spelling fixes: arch/i386/

Spelling fixes in arch/i386/.

Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
Signed-off-by: Adrian Bunk <bunk@kernel.org>

arch/x86/kernel/cpu/amd.c

@@ -266,7 +266,7 @@ static void __cpuinit init_amd(struct cpuinfo_x86 *c)
 #ifdef CONFIG_X86_HT
 	/*
 	 * On a AMD multi core setup the lower bits of the APIC id
-	 * distingush the cores.
+	 * distinguish the cores.
 	 */
 	if (c->x86_max_cores > 1) {
 		int cpu = smp_processor_id();

arch/x86/kernel/cpu/centaur.c

@@ -53,7 +53,7 @@ static u32 __cpuinit ramtop(void)		/* 16388 */
 			continue;
 		/*
 		 *	Don't MCR over reserved space. Ignore the ISA hole
-		 *	we frob around that catastrophy already
+		 *	we frob around that catastrophe already
 		 */
 		 			
 		if (e820.map[i].type == E820_RESERVED)
@@ -287,7 +287,7 @@ static void __cpuinit init_c3(struct cpuinfo_x86 *c)
 		c->x86_capability[5] = cpuid_edx(0xC0000001);
 	}
 
-	/* Cyrix III family needs CX8 & PGE explicity enabled. */
+	/* Cyrix III family needs CX8 & PGE explicitly enabled. */
 	if (c->x86_model >=6 && c->x86_model <= 9) {
 		rdmsr (MSR_VIA_FCR, lo, hi);
 		lo |= (1<<1 | 1<<7);

arch/x86/kernel/cpu/common.c

@@ -207,7 +207,7 @@ static void __cpuinit get_cpu_vendor(struct cpuinfo_x86 *c, int early)
 
 static int __init x86_fxsr_setup(char * s)
 {
-	/* Tell all the other CPU's to not use it... */
+	/* Tell all the other CPUs to not use it... */
 	disable_x86_fxsr = 1;
 
 	/*

arch/x86/kernel/cpu/cpufreq/cpufreq-nforce2.c

@@ -260,7 +260,7 @@ static int nforce2_target(struct cpufreq_policy *policy,
 
 	freqs.old = nforce2_get(policy->cpu);
 	freqs.new = target_fsb * fid * 100;
-	freqs.cpu = 0;		/* Only one CPU on nForce2 plattforms */
+	freqs.cpu = 0;		/* Only one CPU on nForce2 platforms */
 
 	if (freqs.old == freqs.new)
 		return 0;

arch/x86/kernel/cpu/cpufreq/gx-suspmod.c

@@ -12,12 +12,12 @@
  *      of any nature resulting due to the use of this software. This
  *      software is provided AS-IS with no warranties.
  *
- * Theoritical note:
+ * Theoretical note:
  *
  *	(see Geode(tm) CS5530 manual (rev.4.1) page.56)
  *
  *	CPU frequency control on NatSemi Geode GX1/GXLV processor and CS55x0
- *	are based on Suspend Moduration.
+ *	are based on Suspend Modulation.
  *
  *	Suspend Modulation works by asserting and de-asserting the SUSP# pin
  *	to CPU(GX1/GXLV) for configurable durations. When asserting SUSP#
@@ -101,11 +101,11 @@
 
 /* SUSCFG bits */
 #define SUSMOD		(1<<0)	/* enable/disable suspend modulation */
-/* the belows support only with cs5530 (after rev.1.2)/cs5530A */
+/* the below is supported only with cs5530 (after rev.1.2)/cs5530A */
 #define SMISPDUP	(1<<1)	/* select how SMI re-enable suspend modulation: */
 				/* IRQTC timer or read SMI speedup disable reg.(F1BAR[08-09h]) */
 #define SUSCFG		(1<<2)	/* enable powering down a GXLV processor. "Special 3Volt Suspend" mode */
-/* the belows support only with cs5530A */
+/* the below is supported only with cs5530A */
 #define PWRSVE_ISA	(1<<3)	/* stop ISA clock  */
 #define PWRSVE		(1<<4)	/* active idle */
 

arch/x86/kernel/cpu/cpufreq/powernow-k8.c

@@ -168,7 +168,7 @@ static void count_off_irt(struct powernow_k8_data *data)
 	return;
 }
 
-/* the voltage stabalization time */
+/* the voltage stabilization time */
 static void count_off_vst(struct powernow_k8_data *data)
 {
 	udelay(data->vstable * VST_UNITS_20US);

arch/x86/kernel/cpu/cpufreq/powernow-k8.h

@@ -148,10 +148,10 @@ struct powernow_k8_data {
 #define PLL_LOCK_CONVERSION (1000/5) /* ms to ns, then divide by clock period */
 
 #define MAXIMUM_VID_STEPS 1  /* Current cpus only allow a single step of 25mV */
-#define VST_UNITS_20US 20   /* Voltage Stabalization Time is in units of 20us */
+#define VST_UNITS_20US 20   /* Voltage Stabilization Time is in units of 20us */
 
 /*
- * Most values of interest are enocoded in a single field of the _PSS
+ * Most values of interest are encoded in a single field of the _PSS
  * entries: the "control" value.
  */
 

arch/x86/kernel/cpu/cyrix.c

@@ -256,7 +256,7 @@ static void __cpuinit init_cyrix(struct cpuinfo_x86 *c)
 		u32 vendor, device;
 		/* It isn't really a PCI quirk directly, but the cure is the
 		   same. The MediaGX has deep magic SMM stuff that handles the
-		   SB emulation. It thows away the fifo on disable_dma() which
+		   SB emulation. It throws away the fifo on disable_dma() which
 		   is wrong and ruins the audio. 
 
 		   Bug2: VSA1 has a wrap bug so that using maximum sized DMA 

arch/x86/kernel/cpu/mtrr/cyrix.c

@@ -147,10 +147,10 @@ static void prepare_set(void)
 	write_cr0(cr0);
 	wbinvd();
 
-	/* Cyrix ARRs - everything else were excluded at the top */
+	/* Cyrix ARRs - everything else was excluded at the top */
 	ccr3 = getCx86(CX86_CCR3);
 
-	/* Cyrix ARRs - everything else were excluded at the top */
+	/* Cyrix ARRs - everything else was excluded at the top */
 	setCx86(CX86_CCR3, (ccr3 & 0x0f) | 0x10);
 
 }

arch/x86/kernel/cpu/mtrr/generic.c

@@ -182,7 +182,7 @@ static inline void k8_enable_fixed_iorrs(void)
 
 /**
  * Checks and updates an fixed-range MTRR if it differs from the value it
- * should have. If K8 extenstions are wanted, update the K8 SYSCFG MSR also.
+ * should have. If K8 extentions are wanted, update the K8 SYSCFG MSR also.
  * see AMD publication no. 24593, chapter 7.8.1, page 233 for more information
  * \param msr MSR address of the MTTR which should be checked and updated
  * \param changed pointer which indicates whether the MTRR needed to be changed

arch/x86/kernel/cpu/mtrr/main.c

@@ -748,7 +748,7 @@ static int __init mtrr_init_finialize(void)
 	if (use_intel())
 		mtrr_state_warn();
 	else {
-		/* The CPUs haven't MTRR and seemes not support SMP. They have
+		/* The CPUs haven't MTRR and seem to not support SMP. They have
 		 * specific drivers, we use a tricky method to support
 		 * suspend/resume for them.
 		 * TBD: is there any system with such CPU which supports