ファイル
android_kernel_samsung_sm86…/msm/dp/dp_debug.h
Aravind Venkateswaran 7454e06259 disp: msm: dp: improve interop experience for fast hotplug scenarios
Current implementation waits for 10ms prior to sending the connection
notification to user mode. This delay is to check for any potential
IRQ HPD event from the sink which may require a link maintenance.
However, this delay may not be sufficient for certain use cases.
Increase this delay to 150ms and modify the implementation to exit
the wait whenever an IRQ HPD is received. This ensures that we can
process the IRQ HPD in a timely manner as per the specification. To
further improve debug ability, add the support to configure this delay
though debugfs:

   echo [delay_ms] > /sys/kernel/debug/drm_dp/connect_notification_delay_ms

Certain cables are unable to handle back-to-back HPD notifications and
may end up skipping some events. To improve interoperability, delay the
handling of disconnect notification. Sinks would typically issue an HPD
high following an HPD low only after they sense that the mainlink has
been torn down. Delaying the handling of HPD low would in turn delay the
issuing of the subsequent HPD high from the sink. Here again, make this
delay configurable through debugfs to improve debug ability of these
interop issues:

   echo [delay_ms] > /sys/kernel/debug/drm_dp/disconnect_delay_ms

Change-Id: Ie29198af4dcda6d392798a3a93ebb3ddaa6746c8
Signed-off-by: Aravind Venkateswaran <aravindh@codeaurora.org>
2020-10-05 15:05:48 -07:00

152 行
5.1 KiB
C

/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Copyright (c) 2017-2020, The Linux Foundation. All rights reserved.
*/
#ifndef _DP_DEBUG_H_
#define _DP_DEBUG_H_
#include "dp_panel.h"
#include "dp_ctrl.h"
#include "dp_link.h"
#include "dp_aux.h"
#include "dp_display.h"
#include "dp_pll.h"
#define DP_DEBUG(fmt, ...) \
do { \
if (unlikely(drm_debug & DRM_UT_KMS)) \
DRM_DEBUG("[msm-dp-debug][%-4d]"fmt, current->pid, \
##__VA_ARGS__); \
else \
pr_debug("[drm:%s][msm-dp-debug][%-4d]"fmt, __func__,\
current->pid, ##__VA_ARGS__); \
} while (0)
#define DP_INFO(fmt, ...) \
do { \
if (unlikely(drm_debug & DRM_UT_KMS)) \
DRM_INFO("[msm-dp-info][%-4d]"fmt, current->pid, \
##__VA_ARGS__); \
else \
pr_info("[drm:%s][msm-dp-info][%-4d]"fmt, __func__, \
current->pid, ##__VA_ARGS__); \
} while (0)
#define DP_WARN(fmt, ...) \
pr_warn("[drm:%s][msm-dp-warn][%-4d]"fmt, __func__, \
current->pid, ##__VA_ARGS__)
#define DP_ERR(fmt, ...) \
pr_err("[drm:%s][msm-dp-err][%-4d]"fmt, __func__, \
current->pid, ##__VA_ARGS__)
#define DEFAULT_DISCONNECT_DELAY_MS 0
#define MAX_DISCONNECT_DELAY_MS 10000
#define DEFAULT_CONNECT_NOTIFICATION_DELAY_MS 150
#define MAX_CONNECT_NOTIFICATION_DELAY_MS 5000
/**
* struct dp_debug
* @debug_en: specifies whether debug mode enabled
* @sim_mode: specifies whether sim mode enabled
* @psm_enabled: specifies whether psm enabled
* @hdcp_disabled: specifies if hdcp is disabled
* @hdcp_wait_sink_sync: used to wait for sink synchronization before HDCP auth
* @aspect_ratio: used to filter out aspect_ratio value
* @vdisplay: used to filter out vdisplay value
* @hdisplay: used to filter out hdisplay value
* @vrefresh: used to filter out vrefresh value
* @tpg_state: specifies whether tpg feature is enabled
* @max_pclk_khz: max pclk supported
* @force_encryption: enable/disable forced encryption for HDCP 2.2
* @skip_uevent: skip hotplug uevent to the user space
* @hdcp_status: string holding hdcp status information
* @dp_mst_connector_list: list containing all dp mst connectors
* @mst_hpd_sim: specifies whether simulated hpd enabled
* @mst_sim_add_con: specifies whether new sim connector is to be added
* @mst_sim_remove_con: specifies whether sim connector is to be removed
* @mst_sim_remove_con_id: specifies id of sim connector to be removed
* @mst_port_cnt: number of mst ports to be added during hpd
* @connect_notification_delay_ms: time (in ms) to wait for any attention
* messages before sending the connect notification uevent
* @disconnect_delay_ms: time (in ms) to wait before turning off the mainlink
* in response to HPD low of cable disconnect event
*/
struct dp_debug {
bool debug_en;
bool sim_mode;
bool psm_enabled;
bool hdcp_disabled;
bool hdcp_wait_sink_sync;
int aspect_ratio;
int vdisplay;
int hdisplay;
int vrefresh;
bool tpg_state;
u32 max_pclk_khz;
bool force_encryption;
bool skip_uevent;
char hdcp_status[SZ_128];
struct dp_mst_connector dp_mst_connector_list;
bool mst_hpd_sim;
bool mst_sim_add_con;
bool mst_sim_remove_con;
int mst_sim_remove_con_id;
u32 mst_port_cnt;
unsigned long connect_notification_delay_ms;
u32 disconnect_delay_ms;
struct dp_mst_connector mst_connector_cache;
u8 *(*get_edid)(struct dp_debug *dp_debug);
void (*abort)(struct dp_debug *dp_debug);
void (*set_mst_con)(struct dp_debug *dp_debug, int con_id);
};
/**
* struct dp_debug_in
* @dev: device instance of the caller
* @panel: instance of panel module
* @hpd: instance of hpd module
* @link: instance of link module
* @aux: instance of aux module
* @connector: double pointer to display connector
* @catalog: instance of catalog module
* @parser: instance of parser module
* @ctrl: instance of controller module
* @pll: instance of pll module
*/
struct dp_debug_in {
struct device *dev;
struct dp_panel *panel;
struct dp_hpd *hpd;
struct dp_link *link;
struct dp_aux *aux;
struct drm_connector **connector;
struct dp_catalog *catalog;
struct dp_parser *parser;
struct dp_ctrl *ctrl;
struct dp_pll *pll;
};
/**
* dp_debug_get() - configure and get the DisplayPlot debug module data
*
* @in: input structure containing data to initialize the debug module
* return: pointer to allocated debug module data
*
* This function sets up the debug module and provides a way
* for debugfs input to be communicated with existing modules
*/
struct dp_debug *dp_debug_get(struct dp_debug_in *in);
/**
* dp_debug_put()
*
* Cleans up dp_debug instance
*
* @dp_debug: instance of dp_debug
*/
void dp_debug_put(struct dp_debug *dp_debug);
#endif /* _DP_DEBUG_H_ */