Define a new cdp interface structure and API for soc stats for use
by upper layers to fetch dp soc stats.
Change-Id: I314e952546551003da2ca7f69b2e1aa23c126e66
In case of aging out wds entries, avoid sending all
the wds delete wmi commands in a huge single burst.
Instead limit the maximum commands to half of the
wmi queue size. Inactivity will continue to be
marked every 120 secs but the inactive entries
will be flushed every 5 secs if there are pending
entries.
Change-Id: I6735704a0750ef466f1df798f0b354f4382098d6
CRs-Fixed: 2952682
added new WDI event index for tx capture, share same index cause
corruption when switching different feature without delay.
Change-Id: I9e7a849968544957491891629eb42974c8b65728
Add and initialize a preallocated pool of buffers which can
be used to replenish RX buffers. During replenish, the buffers
from the pool are used instead of allocating/mapping a new buffer
in the softirq context. This preallocated pool will be refilled
in thread context.
Change-Id: Idf3bd7d25c5d57ddba105ccd8fab672c26a184f1
CRs-Fixed: 2869345
This change will set up monitor mode status and destination ring
filters for enbale CBF logging and will enable destination ring to
capture CBF frame. This change will get the CBF frame from the
destination ring and send it to the pktlog module for post processing
through WDI event. CBF is a compressed beamforming report.
Change-Id: I4cc419440ba8d60446dd1f01747340a89f023171
While preparing raw packets for transmission, the count
of nbuf belonging to one mpdu must be less than the
number of segments.This makes sure the frags array inside
seg_info does not go out of bounds.
Change-Id: I7fffba7f64da274aa73c558cfc63d90f4419a04d
Firmware advertizes its support to place FST in CMEM,
export this capability to DP.
Change-Id: I265246bcfd38a36e34c4ede66e117a92bb185032
CRs-Fixed: 2772238
Drop frame if it is not for the vap, to which
client is connected.
Enable this check only for ap.
Change-Id: I33d7eb79267490bdb8697e4e45f789e9f6279f0e
CRs-Fixed: 2756304
Add support to update the count of number of Punctured Preamble
PPDU's transmitted by the AP.
Change-Id: Id85a490e9e80566e639f48190a96d3107c6e5c61
CRs-fixed: 2755288
Rx desc pool have a flag to identify whether frag or nbuf
operation needs to be performed for alloc, map, prep and
free buffer for monitor dest buffer.
This flag will be set only for mon destination desc pool,
if RX_MON_MEM_FRAG feature is enabled.
In all other case, It will be set to Zero and default nbuf
operation will be taken.
This flag get initialized at the time of pdev rx_desc_pool
initialization and gets reset while pdev deinit.
Mon destination buffer will have support for frag if
RX_MON_MEM_FRAG flag is set.
Change-Id: I67c6c823ee4f114035b884c024a1a9054a40665b
CRs-Fixed: 2741757
Move RU and MCS strings from dp_stats.c to cdp header file so that these
strings can be used in user applications including the CDP header. This
will remove redundant definitions of these strings in user application
Change-Id: Ie74283f54131378447324b927e19e9716ef7519a
CRs-Fixed: 2749062
Add WMI support for WMI_TWT_SESSION_STATS_EVENTID. This event
contains stats for a given TWT session.
Change-Id: I01d5f7b30da803ee713a14c1d1124b8af7161bca
CRs-Fixed: 2609951
DP RX changes to support RX buffer pool, this is a pre-allocated pool
of buffers which will be utilized during low memory conditions.
Change-Id: I8d89a865f989d4e88c10390861e9d4be72ae0299
CRs-Fixed: 2731517
New WDI event WDI_EVENT_HMWDS_AST_ADD_STATUS to indicate
status of HMWDS peer ast add action to upper layers.
Change-Id: I49afd4b1b64596ef59261e3da1677955c10a7804
CRs-Fixed: 2729299
Soc level exception descriptors limit is sent from FW in WMI service
ready TLV. Using that to check for exception packets limit
Change-Id: I99d20ecbb6a5bfd61b5a8a205775d34749eae880
Move RCC specific debug statistics to Data path
to avoid allocating nbuf for the PPDUs for which
MAC has not sent a Freeze TLV. Instead just update the
debug statistics at an earlier point irrespective of
MAC sending Freeze to PHY, to gather below information:
Status of number of PPDUs being captured by PHY
Status of MAC sending freeze TLV for the PPDUs
Update freeze reason for the number of PPDUs received
Add support to clear debug statistics at user's will.
Change-Id: I8def3ce1f3ecc0b169030704db3fb1fb1c0a20ee
CRs-Fixed: 2609604
Add code to move enum _ol_ath_param_t out from common DP code
and move it into OL layer
Change-Id: I92fa5f52c581a18449ab42da41ff5f6f1a2bc595
Crs-Fixed: 2560866
Maintain packet counters for each peer based on protocol. Following 3
protocols are supported
* ICMP (IPv4)
* ARP (IPv4)
* EAP
Change-Id: I56dd9bbedd7b6698b7d155a524b242e8cabd76c3
CRs-Fixed: 2604877
Add API to set/get monitor vdev count in pdev object.
Also update the max peer count in pdev and psoc when FW allocated peer
count is different than host requested.
Number of vdevs and beacon tx offload max vdevs in wlan_res_cfg are updated
in target_if_update_pdev_tgt_info().
Also, add radio related parameters to get number of vdevs and peers per
psoc and pdev.
Change-Id: I0165f3bd4638280b45ad54391319806fba62e2fe
CRs-Fixed: 2600984
Provide an API to fetch required individual peer stats
from the data path peer stats instead of copying the
whole peer stats structure.
Change-Id: I1c9619bc7d9bb0e3e3df6d38cc5f4570869e31fe
multipass_rx_pkt_drop is peer level stats counter
used to count multipass rx packet dropped frame.
Accumulate this counter at vdev and pdev level.
It also initializes multipass_en flag to false at
vdev attach.
Change-Id: Idaa85a71c80eefb9359abb026402b71aa28ad6a2
CRs-Fixed: 2595551
CFR information extracted from PPDU status TLVs is already stored in
HAL ppdu structure. Extract the same and copy it to CDP ppdu structure.
This is delivered to subscribers through a WDI event, similar to PPDU
stats.
Change-Id: I4315626c7f79f85b75b8d1b9e1e5caf8d65abed9
CRs-Fixed: 2593416
* Add command to modify OMN (Operating Mode Notification) timer value for
hw-mode switch. These commands can enable/disable the sending of Opmode
IEs in the beacons after HW mode switch and also configure the time for
which the IE will be sent after the switch.
* Add command to change primary interface when switching dynamically to
DBS mode.
Change-Id: Iceb8e29a46fa4873d3cbd7e41ec0da3782a5dd22
CRs-Fixed: 2560684
