AP isolation a.k.a intra-bss forwarding is a per AP attribute. Issue in
current IPA implementation is that it does not support per AP control.
In a SAP-SAP configuration, latter SAP configuration will always overwrite
first SAP's isolation configuration.
Fix is to add vdev id parameter from protocol layer so that IPA component
could configure AP isolation on a per AP basis.
Change-Id: I9c96cdcda03eb10b4c2984a757e52d77b5bf6790
CRs-Fixed: 2624757
Currently cdp ops are given pdev/vdev/peer
handle as its arguments, which is directly
accessed in those APIs. This can cause a
race-condition in access of the respective
handles if it has been deleted in parallel.
Hence as a part of cdp convergence, pass only
the pdev_id or vdev_id or peer mac address,
which will be used to get the respective handles,
and hence avoiding the unwanted access of the
handles if it has been deleted.
- ipa_get_resource
- ipa_set_doorbell_paddr
- ipa_set_active
- ipa_register_op_cb
- ipa_get_stat
- ipa_tx_data_frame
- ipa_uc_get_share_stats
- ipa_uc_set_quota
- ipa_enable_autonomy
- ipa_disable_autonomy
- ipa_setup
- ipa_enable_pipes
- ipa_disable_pipes
- ipa_rx_intrabss_fwd
Change-Id: I678d7a7de7132417ff6051b0fd6da5d14426d21e
CRs-Fixed: 2540861
In DBS scenario(SAP + STA) when all SPA clients disconnect, while STA is
still connected, IPA pipes are disabled on the lithium target. At this
time, its possible that some packets TX from IPA over WLAN are still
pending. If these completions come after IPA pipes are disabled, it can
lead to a NOC error, since the GSI doorbell register for WBM2SW2 ring
may be clock gated (after IPA pipes are disabled).
To avoid this situation, wait for some time before disabling IPA pipes.
IPA pipes are disabled after a timeout, when system suspend call tries
to suspend the bus. A driver unload or a softap tear-down will also
disable the pipes.
Change-Id: I542049fa19d0dcf5c31d9b8a2d836388847dd6c1
CRs-Fixed: 2553670
Implement metering stats quota to support ipa offload sta plus
sap wifi sharing use cases.
Change-Id: Ic9d5ad817ffb4d671a43f3f3aebb2d8cce293873
CRs-Fixed: 2517696
During wlan IPA suspend, force the bandwidth voting to high
when CFG_DP_IPA_ENABLE_FORCE_VOTING is enabled.
Change-Id: I9b368081f9c0919f5fecfacf318ad1a714cc33cf
CRs-Fixed: 2521815
If STA disconnect failed for any reason, cleanup IPA STA iface
if not already done.
Change-Id: I27ff33324bc4724e8470af9a0c434fa03e8aa5c3
CRs-Fixed: 2505563
Local sta_id or peer_id is being cleaned up across DP, HDD
and PS/WMA. So, any references to local peer_id/sta_id will
be replaced by peer mac address and all interactions
between the layers will be based on peer mac address.
Change-Id: I78230bf1e1ec090e83245bff04953fa2e03b91cd
CRs-Fixed: 2504013
Abstract the callback hdd_softap_ipa_start_xmit by
hdd_softap_ipa_start_xmit, to match the return type of
wlan_ipa_softap_xmit pointer, to fix a CFI failure.
Change-Id: If1cb1a80801558d5c7831ec89ad5281b0bbe36f3
Some ini descriptions are different to common, and some of them
include wrong information, so correct them and use unified form.
Change-Id: I36348fb26a03cab254fd309d792125b8a21ad02f
CRs-Fixed: 2402446
Upon driver reinitialize after a FW rejuvenate,
data packets are not going through IPA path.
Check for FW rejuvenate scenario during driver
recovery and send appropriate message to IPA
driver.
Change-Id: I8c1d7ba78227684cd5653a5927aa4d4c2ce5d354
Crs-Fixed: 2287293
Currently during SSR IPA events such as AP DISCONNECT/
STA DISCONNECT are not sent and also wlan ipa interafces
are not deregistered. After SSR when host sends AP CONNECT/
STA CONNECT and register interafce IPACM will reject as for
previous events before SSR there are no disconnect events.
This leads to data come via exception path instead taking
IPA HW route as interface headers are not registered.
In this fix send IPA UC disconnect events and deregister
interafces during SSR.
Change-Id: I6e617261ec53b7d572023613d212eae057b13b03
CRs-Fixed: 2315828
A number of HDD and IPA logs are generally unnecessary and have been
identified as contributing to log spam. Reduce these log messages to the
debug level.
Change-Id: I2f92bb4caec5adc65fdad0146298aa5f88b43def
CRs-Fixed: 2288430
In case of rmmod if stop bss fails SAP IPA interface is not
deleted. So again at next driver load IPA will be holding the
stale IPA header and new IPA header will not be added at IPA
interface creation. In this change clean IPA interface when SAP
stop bss fails.
Change-Id: I3a1bf891752308ba1a29d6768f24880d8514d5bf
CRs-Fixed: 2224307
There's an excessive log for IPA uC stat request reason even when
WDI pipe is suspended.
Enable IPA uC stat request reason log only when IPA pipe is resumed.
Change-Id: I35d98e02a9180738bc9cdb25f59e31d572df9e0e
CRs-Fixed: 2181952
Check if IPA is enabled in ini configuration before doing
IPA operations from northbound interface calls.
Change-Id: Ic075562c1afe52d26ebefaff058fde7c90d4f7d1
CRs-Fixed: 2215269
IPA module has been moved to CLD component under the converged
driver model. Move the legacy HDD IPA SMMU functions to the
IPA component.
Change-Id: I3ac5ebe87cc48913f3e8e075e60737e78664f861
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy HDD IPA WLAN event handler to
the IPA component.
Change-Id: Ia53adce7ef29eea747f288fa074f96a84e47925d
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy HDD IPA FW OP event handler to
the IPA component.
Change-Id: Idecf12c33a5b4ab80de50626029ff43b5f9336a2
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy IPA UC offload initialization to
the IPA component.
Change-Id: I221a11e7f8aa2459918f87c6b043d4682e05cb04
CRs-Fixed: 2177925
As part of converged driver model remove IPA from
HDD and create a new IPA CLD component. Remove the
legacy code from the HDD.
Change-Id: Id4691e0f490c2f9bd9ccc8d5225be32002a5df9e
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy IPA stats and debug info APIs to
the IPA component.
Change-Id: Ieb68a1579986c835f66c84e5e3b7aa2a4004383d
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy IPA set perf level APIs to the IPA
component.
Change-Id: Idbbab9cc6885b6acf1cd40d432a236f0629c8dff
CRs-Fixed: 2177925
IPA module has been moved to CLD component under the converged
driver model. Move the legacy IPA setup and initialization code
to the IPA component.
Change-Id: I63717eb2601c569131c6642f7330e4182e604424
CRs-Fixed: 2177925
As part of converged driver model remove IPA from
HDD and create a new IPA CLD component. Add files for
IPA core, dispatcher and target_if. Define IPA related
public and private structures.
Change-Id: I8848331edc7dd878f9fc51ef9f5e311ad91ed70b
CRs-Fixed: 2177925
