To avoid unmeaningful rate fluctuation, when report
rx linkspeed to upper layer, exclude special frames:
arp/ssdp/dhcp/eapol/ipv6 NA/NS/DHCPV6 in low rate.
Change-Id: I4bc49a808a02b4bc8c687f70690922045d65e739
CRs-Fixed: 3198484
There is a possibility where host can receive invalid SW cookie
from Rx rel ring which causes invalid rx descriptor access in
dp_rx_wbm_err_process().
Add a sanity check on received SW cookie to prevent the invalid
rx descriptor access.
Change-Id: I7818290466a2a8cea9938577fbf869d1fc30d5e3
CRs-Fixed: 3240038
If vdev is updated in mld_peer, then vdev in txrx_peer of mld peer
should be updated and synced accordingly.
Change-Id: I003ab5f3d96f0b62a5ed1dad2b1e8d4f57f58dad
CRs-Fixed: 3242644
Add function pointer declaration for SCS peer lookup and rule
match and also define cdp call for the same.
Change-Id: I4329b746a12f019a077652d02625b76c7f5fa21f
CRs-Fixed: 3226475
Changes to fetch the default monitor ring config and then
apply CFR filter settings on top of it instead of overwriting
the default one.
CRs-Fixed: 3241818
Change-Id: I7b9d1c9560fd665e0f6418176e6dd3642450442f
Packet logging buffer is only 2048 bytes, if copy non-linear
TX packet with skb->len (like TSO) which is likely > 2048,
this will lead to skb panic as packet logging buffer can not
accommodate it.
Only support TX packet logging with single linear buffer.
Change-Id: I1d15f9ab80fcc1720fdb3f7fe8c89e7f5e3c0a79
CRs-Fixed: 3242090
Create a HIF context for UMAC reset handler, register the datapath UMAC HW
reset callback handler with HIF layer, request for UMAC HW reset interrupt,
and schedule a high priority tasklet to process the interrupt in which
call the registered DP callback handler.
CRs-Fixed: 3184312
Change-Id: Iefc811bf0d1b093c3c63bf2238c94a1448f4f139
To support WDS feature in IPA driver, WLAN needs
to update the ast entry for any new rx packet, and for
end-nodes connected via repeater to root.
CRs-Fixed: 3226348
Change-Id: I7383b12f18e7c70ec06499d66130667eca033131
a. to avoid dynamic memory allocation of ppdu_info per-pkt path
which is leading fragmentation, use statically allocated
ppdu_info.
b. Disable rxmon workqueue processing as statically allocated
ppdu_info is being used.
Change-Id: Idbcd49863954582349900a414bb1aa80f68aab72
CRs-Fixed: 3239974
Add extra actions for tx peer filtering. This actions are used
to indicate to FW for the first peer addition and the last peer
deletion. This will be used by FW to set and clear peer filtering
related registers.
Change-Id: I1488146f54f3aab82651f4a27823a9b977d7b307
CRs-Fixed: 3237958
Subscribe only for the required downstream and upstream tlvs instead
of subscribing for all the tlvs. Also set only the required word mask
configuration
Change-Id: I998d0bf3b331bf2d5227bbba4b5962bcba80a2e5
CRs-Fixed: 3238211
Add support to track the high watermark for the number
of entries which are used at any given instant. This helps
in identifying if the ring size is sufficient or is being
full for certain use-cases.
Change-Id: Id3ffa52c653696699fbcfbb556a815d5f7908863
CRs-Fixed: 3235115
Currently, the PN error message is logged with
QDF_TRACE for every occurrence of PN_CHECK_FAILED
or PN_ERROR_HANDLING_FLAG_SET. This causes a crash
due to excessive logging when there is a high number
of PN errors. Hence rate-limit this message.
Change-Id: I57bc3401ba8239151f0791040c649d372ec0a953
CRs-Fixed: 3236492
With KIWI_V2, wbm_ring_num for WBM2SW5 and WBM2SW6 have been changed
to 5 and 6. Hence properly update them in g_tcl_wbm_map_array. At the
same time, tx_ring_mask_msi and tx_ring_near_full_irq_mask are also
updated.
With IPA_OFFLOAD enabled soc->tcl_data_ring[0|1|2] is used by HOST
and the other two rings are allocated to IPA usage.
Change-Id: I4c13d0787e46be667c3a5a0ae624df8c2b2b354e
CRs-Fixed: 3229375
Update RSSI specific parameter from beryllium
specific path to common path as part of
extending feature for lithium also.
RSSI calibration parameters are received as part
of WMI event from FW, update these parameters to
monitor pdev via CDP interface.
Change-Id: I4e35d873db6d1ad03d86694a8d36decffe409a0e
CRs-Fixed: 3231120
With IPA WDI version 3.0 including HST, HSP and even HMT,
GSI is the implementation instead of IPA uC. As a result,
desc_format_template filed in pipe setup info is not used.
Hence clean up the unnecesssary setup for desc_format_template.
Change-Id: I51f87d9e22951c6a621c11984ed5e7084990c5c0
CRs-Fixed: 3231623
To avoid memory fragmentation during wifi down/up,
initialize ppdu info flex mem pool during pdev attach
instead of pdev init.
CRs-Fixed: 3235962
Change-Id: I7970ab056e600ccfe28ae1ccdc50a66d5ae0ade8
-Wimplicit-fallthrough is being enabled by default. Some compilers
such as clang require the attribute instead of just a fallthrough comment.
Change-Id: I443da8d7f5e1771dceb3386c4458b0da6a5e9476
CRs-Fixed: 3218236
- Handle scenario where decap type may be invalid when
buff address tlv is received.
- Add check for min number of frags during restitch process.
- Minor fixes during rx mon tlv processing.
Change-Id: I0120d97e297701362183189e29c1d5df91affdc1
CRs-Fixed: 3216050
- Add support to compute HW Tx completion delay on WKK
- Define arch op to calculate delay
Change-Id: I82567cc781e90fe01dc5a0edfffacd4cde73f652
CRs-Fixed: 3220911
Add delta_tqm, delta_tsf2 and mlo timestamp offset for BE.
These offsets are used to calculate hardware Tx completion delay.
delta_tsf2 and delta_tqm are updated during init. mlo timestamp
offset is updated whenever target sends the update event.
Also, adding CDP ops to set the offsets.
Change-Id: I55665982798c3a795481fa96c023bb851ea17476
CRs-Fixed: 3220906
Currently the INI value for reo destination ring size
is over-written to 1024 during ini. Hence any ini change
to modify the RX ring size does not take effect.
Fix the over-write of the INI value for reo destination
ring size.
Change-Id: If4c166687a05f37b902ae1f7ed881db88436eaaa
CRs-Fixed: 3235427
Add host support to display selfgen_be_stats,
selfgen_be_err_stats and tx_sounding_stats.
Change-Id: If6b6da59be609161537f1e3b28031ac3d029328b
CRs-Fixed: 3210158
Currently 11be msdu rate statistic is not supported yet.
Another issue is: HW reported pkt type value 6, while host
SW defined 11be type DOT11_BE (value 5), they are not matching.
DOT11_BE value 5 is referred in monitor mode and otherwhere,
so do map and conversion in host sw side.
Change-Id: Ic5c2dd2a35cbe0ecd6430f007b6e7e02ece40998
CRs-Fixed: 3230900
Changes to configure the rxdma ring for CFR. Move existing
API of legacy chipsets to dp_mon_1.0 and add Waikiki
specific API in dp_mon_2.0.
CRs-Fixed: 3231265
Change-Id: Id7276bb7bb7f58461c7e10a0695c3e78a1c39b0c
Add history to track the monitor status buffer entry.
Currently the below 3 events are added:
- Monitor status buffer reap from ring
- Buffer enqueue to a local list
- Buffer dequeue from local list for parsing.
Change-Id: I7c17070ffee25a9a9dc4af0b48bfa8808e18887d
CRs-Fixed: 3225647
Fill up the lite monitor vdev which is needed to deliver the
tx monitor frames to the configured vap.
Change-Id: I298abde095fef44e67a741f48f2f73a6998efc7a
CRs-Fixed: 3226335
Properly increment message word variable while forming rx ring
selection config htt message. Message word should point to
appropriate word before calling individual feature config funcs,
this will help to track exact message word position in calling
function.
Change-Id: Iad6c446ac91fdb5be9286f4fa076847e1728dc74
CRs-Fixed: 3219549
Remove type option from peer config as host doesn't have to track the
state of peer. State transition between associated and non-associated
peer is seamlessly taken care in FW and no host intervention is
needed.
Change-Id: If85ff68878fb2284ff28ff93320ca009377a90e6
CRs-Fixed: 3221274
RX TID HW descriptor is first allocated in setup stage. When
failure case happens, it is got freed. This change adds a
check to make sure it's valid before updating RX TIDs.
Change-Id: I1326315b2eca4c50ef9ff5fa887386de4a796eb0
CRs-Fixed: 3227483
1. Remove prints in per packet path
2. Add prefecth for skb shinfo
3. Avoid qdf_get_cpu() in DP tx
Change-Id: I86d196cc7865a2d5b3a5a6098f6f7d84397a60d0
CRs-Fixed: 3227568
a. Fix memleak issue due to RX_HDR not received for a MPDU
b. Compute appropriate packet offset for non-decapped packets
c. Add correct DMA_LEN while adding a frag to SKB.
d. Add debug stats
Change-Id: Ie946f79df94df05789220b97c159c60d608bf1b2
CRs-Fixed: 3213698
Currently, bandwidth and corresponding MPDU retry threshold was
taken from tx packet status in per packet to update peer stats.
With this change, set bandwidth and MPDU retry threshold
during peer registration.
Change-Id: Iffd06968246d0b86b26716ae6672e2cd23360c67
CRs-Fixed: 3225479
UMAC HW reset feature will be using the last interrupt context in each
DP interrupt combination i.e., on a system with more than 8 MSIs for DP,
UMAC HW reset will be assigned a dedicated interrupt context.
Add the necessary support for the same.
CRs-Fixed: 3163900
Change-Id: I26abd01e4261661ed95e1aa3cb2a774e78b50d9f
This change fixed compilation issue when enabled two configures -
CONFIG_WDI_EVENT_ENABLE and CONFIG_REMOVE_PKT_LOG.
Change-Id: I121ea61bd3681b834a36c0bc8017b855897023a4
CRs-Fixed: 3223552
Currently the sw_cookie is validated in RX error path
using the pool_id logic, which is not valid for KIWI target.
Kiwi target has a different logic to assign rx sw_cookie, as
compared to other legacy chipsets.
Hence this sanity of sw_cookie fails always for RX error
packets on KIWI target, and these corresponding buffers are
never released/replenished back. Eventually as more RX error
packets are received, the device runs out of buffers in the
refill ring and induces a backpressure.
Hence disable this sanity check for sw_cookie in rx error
path for KIWI target.
Change-Id: I320fcb268c1fe24695daeb4677af6cc0cbc445ed
CRs-Fixed: 3228792
Remove unused local variable mon_soc in the dp_pktlogmod_exit to
address the compiling issue when PKT log enabled.
Change-Id: I5de03433603988e6f8125285a58c141551d7a149
CRs-Fixed: 3225370
