Currently cdp ops are given pdev/vdev handle
as its arguments, which is directly accessed
in those APIs. This can cause a race-condition
in access of the respective handles if it has
been deleted in parallel.
Hence as a part of cdp convergence, pass only
the pdev_id/vdev_id which will be used to get the
respective handles, and hence avoiding unwanted
access of the handles if it has been deleted.
Also deleting few ops which stores and retrieves
such handles and adding ops to set/get pdev params.
- txrx_get_psoc_param
- wdi_event_sub
- wdi_event_unsub
Change-Id: Id089d9b6b4737d700d2436e2081291a3741affb5
CRs-Fixed: 2541658
Change set 1 of the ctrl_ops APIs to replace pdev, vdev and peer
dp handles with pdev_id, vdev_id and peer mac address
along with dp soc handle
Change-Id: Iedf6dea2215d3d04b2212c71c8ec8c7328c559e8
1. Enable CE5 and allow it to service
pktlog messages from the firmware.
2. Register full pktlog callback handlers
for handling sw_events and full tx pktlog.
Change-Id: Ifb70ac0993f2402201f88758845f730cf677b1a0
CRs-Fixed: 2388906
Clean up datapath component prints by correcting trace levels for
regularly occurring prints and removing newlines from converged
print APIs since qdf_trace_msh appends them by default.
Change-Id: Ie8fe319fcb737720f7400a165e134b6a18bd15b5
CRs-Fixed: 2243843
Initialize MAC1 along with MAC0. 2.4GHz monitor mode operates on
MAC1 so initialize MAC1 and reap both MAC0 and MAC1.
Change-Id: Id281def37d460b224f5f571893266f193846fd0c
CRs-Fixed: 2176848
Add polling timer to reap monitor status rings
until PPDU end interrupts are enabled.
Change-Id: I742b0df6fd5a369d9664b5c2e09a70916585174b
CRs-Fixed: 2117063
