NDP peer gets created as part of NDP indication in case of NDP
initiator. But NDP may fail to form due to various reasons and
firmware may send NDP confirm with reject status in such cases
instead of NDP indication event.
Below is the detailed scenario,
1. On initiator side, it has sent an NDP request and is waiting
for NDP response.
2. On responder side, application/framework is preparing to send
NDP response with reject due to some config mismatch. At the
same time, NDP termination is also issued. So NDP termination
frame is sent successfully.
3. Initiator firmware receives this NDP end and it sends an NDP
confirm with REJECT to the host and it shall clean-up the
session.
Currrently, there is a check for the peer existence while
indicating this NDP confirm status to framework. There is no need
of this check in such failure cases as peer is not yet created.
Change-Id: Ibe94a5b67df1ce3d65eaf2ef37b11b08155752c9
CRs-Fixed: 3086975
accd92e85d