Firmware doesn't expect any vdev commands from host while RSO stop
is happening. It sends a response to the RSO_STOP command once
it's done with cleanup. Host needs to run a timer after sending
RSO stop command to firmware and wait for a maximum of 6 seconds
for the response. Host can stop the timer and allow the commands
to firmware in the below cases,
1. RSO_STOP response with success status
2. RSO_STOP response with HO_FAIL status followed by
HO_FAIL event: Host needs to wait till HO_FAIL event is received
If firmware doesn't send any response in the 6 seconds wait, issue
a recovery to help to check the firmware state.
Also, set WMI_ROAM_SCAN_MODE_FLAG_REPORT_STATUS always when MLO is
supported while sending RSO_STOP to firmware. It's sent only
in case of wpa_supplicant disabled roaming currently.
Change-Id: I8182e60beb9288dba23cc72e978dc781c8ab1707
CRs-Fixed: 3106023
db3c1a98e5