In ASYNC wait mode, next command kickoff can happen before previous command ISR execution is
completed in below sequence:
ASYNC command A -> triggered
dsi_ctrl_isr for command A -> fired and executed atomic_set(&dsi_ctrl->dma_irq_trig, 1);
wait_for_done for command A -> returns early as dsi_ctrl->dma_irq_trig is 1
ASYNC Command B -> triggered
wait_for_done for command B -> waiting for cmd_dma_done
dsi_ctrl_isr for command A -> executes complete_all(&dsi_ctrl->irq_info.cmd_dma_done);
wait_for_done for command B -> returns success incorrectly based on complete_all of previous
command isr and disable_status_interrupt() is not called.
This leads to refcount of dma_done going wrong and dsi_ctrl_isr is not enabled on suspend resume.
To fix this issue, mark command transfer successful only based on complete_all(cmd_dma_done). This
way disable_status_interrupt() will be always called either from dsi_ctrl_isr or wait_for_done().
Change-Id: I0379ea7ff82a1e077b95f6996d11d1722de00936
Signed-off-by: Ritesh Kumar <riteshk@codeaurora.org>
f2499b50d8