Add reg_wake_irq macro callback and issue an event
from Tx macro to Tx sound wire master instance
in order to register for wake irq and to handle
the ipc wake up interrupt.
Change-Id: Iefddc1f85173ce267c0b00c9d06be3a4a2fe29fe
Signed-off-by: Aditya Bavanari <abavanar@codeaurora.org>
Add new class-H driver with sequences to support
both class-H and class-AB modes on wcd937x variants.
Change-Id: Ie109f3d951af1e8a0079dd39ab2fe1e9883bd6c2
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
For export functions from wcd937x use separate
header as internal header is only supposed to be
used within wcd937x driver logic.
Change-Id: Ice373ff95f7166a2f968458b25223c582edc7fba
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
Two power modes are supported on bolero digital.
Add support to set required power mode using
mixer control and enable runtime during powerup
sequence.
Change-Id: I4c5a7560984d60745ac98848f1eec1d1f8485323
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
TX channel2 is not disabled after power down. It leads to
noise at the beginning of next recording on CH2.
Disable it after power down.
Change-Id: If12a84df52b9c8cd55de2bdcb91f950b054898b8
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
Avoid access of gfmux register during SSR/PDR.
Reset the gfmux state to MCLK_MUX0 after
SSR up event in rx macro.
Change-Id: I2ac611049efd3ce9d03bc9dcd912f64887a23679
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
Micb lock which is used to synchronize micbias
control api is not initialized causing spin lock
errors. Initialize the mutex to avoid the issue.
Change-Id: I580e52e1bd225c2d99bfba4657d80670296709a0
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
Sometimes observed that session is taken more time to teardown
after ssr. Increase timeout to allow more time for session
to be tear down.
Change-Id: I3f1b4d8f583ad5b9c8f5e1b90af9c576ae6bd2b2
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
Currently, the fs_cntr for MAD is enabled whenever the MAD
audio path is enabled. But, a new issue is reported where
MAD fs_cntr is required even for some of the non-MAD paths.
As per hardware requirements, enable the MAD fs_cntr always
from the codec default registers.
Change-Id: I6fe8f663b82e711b4194aa51a3e21150aa98cf02
Signed-off-by: Bhalchandra Gajare <gajare@codeaurora.org>
Runtime HPF param change leads to TX distortion at the beginning.
Unmute HPF after param change.
Change-Id: I7683ca047123dd004fb2dd019365305edfc72ea5
Signed-off-by: Xiaojun Sang <xsang@codeaurora.org>
SXR1120 has additional gpio for micbias supply to be
enabled. Add control for this gpio and enable it.
Change-Id: Ica4ea9765db9bd48a1f8eb010d82d2687c8abbb9
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
When micbias is enabled set curr to higher value for
vreg bob bypass and when it is disabled set it
to default value for sm6150.
CRs-Fixed: 2315478
Change-Id: I451506002f382e666d47bc83944bdc8dbbedcad8
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Pop is observed on HPH playback start. Enable SWR port
config setup before HPH PA enable.
Change-Id: I2253be1c7e4d8df2bffd7bd0396ceb72a5018637
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
Add widget and routing support for vdd-buck supply
as dynamic for all rx usecases.
Change-Id: I1e67e7e950e33a0d98900ee0b20e0dc818a7936d
Signed-off-by: Tanya Dixit <tdixit@codeaurora.org>
If interrupt indicates a fault in multichannel case,
reset all cluster devices in a specific order.
Change-Id: I077ff65c5f2b5e656fcdf6533fde04eba426e322
Signed-off-by: Romed Schur <rschur@codeaurora.org>
If headset is connected during SSR, after recovery mbhc
driver expects a new detection event as the driver is reinitialized.
Reset detection type to insertion to retrigger a hw interrupt
for mbhc driver.
Change-Id: I55705eb6b6a289deb5dc16a4b9ef6252082a3d9a
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
The format change event signaling for EP92 HDMI input is adapted
to provide format information through sysfs nodes.
Chip configuration is done through sysfs as well.
Change-Id: I8c930ca5647899b4434272009699763c32fe9d04
Signed-off-by: Ralf Herz <rherz@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
wcd interrupts can be disabled in the same interrupt
context. So use non-sync disable irq api for disabling the
interrupts to avoid a deadlock.
Change-Id: I82dda8dbcd80ba18674eea00686f6a4f54a3b340
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
During SSR, when the playback on speaker gets started before codec
is out of digital core power collapse, results in soundwire
register read/write failures. Check for codec power state before
enabling the soundwire during speaker device path enablement for
playback usecase to avoid soundwire register read/write failures.
Change-Id: I3b45ef0c34ad4f97aad89afaf719989ffbda7485
Signed-off-by: Sudheer Papothi <spapothi@codeaurora.org>
Add proper way to clear interrupts using regmap irq framework,
to avoid mismatch between interrupts handled and interrupts
cleared. wcd937x requires writing '1' and then '0' to clear
interrupt. Set a new regmap irq flag 'clear_ack' to indicate this.
Change-Id: I1346dc66735d3b5788e1cc0cfef772c9deacbfc1
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
Update ignore suspend for AIF in/out and dapm input/output
widgets for bolero and wcd937x codecs to avoid suspend
of codec during active usecase running even after APSS
goes to suspend.
CRs-Fixed: 2321226
Change-Id: I277129e8e657485c56414a385150c4da55382770
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
After switching from native to non-native clip,
observe slowness in clip playback content heard
on headphones. Update mclk_mux for enable sequence
based on native flag and for disable sequence
use the same setting done during enable.
CRs-Fixed: 2322232
Change-Id: I795e0620e0239b53cdfdadaf2d57acfb570c4c3b
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
ANDROID_BUILD_TOP variable is deprecated and thus all paths are
assumed to be relative to the top directory.
Change-Id: Ifc1bba67bf47092a37336581990d4bcce82a72f5
Add changes to recover audio after SSR on wcd937x driver.
Change-Id: I661605e9b1bd71f08f331d14ae52f89ba8423d4f
Signed-off-by: Rohit kumar <rohitkr@codeaurora.org>
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
