Merge tag 'for-linus-20161008' of git://git.infradead.org/linux-mtd

Pull MTD updates from Brian Norris:
 "I've not been very active this cycle, so these are mostly from Boris,
  for the NAND flash subsystem.

  NAND:

   - Add the infrastructure to automate NAND timings configuration

   - Provide a generic DT property to maximize ECC strength

   - Some refactoring in the core bad block table handling, to help with
     improving some of the logic in error cases.

   - Minor cleanups and fixes

  MTD:

   - Add APIs for handling page pairing; this is necessary for reliably
     supporting MLC and TLC NAND flash, where paired-page disturbance
     affects reliability. Upper layers (e.g., UBI) should make use of
     these in the near future"

* tag 'for-linus-20161008' of git://git.infradead.org/linux-mtd: (35 commits)
  mtd: nand: fix trivial spelling error
  mtdpart: Propagate _get/put_device()
  mtd: nand: Provide nand_cleanup() function to free NAND related resources
  mtd: Kill the OF_MTD Kconfig option
  mtd: nand: mxc: Test CONFIG_OF instead of CONFIG_OF_MTD
  mtd: nand: Fix nand_command_lp() for 8bits opcodes
  mtd: nand: sunxi: Support ECC maximization
  mtd: nand: Support maximizing ECC when using software BCH
  mtd: nand: Add an option to maximize the ECC strength
  mtd: nand: mxc: Add timing setup for v2 controllers
  mtd: nand: mxc: implement onfi get/set features
  mtd: nand: sunxi: switch from manual to automated timing config
  mtd: nand: automate NAND timings selection
  mtd: nand: Expose data interface for ONFI mode 0
  mtd: nand: Add function to convert ONFI mode to data_interface
  mtd: nand: convert ONFI mode into data interface
  mtd: nand: Introduce nand_data_interface
  mtd: nand: Create a NAND reset function
  mtd: nand: remove unnecessary 'extern' from function declarations
  MAINTAINERS: Add maintainer entry for Ingenic JZ4780 NAND driver
  ...

Documentation/devicetree/bindings/mtd/nand.txt

@@ -35,6 +35,15 @@ Optional NAND chip properties:
 - nand-ecc-step-size: integer representing the number of data bytes
 		      that are covered by a single ECC step.
 
+- nand-ecc-maximize: boolean used to specify that you want to maximize ECC
+		     strength. The maximum ECC strength is both controller and
+		     chip dependent. The controller side has to select the ECC
+		     config providing the best strength and taking the OOB area
+		     size constraint into account.
+		     This is particularly useful when only the in-band area is
+		     used by the upper layers, and you want to make your NAND
+		     as reliable as possible.
+
 The ECC strength and ECC step size properties define the correction capability
 of a controller. Together, they say a controller can correct "{strength} bit
 errors per {size} bytes".