported as active instead of being obtained from the modem status
+  register. Define this if your serial port does not use this pin.
+- ri-override : Override the RI modem status signal. This signal will always be
+  reported as inactive instead of being obtained from the modem status register.
+  Define this if your serial port does not use this pin.
 
 Example:
 
@@ -31,6 +43,10 @@ Example:
 		interrupts = <10>;
 		reg-shift = <2>;
 		reg-io-width = <4>;
+		dcd-override;
+		dsr-override;
+		cts-override;
+		ri-override;
 	};
 
 Example with one clock: