Support dynamic antenna switch in TDLS:
1. If TDLS NSS is configured to be 1x1, TDLS connections not teardown;
2. When antenna mode switched from 2x2 to 1x1, TDLS connections teared
down and EAGAIN returned; When antenna mode switched from 1x1 to 2x2,
TDLS connections is still teardown, but success in one trial.
Change-Id: I1877002122a96dc8f40c796f8a1b938199d3b67a
CRs-Fixed: 2080461
Additional IE's in the TDLS management request is not
populated correctly and it causes invalid memory
access and system crash.
Populate the additional TDLS IE's in correct
order.
Change-Id: I1c65f04c3b0e134dc4854e3f16022c887e8ce7c0
CRs-Fixed: 2136739
If ACM enabled and access is not granted for AC_VI, then send
TDLS frames with lower access category instead of dropping them.
Change-Id: I2201536dc4475764f33eebce1faa0a7df0b2c454
CRs-Fixed: 2119433
TDLS set state cmd to firmware is going out of sequence, if STA
is disconnected, when concurrent TDLS connections are active.
This out of sequence causes crash in the firmware.
Fix the out of sequence issue, by grouping all the TDLS delete
peer commands into one single command.
Change-Id: Idd315d544c46bcf063881bff5be70cb5d9ad0ea2
CRs-Fixed: 2123838
When TDLS disabled at the build level, it triggers
build failures in some of the projects, which does
not support TDLS feature.
Restructure the TDLS function to avoid build
failures, when TDLS is not enabled.
Change-Id: I3b63546f22d0187fb42d400fd7e15ff7a3d64653
CRs-Fixed: 2056022
Firmware expects TDLS set state cmd before vdev stop, but
the cmd is going out of sequence during roaming and induce
crash in the system.
Send the TDLS set state cmd with correct sequence.
Change-Id: Ie106b8a8cebaa7f107c9eff67dda924b231162da
CRs-Fixed: 2048036
Add support to set address search flags in WLAN Tx Descriptor
for TDLS operation
Change-Id: Iafb15fb1efd84a4bef436062368401a5496e4468
CRs-Fixed: 2041759
Add TDLS ucfg interface changes for sta connect, sta
disconnect and tx/rx data sample
Change-Id: Ic57a91b70fe462ee031dc0cf54112601aae0dfc4
CRs-Fixed: 2034220
