sde_hw_intf.h 8.1 KB

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198199200201202203204205206207208209210211212213214215216217218219220221222223224225226227228229230231232233234235236237238239240241242243244245246247248249250251252253254255256257258259260261262263264265266267268269270271272273274275276277278279280281282283284285286287288289290291292293294295296297298299
  1. /* SPDX-License-Identifier: GPL-2.0-only */
  2. /*
  3. * Copyright (c) 2021-2022 Qualcomm Innovation Center, Inc. All rights reserved.
  4. * Copyright (c) 2015-2021, The Linux Foundation. All rights reserved.
  5. */
  6. #ifndef _SDE_HW_INTF_H
  7. #define _SDE_HW_INTF_H
  8. #include "sde_hw_catalog.h"
  9. #include "sde_hw_mdss.h"
  10. #include "sde_hw_util.h"
  11. #include "sde_kms.h"
  12. struct sde_hw_intf;
  13. /* intf timing settings */
  14. struct intf_timing_params {
  15. u32 width; /* active width */
  16. u32 height; /* active height */
  17. u32 xres; /* Display panel width */
  18. u32 yres; /* Display panel height */
  19. u32 h_back_porch;
  20. u32 h_front_porch;
  21. u32 v_back_porch;
  22. u32 v_front_porch;
  23. u32 hsync_pulse_width;
  24. u32 vsync_pulse_width;
  25. u32 hsync_polarity;
  26. u32 vsync_polarity;
  27. u32 border_clr;
  28. u32 underflow_clr;
  29. u32 hsync_skew;
  30. u32 v_front_porch_fixed;
  31. bool wide_bus_en;
  32. bool compression_en;
  33. u32 extra_dto_cycles; /* for DP only */
  34. bool dsc_4hs_merge; /* DSC 4HS merge */
  35. bool poms_align_vsync; /* poms with vsync aligned */
  36. u32 dce_bytes_per_line;
  37. u32 vrefresh;
  38. };
  39. struct intf_prog_fetch {
  40. u8 enable;
  41. /* vsync counter for the front porch pixel line */
  42. u32 fetch_start;
  43. };
  44. struct intf_status {
  45. u8 is_en; /* interface timing engine is enabled or not */
  46. bool is_prog_fetch_en; /* interface prog fetch counter is enabled or not */
  47. u32 frame_count; /* frame count since timing engine enabled */
  48. u32 line_count; /* current line count including blanking */
  49. };
  50. struct intf_tear_status {
  51. u32 read_count; /* frame & line count for tear init value */
  52. u32 write_count; /* frame & line count for tear write */
  53. };
  54. struct intf_avr_params {
  55. u32 default_fps;
  56. u32 min_fps;
  57. u32 avr_mode; /* one of enum @sde_rm_qsync_modes */
  58. u32 avr_step_lines; /* 0 or 1 means disabled */
  59. };
  60. /**
  61. * struct intf_wd_jitter_params : Interface to the INTF WD Jitter params.
  62. * jitter : max instantaneous jitter.
  63. * ltj_max : max long term jitter value.
  64. * ltj_slope : slope of long term jitter.
  65. */
  66. struct intf_wd_jitter_params {
  67. u32 jitter;
  68. u32 ltj_max;
  69. u32 ltj_slope;
  70. };
  71. /**
  72. * struct sde_hw_intf_ops : Interface to the interface Hw driver functions
  73. * Assumption is these functions will be called after clocks are enabled
  74. * @ setup_timing_gen : programs the timing engine
  75. * @ setup_prog_fetch : enables/disables the programmable fetch logic
  76. * @ setup_rot_start : enables/disables the rotator start trigger
  77. * @ enable_timing: enable/disable timing engine
  78. * @ get_status: returns if timing engine is enabled or not
  79. * @ setup_misr: enables/disables MISR in HW register
  80. * @ collect_misr: reads and stores MISR data from HW register
  81. * @ get_line_count: reads current vertical line counter
  82. * @ get_underrun_line_count: reads current underrun pixel clock count and
  83. * converts it into line count
  84. * @setup_vsync_source: Configure vsync source selection for intf
  85. * @configure_wd_jitter: Configure WD jitter.
  86. * @bind_pingpong_blk: enable/disable the connection with pingpong which will
  87. * feed pixels to this interface
  88. */
  89. struct sde_hw_intf_ops {
  90. void (*setup_timing_gen)(struct sde_hw_intf *intf,
  91. const struct intf_timing_params *p,
  92. const struct sde_format *fmt);
  93. void (*setup_prg_fetch)(struct sde_hw_intf *intf,
  94. const struct intf_prog_fetch *fetch);
  95. void (*setup_rot_start)(struct sde_hw_intf *intf,
  96. const struct intf_prog_fetch *fetch);
  97. void (*enable_timing)(struct sde_hw_intf *intf,
  98. u8 enable);
  99. void (*get_status)(struct sde_hw_intf *intf,
  100. struct intf_status *status);
  101. void (*setup_misr)(struct sde_hw_intf *intf,
  102. bool enable, u32 frame_count);
  103. int (*collect_misr)(struct sde_hw_intf *intf,
  104. bool nonblock, u32 *misr_value);
  105. /**
  106. * returns the current scan line count of the display
  107. * video mode panels use get_line_count whereas get_vsync_info
  108. * is used for command mode panels
  109. */
  110. u32 (*get_line_count)(struct sde_hw_intf *intf);
  111. u32 (*get_underrun_line_count)(struct sde_hw_intf *intf);
  112. void (*setup_vsync_source)(struct sde_hw_intf *intf, u32 frame_rate);
  113. void (*configure_wd_jitter)(struct sde_hw_intf *intf,
  114. struct intf_wd_jitter_params *wd_jitter);
  115. void (*bind_pingpong_blk)(struct sde_hw_intf *intf,
  116. bool enable,
  117. const enum sde_pingpong pp);
  118. /**
  119. * enables vysnc generation and sets up init value of
  120. * read pointer and programs the tear check cofiguration
  121. */
  122. int (*setup_tearcheck)(struct sde_hw_intf *intf,
  123. struct sde_hw_tear_check *cfg);
  124. /**
  125. * enables tear check block
  126. */
  127. int (*enable_tearcheck)(struct sde_hw_intf *intf,
  128. bool enable);
  129. /**
  130. * updates tearcheck configuration
  131. */
  132. void (*update_tearcheck)(struct sde_hw_intf *intf,
  133. struct sde_hw_tear_check *cfg);
  134. /**
  135. * read, modify, write to either set or clear listening to external TE
  136. * @Return: 1 if TE was originally connected, 0 if not, or -ERROR
  137. */
  138. int (*connect_external_te)(struct sde_hw_intf *intf,
  139. bool enable_external_te);
  140. /**
  141. * provides the programmed and current
  142. * line_count
  143. */
  144. int (*get_vsync_info)(struct sde_hw_intf *intf,
  145. struct sde_hw_pp_vsync_info *info);
  146. /**
  147. * configure and enable the autorefresh config
  148. */
  149. int (*setup_autorefresh)(struct sde_hw_intf *intf,
  150. struct sde_hw_autorefresh *cfg);
  151. /**
  152. * retrieve autorefresh config from hardware
  153. */
  154. int (*get_autorefresh)(struct sde_hw_intf *intf,
  155. struct sde_hw_autorefresh *cfg);
  156. /**
  157. * poll until write pointer transmission starts
  158. * @Return: 0 on success, -ETIMEDOUT on timeout
  159. */
  160. int (*poll_timeout_wr_ptr)(struct sde_hw_intf *intf, u32 timeout_us);
  161. /**
  162. * Select vsync signal for tear-effect configuration
  163. */
  164. void (*vsync_sel)(struct sde_hw_intf *intf, u32 vsync_source);
  165. /**
  166. * Program the AVR_TOTAL for min fps rate
  167. */
  168. int (*avr_setup)(struct sde_hw_intf *intf,
  169. const struct intf_timing_params *params,
  170. const struct intf_avr_params *avr_params);
  171. /**
  172. * Signal the trigger on each commit for AVR
  173. */
  174. void (*avr_trigger)(struct sde_hw_intf *ctx);
  175. /**
  176. * Enable AVR and select the mode
  177. */
  178. void (*avr_ctrl)(struct sde_hw_intf *intf,
  179. const struct intf_avr_params *avr_params);
  180. /**
  181. * Indicates the AVR armed status
  182. *
  183. * @return: false if a trigger is pending, else true while AVR is enabled
  184. */
  185. u32 (*get_avr_status)(struct sde_hw_intf *intf);
  186. /**
  187. * Enable/disable 64 bit compressed data input to interface block
  188. */
  189. void (*enable_compressed_input)(struct sde_hw_intf *intf,
  190. bool compression_en, bool dsc_4hs_merge);
  191. /**
  192. * Check the intf tear check status and reset it to start_pos
  193. */
  194. int (*check_and_reset_tearcheck)(struct sde_hw_intf *intf,
  195. struct intf_tear_status *status);
  196. /**
  197. * Reset the interface frame & line counter
  198. */
  199. void (*reset_counter)(struct sde_hw_intf *intf);
  200. /**
  201. * Get the HW vsync timestamp counter
  202. */
  203. u64 (*get_vsync_timestamp)(struct sde_hw_intf *intf, bool is_vid);
  204. /**
  205. * Enable processing of 2 pixels per clock
  206. */
  207. void (*enable_wide_bus)(struct sde_hw_intf *intf, bool enable);
  208. /**
  209. * Get the INTF interrupt status
  210. */
  211. u32 (*get_intr_status)(struct sde_hw_intf *intf);
  212. /**
  213. * Override tear check rd_ptr_val with adjusted_linecnt
  214. * when qsync is enabled.
  215. */
  216. void (*override_tear_rd_ptr_val)(struct sde_hw_intf *intf,
  217. u32 adjusted_linecnt);
  218. };
  219. struct sde_hw_intf {
  220. struct sde_hw_blk_reg_map hw;
  221. /* intf */
  222. enum sde_intf idx;
  223. const struct sde_intf_cfg *cap;
  224. const struct sde_mdss_cfg *mdss;
  225. struct split_pipe_cfg cfg;
  226. /* ops */
  227. struct sde_hw_intf_ops ops;
  228. };
  229. /**
  230. * to_sde_hw_intf - convert base hw object to sde_hw_intf container
  231. * @hw: Pointer to hardware block register map object
  232. * return: Pointer to hardware block container
  233. */
  234. static inline struct sde_hw_intf *to_sde_hw_intf(struct sde_hw_blk_reg_map *hw)
  235. {
  236. return container_of(hw, struct sde_hw_intf, hw);
  237. }
  238. /**
  239. * sde_hw_intf_init(): Initializes the intf driver for the passed
  240. * interface idx.
  241. * @idx: interface index for which driver object is required
  242. * @addr: mapped register io address of MDP
  243. * @m : pointer to mdss catalog data
  244. */
  245. struct sde_hw_blk_reg_map *sde_hw_intf_init(enum sde_intf idx,
  246. void __iomem *addr,
  247. struct sde_mdss_cfg *m);
  248. /**
  249. * sde_hw_intf_destroy(): Destroys INTF driver context
  250. * @hw: Pointer to hardware block register map object
  251. */
  252. void sde_hw_intf_destroy(struct sde_hw_blk_reg_map *hw);
  253. #endif /*_SDE_HW_INTF_H */