| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455565758596061626364656667686970717273747576 |
- What: /sys/class/net/<iface>/qmi/raw_ip
- Date: Dec 2015
- KernelVersion: 4.4
- Contact: Bjørn Mork <[email protected]>
- Description:
- Boolean. Default: 'N'
- Set this to 'Y' to change the network device link
- framing from '802.3' to 'raw-ip'.
- The netdev will change to reflect the link framing
- mode. The netdev is an ordinary ethernet device in
- '802.3' mode, and the driver expects to exchange
- frames with an ethernet header over the USB link. The
- netdev is a headerless p-t-p device in 'raw-ip' mode,
- and the driver expects to echange IPv4 or IPv6 packets
- without any L2 header over the USB link.
- Userspace is in full control of firmware configuration
- through the delegation of the QMI protocol. Userspace
- is responsible for coordination of driver and firmware
- link framing mode, changing this setting to 'Y' if the
- firmware is configured for 'raw-ip' mode.
- What: /sys/class/net/<iface>/qmi/add_mux
- Date: March 2017
- KernelVersion: 4.11
- Contact: Bjørn Mork <[email protected]>
- Description:
- Unsigned integer.
- Write a number ranging from 1 to 254 to add a qmap mux
- based network device, supported by recent Qualcomm based
- modems.
- The network device will be called qmimux.
- Userspace is in charge of managing the qmux network device
- activation and data stream setup on the modem side by
- using the proper QMI protocol requests.
- What: /sys/class/net/<iface>/qmi/del_mux
- Date: March 2017
- KernelVersion: 4.11
- Contact: Bjørn Mork <[email protected]>
- Description:
- Unsigned integer.
- Write a number ranging from 1 to 254 to delete a previously
- created qmap mux based network device.
- What: /sys/class/net/<qmimux iface>/qmap/mux_id
- Date: January 2021
- KernelVersion: 5.12
- Contact: Daniele Palmas <[email protected]>
- Description:
- Unsigned integer
- Indicates the mux id associated to the qmimux network interface
- during its creation.
- What: /sys/class/net/<iface>/qmi/pass_through
- Date: January 2021
- KernelVersion: 5.12
- Contact: Subash Abhinov Kasiviswanathan <[email protected]>
- Description:
- Boolean. Default: 'N'
- Set this to 'Y' to enable 'pass-through' mode, allowing packets
- in MAP format to be passed on to the stack.
- Normally the rmnet driver (CONFIG_RMNET) is then used to process
- and demultiplex these packets.
- 'Pass-through' mode can be enabled when the device is in
- 'raw-ip' mode only.
|
