Soc level exception descriptors limit is sent from FW in WMI service
ready TLV. Using that to check for exception packets limit
Change-Id: I99d20ecbb6a5bfd61b5a8a205775d34749eae880
Move RCC specific debug statistics to Data path
to avoid allocating nbuf for the PPDUs for which
MAC has not sent a Freeze TLV. Instead just update the
debug statistics at an earlier point irrespective of
MAC sending Freeze to PHY, to gather below information:
Status of number of PPDUs being captured by PHY
Status of MAC sending freeze TLV for the PPDUs
Update freeze reason for the number of PPDUs received
Add support to clear debug statistics at user's will.
Change-Id: I8def3ce1f3ecc0b169030704db3fb1fb1c0a20ee
CRs-Fixed: 2609604
Add code to move enum _ol_ath_param_t out from common DP code
and move it into OL layer
Change-Id: I92fa5f52c581a18449ab42da41ff5f6f1a2bc595
Crs-Fixed: 2560866
Maintain packet counters for each peer based on protocol. Following 3
protocols are supported
* ICMP (IPv4)
* ARP (IPv4)
* EAP
Change-Id: I56dd9bbedd7b6698b7d155a524b242e8cabd76c3
CRs-Fixed: 2604877
Add API to set/get monitor vdev count in pdev object.
Also update the max peer count in pdev and psoc when FW allocated peer
count is different than host requested.
Number of vdevs and beacon tx offload max vdevs in wlan_res_cfg are updated
in target_if_update_pdev_tgt_info().
Also, add radio related parameters to get number of vdevs and peers per
psoc and pdev.
Change-Id: I0165f3bd4638280b45ad54391319806fba62e2fe
CRs-Fixed: 2600984
Provide an API to fetch required individual peer stats
from the data path peer stats instead of copying the
whole peer stats structure.
Change-Id: I1c9619bc7d9bb0e3e3df6d38cc5f4570869e31fe
multipass_rx_pkt_drop is peer level stats counter
used to count multipass rx packet dropped frame.
Accumulate this counter at vdev and pdev level.
It also initializes multipass_en flag to false at
vdev attach.
Change-Id: Idaa85a71c80eefb9359abb026402b71aa28ad6a2
CRs-Fixed: 2595551
CFR information extracted from PPDU status TLVs is already stored in
HAL ppdu structure. Extract the same and copy it to CDP ppdu structure.
This is delivered to subscribers through a WDI event, similar to PPDU
stats.
Change-Id: I4315626c7f79f85b75b8d1b9e1e5caf8d65abed9
CRs-Fixed: 2593416
* Add command to modify OMN (Operating Mode Notification) timer value for
hw-mode switch. These commands can enable/disable the sending of Opmode
IEs in the beacons after HW mode switch and also configure the time for
which the IE will be sent after the switch.
* Add command to change primary interface when switching dynamically to
DBS mode.
Change-Id: Iceb8e29a46fa4873d3cbd7e41ec0da3782a5dd22
CRs-Fixed: 2560684
Add WMI and objmgr support for maintaining RNR
buffer cache and receive tbtt events for all
vdevs using existing tbtt offset WMI.
Change-Id: Idfed63e104e629fbe455d1cf6202cd9b332f5cf9
Remove pdev and vdev control path handles from data path.
Instead send pdev_id and vdev_id along with opaque soc
handle in ol_if_ops.
Change-Id: I6ee083f07e464f283da0d70ada70a4e10e18e1b2
In cases were all the tso tx descriptors are outstanding,
the alloc for any subsequent tso packet will fail.
This failure to get a tso tx descriptor floods the
console with failure logs.
Ratelimit the tso descriptor allocation failure and
increment the alloc failure in stats to get the exact
number of times the allocation failed.
CRs-Fixed: 2572580
Change-Id: I789788b917421be99df5435ad858d715ef0f5c8e
Add an enum that enables/disables coexistance of UNII-1 and
UNII-2A band channels.
CRs-Fixed: 2570364
Change-Id: I30cdda555675e4772aff59ebbbacfdd79f699af5
Add support to account for TSO jumbo packets on the
Tx path and print the statistics using dumpStats 3.
Change-Id: I6cc446df5c84e3ac436d922935fcd559e0704ec5
CRs-Fixed: 2356244
Add parameter to know if MBSS feature is enabled or disabled.
During 'wifi detect', the wireless config file is changed and
there's no way to figure out status of MBSS feature.
Change-Id: Ie56244097fd15efc71213f23e5afcb57188c9386
CRs-fixed: 2531506
Peer rssi is updated with the rssi measured on primary 20 and
not on the entire bandwidth.
Scale the peer rssi value by packet bandwidth offset.
Packet bandwidth offset for packet bandwidth of 20/40/80/160 is
0/3/6/9 dB.
Change-Id: I13eb8c17ec9828c0025d6b3a92a8b26b971268a1
CRs-Fixed: 2518598
MDNS packets if forwarded for a NAN vdev can lead to potential flooding
of the air interface. Hence donot forward them.
Change-Id: Idfdedfb0b5b553745440587448230013f3b56a7d
CRs-Fixed: 2503360
Process smart antenna fields from tlv
HTT_PPDU_STATS_USR_COMPLTN_COMMON_TLV in tx
completion path and export it to tx_completion.
Change-Id: If14e711b0aee8e583fd329f3c3915904649ffe47
CRs-Fixed: 2491429
This feature enables user to change HW mode dynamically
from DBS to DBS_SBS mode and vice-versa. Currently, HW
mode configuration is only possible through INI setting
requiring a subsequent reboot.
Relevant DP changes are:
1. Add API cdp_txrx_handle_pdev_status_change to pass
pdev 'up' or 'down' status to DP module
2. Add pdev-status check in dp_rx_process_invalid_peer
3. Add pdev-status check in dp_tx_comp_handler to free
buffer and release descriptor
Change-Id: I74b144abb1b0dc41a26a18ad28f872e6457e9653
CRs-fixed: 2490212
Size of rx_pkt_hdr tlv structure is used to check if there is enough
space in the SKB to add radiotap header.
The issue is seen due to a single SKB can hold the multiple TLVs and
the next subsequent SKB has the data. In this case, there is no headroom
available in the second SKB. Therefore crash seen while adding the
radiotap header in the second SKB.
To fix this issue, check if the SKB has enough headroom space. If not,
drop the frame.
Change-Id: Icd11f946c0aee974dde2ef21f59cfe3d8b87fa5d
CRs-Fixed: 2480719
A radio level parameter for configuring if external channel selection on
the radio is in progress is required to reduce the number of external
channel selection requests by the radio.
Add the parameter OL_ATH_EXT_ACS_REQUEST_IN_PROGRESS for this purpose.
Change-Id: I30ce066e840b11fe23158b896977fbf3924dbbf3
CRs-Fixed: 2483737
Add enum for baseline radio level channel width. This is required for
some low level use cases which need the original width configured into
the radio when channel is configured, rather than per-VDEV protocol
level width which might vary.
Change-Id: I8215003774bc46403a038011e7581517d25b94f9
CRs-Fixed: 2474794
Add enum pdev configuration param to
- Set PD threshold value
- Set enable/disable PD transmission
Change-Id: I76209a316552b63f72df9a812a5491517b7f1277
CRs-Fixed: 2429269
Non raw traffic gets enqueued to VAP in raw mode
and incorrect fc.type causes HW fault.
Lets proceed only if raw frame is of type data.
Change-Id: I9f0d608cd1b319feb9af642969b258aab813645f
CRs-Fixed: 2434391
Add WMI commands:
1) WMI_PDEV_PARAM_SET_MGMT_TTL
Enable/Disable/Set MGMT_TTL in milliseconds.
2) WMI_PDEV_PARAM_SET_PROBE_RESP_TTL
Enable/Disable/Set PROBE_RESP_TTL in milliseconds.
3) WMI_PDEV_PARAM_SET_MU_PPDU_DURATION
Set global MU PPDU duration for DL (usec units)
4) WMI_PDEV_PARAM_SET_TBTT_CTRL.
Set TBTT CTRL value BITS 0 - 2
(refer to WMI_TBTT_CTRL_CFG enum)
Change-Id: Iedda500fdb7bdedcc11fef31f0b29ad3f1812a43
CRs-Fixed: 2415745
Tx completion stats should be counted per wbm ring on tx completion
and not globally. Similarly, rx stats should be counter per reo ring.
Change-Id: I1e4af0d38b23e60de78ca03316861db08ff0811a
Add configuration option for enabling/disabling acs channel
grade algo along with configurations channel efficieny
variance and weightages for near mid and far range OBSS
used in algo.
Change-Id: I21fffc6f96d78634bc6ced6ac76a61d87a7d4bb9
CRs-Fixed: 2453992
