i2c: busses: make use of i2c_8bit_addr_from_msg

Because it looks neater.

For diolan, this allows factoring out some code that is now common
between if and else.

For eg20t, pch_i2c_writebytes is always called with a write in
msgs->flags, and pch_i2c_readbytes with a read.

For imx, i2c_imx_dma_write and i2c_imx_write are always called with a
write in msgs->flags, and i2c_imx_read with a read.

For qup, qup_i2c_write_tx_fifo_v1 is always called with a write in
qup->msg->flags.

For stu300, also restructure debug output for resends, since that
code as a result is only handling debug output.

Reviewed-by: Guenter Roeck <linux@roeck-us.net> [diolan]
Acked-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> [efm32 and imx]
Acked-by: Linus Walleij <linus.walleij@linaro.org> [stu300]
Signed-off-by: Peter Rosin <peda@axentia.se>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-aspeed.c

@@ -335,13 +335,12 @@ static void aspeed_i2c_do_start(struct aspeed_i2c_bus *bus)
 {
 	u32 command = ASPEED_I2CD_M_START_CMD | ASPEED_I2CD_M_TX_CMD;
 	struct i2c_msg *msg = &bus->msgs[bus->msgs_index];
-	u8 slave_addr = msg->addr << 1;
+	u8 slave_addr = i2c_8bit_addr_from_msg(msg);
 
 	bus->master_state = ASPEED_I2C_MASTER_START;
 	bus->buf_index = 0;
 
 	if (msg->flags & I2C_M_RD) {
-		slave_addr |= 1;
 		command |= ASPEED_I2CD_M_RX_CMD;
 		/* Need to let the hardware know to NACK after RX. */
 		if (msg->len == 1 && !(msg->flags & I2C_M_RECV_LEN))