Enhanced channel frequency response (CFR) based on monitor status
ring, need to enable mon reap timer before starting CFR and disable
the timer after stopping CFR capture. This change adds interface to
enable/disable monitor status ring's reap timer.
Change-Id: I843433ac07c4d55e14b42855ee22779eb7ecb678
CRs-Fixed: 2639307
Move RCC specific debug statistics to Data path
to avoid allocating nbuf for the PPDUs for which
MAC has not sent a Freeze TLV. Instead just update the
debug statistics at an earlier point irrespective of
MAC sending Freeze to PHY, to gather below information:
Status of number of PPDUs being captured by PHY
Status of MAC sending freeze TLV for the PPDUs
Update freeze reason for the number of PPDUs received
Add support to clear debug statistics at user's will.
Change-Id: I8def3ce1f3ecc0b169030704db3fb1fb1c0a20ee
CRs-Fixed: 2609604
Maintain packet counters for each peer based on protocol. Following 3
protocols are supported
* ICMP (IPv4)
* ARP (IPv4)
* EAP
Change-Id: I56dd9bbedd7b6698b7d155a524b242e8cabd76c3
CRs-Fixed: 2604877
A framework is added where the filters for every
mode are stored on a radio instance. Whenever a mode comes
up, it stores the filters in the radio and calls a
common API which iterates through all the enabled
mode filters and loops through them to create a
superset of filters which is sent to HTT.
This framework can be extended for new feature addition
which set filters for the monitor status and monitor
destination rings.
Change-Id: I9b739af2086bbe261b65c57af0a5bd867294f30f
CRs-Fixed: 2585872
Currently cdp ops are given pdev/vdev handle
as its arguments, which is directly accessed
in those APIs. This can cause a race-condition
in access of the respective handles if it has
been deleted in parallel.
Hence as a part of cdp convergence, pass only
the pdev_id/vdev_id which will be used to get the
respective handles, and hence avoiding unwanted
access of the handles if it has been deleted.
Also deleting few ops which stores and retrieves
such handles and adding ops to set/get pdev params.
- txrx_get_psoc_param
- wdi_event_sub
- wdi_event_unsub
Change-Id: Id089d9b6b4737d700d2436e2081291a3741affb5
CRs-Fixed: 2541658
Change set 2 of ctrl_ops APIs to replace pdev, vdev and peer
dp handles with pdev_id, vdev_id and peer mac address
along with dp soc handle
Change-Id: I3f180c9c360d564f0b229b447074ad23b7c0a737
Change set 1 of the ctrl_ops APIs to replace pdev, vdev and peer
dp handles with pdev_id, vdev_id and peer mac address
along with dp soc handle
Change-Id: Iedf6dea2215d3d04b2212c71c8ec8c7328c559e8
Channel Frequency Response(CFR) captures FFT bins corresponding to a PPDU
received and this is relayed to user space application. Since FFT bins
alone will not be meaningful, additional information about the PPDU such
as Peer addr, BW, NSS, etc are extracted from multiple PPDU status TLVs
and passed on to userspace along with CFR data.
Host RX monitor status ring is configured during CFR enable and the host
subscribes to relevant PPDU TLVs that provides all necessary information
for CFR data correlation.
Change-Id: Ia8080fe96c330db42d371634ba4363eb36c05402
CRs-Fixed: 2593416
Since tx_monitor mode and rx_monitor mode consume signficant MIPS
when enabled on a per-peer basis, new requirement is to enable such
functionality on a per-peer basis. New CDP APIs are added to set these
per-peer parameters.
CRs-Fixed: 2494471
Change-Id: Ib44845ec98481cc4df36c30f47335522e5274568
Tags are programmed using wlanconfig commands. Rx IPv4/v6
TCP/UDP packets matching a 5-tuple are tagged using HawkeyeV2 hardware.
Tags are populated in the skb->cb in the REO/exception/monitor data
path and sent to upper stack
CRs-Fixed: 2502311
Change-Id: I7c999e75fab43b6ecb6f9d9fd4b0351f0b9cfda8
1. Remove vlan tag in tx and enqueue to hardware.
2. Add vlan tag in rx after peer-vlan_id lookup.
Change-Id: I932202540ac03cabdd20ffd4849fe759ea8a7abb
With this feature, using appropriate commands, link layer, network layer,
transport layer and some of the application protocols can be tagged with
the user provided tag values for easier identification of protocols. The
supported protocols today are as follows.
ARP, DHCPv4, DHCPv6, DNS over TCP (v4), DNS over TCP (v6), DNS over UDP
(v4), DNS over UDP (v6), ICMPv4, ICMPv6, TCPv4, TCPv6, UDPv4,
UDPv6, IPv4, IPv6, EAP.
Receive packets are tagged by hardware. Tags are applied after the first
matching rule. Hence it is recommended that the rules are
programmed in such a way that tags are configured from application layer
to data link layer to get expected results.
Change-Id: Ibdc2bd2b78234f482074955e89fb93f05988eaca
Delay counters per TID have been implemented for following types:
1. Linux stack to hw enqueue delay
2. HW enqueue delay to tx completion delay
3. TX interframe delay
4. RX interframe delay
5. RX frame delay from ring reap to networking stack
Change-Id: I836596cbd878a43955c18b4981cb5b7b43d4df5e
In existing code, 132 bytes of OTA mgmt. and control payload is
provided to upper layers by subscribing to packet header TLV.
The requirement in M-copy mode though is to get complete payload for
mgmt. and ctrl. packets. Add change to configure monitor destination
ring and add mgmt. and ctrl. packet filter to receive full mgmt. and
ctrl. packets.
Change-Id: I0014837b51cac6f0143dcc5cb624ea2086cf4486
CRs-Fixed: 2256159
This FR is to enhance existing pktlog debug tool
This feature will allow to capture pktlog for particular
peer mac address.
Change-Id: I3676095536185f25b0d498e03f70246260a324fd
Add new flags for MEC and DA enable/disable
and keep it independent of WDS enable flag
Change-Id: Idb49c45ebb34a38f876dbdb293806c4e96d49b5d
CRs-Fixed: 2336332
Populate the RSSI value for the non associated clients
added in pdev->neighbour_peers_list from monitor status
ring
Change-Id: I509d06bec6eafe8377681c8a3da9a64f301c3c73
CRs-fixed: 2286571
Add change in driver to get RSSI of non associated clients.
This is done in 2 levels of filtering
1. Send WMI to FW to configure BSSID in HW
2. Filter the neighbour BSSID packets received in host for
the configured client mac
Change-Id: I6b684b83cecb308dac326056aa77537aee07b933
CRs-Fixed: 2148773
Add support to send MSDU, mgmt. and ctrl payload along with metadata
to upper layer callback
FR 42132
Change-Id: Ie751322c7c15419ea908538e9e8687b64693fcfa
CRs-Fixed:2068486
Add CDP API to get security type for ucast and mcast from
peer handler. Add additional peer handler argument for raw mode
rx decap functions. The peer handler is needed in the raw mode
functions for getting the security type of the frame and process
it accordingly.
Change-Id: I8b4728e9eb0ff29849805bb461c81e4fc3accc81
1) Defined modularized public api for cdp module
to track inactivity and over load detection.
2) Initialization calls are added to attach and
detach SON specific api.
3) operating system specific calls are replaced with qdf calls.
Change-Id: I130d1e99208d6454f5d9888774534cc6d619ad83
Add nac(non associated client) configuration to pdev. It will be
used to perform smart mesh filtering on rx packets.
Change-Id: I29989d379e10fcc4a0e4aa19dbb3499650d6bf39
CRs-Fixed: 2017269
Adding subscribe and unsubscribe functions for wdi events in
cdp layer to enable for legacy alone and disable for lithium
data path.
Change-Id: Ibdf449393d0cb59c4c46c712c7a72695e086ab6c
packets received on a particular radio are queued to
a user configured reo destination ring.
Change-Id: I080090f22b80fd8d8868df4145b82888e1111cea
CRs-Fixed: 2017081
Add API to handle NAWDS packets on tx side.
Add API to handle invalid peers and pass them to umac.
Change-Id: Ie8c2508e4f51c7d6969c9eb6439919c57dd427d4
CRs-Fixed: 2008205
Added support to filter out received packets on mesh vap based on
rx filter setting.
Change-Id: Ibc541324d928a9d006531c8908f4792e0c7d854e
CRs-Fixed: 2003389
Replace void pointer handles for pdev and vdev with
abstract structure handles in cdp.
New file cdp_txrx_handle.h has the abstract
structure declarations.
Change-Id: I333e6ea5e699e7cebbfc6281faf7f07c0aee4e2a
CRs-Fixed: 1109835
Change the return type of get_vdev_rx_decap_type to htt_cmn_pkt_type
which is defined inside the cdp_if layer.
Change-Id: Ie931952e3618f8e52a5b8839648a0516132ede1f
CRs-fixed: 1075597
Remove the htt.h file inclusion from inside the cdp layer.
The upper layers should include this. Create a common
enum structure to be used inside the cdp_if layer.
Translation will take place in the DP layer.
Change-Id: I0c3e30eab54c0efafb917ddb304678a392788c2b
Crs-fixed: 1075597
Added a new layer CDP_IF inside dp which is an intermediate
between the data path functions and the upper layers. All function
calls from outside the DP layer to the DP layer goes via the CDP_IF
layer
Change-Id: I76e671c85d2d02aa0a65a90b356840d3aeede52d
CRs-Fixed: 1075597
Address compilation issues for WIN with new Lithium Firmware headers.
Also removed dependency on htt.h from header files, which may need to
add explicit dependency on htt.h in .c files.
Change-Id: Ia5027963837e645bc3f81a3db98c2ea06789aea8
CRs-Fixed: 1061096
Initial check-in of the data path converged APIs that
are currently only implemented by WIN.
Change-Id: I68bc403dc652b514bfcc27f1eac1e9c5ca27c8d8
CRs-Fixed: 993414
