Merge branch 'for-3.18-consistent-ops' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/percpu

Pull percpu consistent-ops changes from Tejun Heo:
 "Way back, before the current percpu allocator was implemented, static
  and dynamic percpu memory areas were allocated and handled separately
  and had their own accessors.  The distinction has been gone for many
  years now; however, the now duplicate two sets of accessors remained
  with the pointer based ones - this_cpu_*() - evolving various other
  operations over time.  During the process, we also accumulated other
  inconsistent operations.

  This pull request contains Christoph's patches to clean up the
  duplicate accessor situation.  __get_cpu_var() uses are replaced with
  with this_cpu_ptr() and __this_cpu_ptr() with raw_cpu_ptr().

  Unfortunately, the former sometimes is tricky thanks to C being a bit
  messy with the distinction between lvalues and pointers, which led to
  a rather ugly solution for cpumask_var_t involving the introduction of
  this_cpu_cpumask_var_ptr().

  This converts most of the uses but not all.  Christoph will follow up
  with the remaining conversions in this merge window and hopefully
  remove the obsolete accessors"

* 'for-3.18-consistent-ops' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/percpu: (38 commits)
  irqchip: Properly fetch the per cpu offset
  percpu: Resolve ambiguities in __get_cpu_var/cpumask_var_t -fix
  ia64: sn_nodepda cannot be assigned to after this_cpu conversion. Use __this_cpu_write.
  percpu: Resolve ambiguities in __get_cpu_var/cpumask_var_t
  Revert "powerpc: Replace __get_cpu_var uses"
  percpu: Remove __this_cpu_ptr
  clocksource: Replace __this_cpu_ptr with raw_cpu_ptr
  sparc: Replace __get_cpu_var uses
  avr32: Replace __get_cpu_var with __this_cpu_write
  blackfin: Replace __get_cpu_var uses
  tile: Use this_cpu_ptr() for hardware counters
  tile: Replace __get_cpu_var uses
  powerpc: Replace __get_cpu_var uses
  alpha: Replace __get_cpu_var
  ia64: Replace __get_cpu_var uses
  s390: cio driver &__get_cpu_var replacements
  s390: Replace __get_cpu_var uses
  mips: Replace __get_cpu_var uses
  MIPS: Replace __get_cpu_var uses in FPU emulator.
  arm: Replace __this_cpu_ptr with raw_cpu_ptr
  ...

drivers/clocksource/dummy_timer.c

@@ -28,7 +28,7 @@ static void dummy_timer_set_mode(enum clock_event_mode mode,
 static void dummy_timer_setup(void)
 {
 	int cpu = smp_processor_id();
-	struct clock_event_device *evt = __this_cpu_ptr(&dummy_timer_evt);
+	struct clock_event_device *evt = raw_cpu_ptr(&dummy_timer_evt);
 
 	evt->name	= "dummy_timer";
 	evt->features	= CLOCK_EVT_FEAT_PERIODIC |

drivers/clocksource/metag_generic.c

@@ -90,7 +90,7 @@ static struct clocksource clocksource_metag = {
 
 static irqreturn_t metag_timer_interrupt(int irq, void *dummy)
 {
-	struct clock_event_device *evt = &__get_cpu_var(local_clockevent);
+	struct clock_event_device *evt = this_cpu_ptr(&local_clockevent);
 
 	evt->event_handler(evt);
 

drivers/clocksource/qcom-timer.c

@@ -219,7 +219,7 @@ static void __init msm_timer_init(u32 dgt_hz, int sched_bits, int irq,
 		}
 
 		/* Immediately configure the timer on the boot CPU */
-		msm_local_timer_setup(__this_cpu_ptr(msm_evt));
+		msm_local_timer_setup(raw_cpu_ptr(msm_evt));
 	}
 
 err: