The kernel-doc script identified a large number of documentation
issues in dp/wifi3.0/dp_htt.[ch], so fix those issues. In addition,
there are a number of instances where public functions have their
implementation documented instead of having their interface
documented, so move that documentation.
Change-Id: Ic8eb4c5e7f04de45a785aa4278cb97f1895e53d1
CRs-Fixed: 3373162
Change module id to QDF_MODULE_ID_DP_HTT for hexdump printing
of hw vdev stats.
Change-Id: Ie9db76aa04241680236aa6b23a4ee65b5fd89d23
CRs-Fixed: 3343177
Add support and ops for initialization and
deinitialization of Direct Link refill ring.
Change-Id: I2c7018c4f8411fb7a590cfbb8b991f9152b22397
CRs-Fixed: 3316656
For WMI messages RTPM get is done during HTC message send and the
corresponding put is done in Tx failure or in Tx completion handler
for Tx success case. In the case where Tx completion is not received
for WMI messages RTPM put is not done as part of the cleanup which
results in RTPM Get and PUT call out of sync issues.
To fix the issue as part of HTC cleanup do RTPM put for WMI messages
for which tx completion is not received.
Change-Id: If92f4bd8a6c104d7ccef1e33b31aa765ea6100bd
CRs-Fixed: 3315404
add debug prints and a custom timer for how long to wait to receive next
bk pressure event message.
Change-Id: I5a736b0f134cd179990de536da02967db3e39774
CRs-Fixed: 3273427
Error Handling in Event Based Mechanism to reduce
delay by removing sleep while getting response
from firmware.
Change-Id: I9ee8e03b0d0ebdaae150417fb0fb0531e5bf4a86
CRs-Fixed: 3268808
Change macro IPA_WDI3_RX_TWO_PIPES to IPA_WDI3_VLAN_SUPPORT to represent
the feature supported under this macro
Change-Id: Ie1e387d641052cd5690c63f0c1216f4852544605
CRs-Fixed: 3250264
UMAC reset prerequisite setup command contains the following information.
- Interrupt number to be used for raising the UMAC reset interrupt
- Address of the shared memory
This is an HTT command. Send this command as part of the UMAC reset
initialization sequence.
Change-Id: I7a08f48b420580b5e3dbb9b46f6605d986f8fd89
CRs-Fixed: 3244930
In IPA offload, both tagged and untagged traffic cannot be handled with
a single rx pipe. Hence, add support for 2nd RX pipe for tagged and
untagged traffic respectively.
Change-Id: I77ff633327696f66df42fb592492321c1591646b
CRs-Fixed: 3226021
Add delta_tqm, delta_tsf2 and mlo timestamp offset for BE.
These offsets are used to calculate hardware Tx completion delay.
delta_tsf2 and delta_tqm are updated during init. mlo timestamp
offset is updated whenever target sends the update event.
Also, adding CDP ops to set the offsets.
Change-Id: I55665982798c3a795481fa96c023bb851ea17476
CRs-Fixed: 3220906
Properly increment message word variable while forming rx ring
selection config htt message. Message word should point to
appropriate word before calling individual feature config funcs,
this will help to track exact message word position in calling
function.
Change-Id: Iad6c446ac91fdb5be9286f4fa076847e1728dc74
CRs-Fixed: 3219549
This is a generic T2H message in which a target can specify bits and
offsets to extract a parameter from PPDU-id. Use link-id bit and offset
present in T2H message to extract hw link-id from PPDU-id on Tx completion.
Change-Id: I64b7559e88b037e30f52ba0b75ab62349e469d20
CRs-Fixed: 3195432
Usually, ADDBA frame exchange is handled by HOST. But when this
is offloaded to FW, an HTT event is reported and HOST only needs
to update RX tid parameters, no need to send addba resp frame again.
BA status update is in addba resp TX completion, so there is no chance
to update this field in ADDBA offload case. This change is used to
set ba status to active to make ba session in correct status.
Change-Id: Iae4a1974cf4b8c55b20862df51b14d5011aefd73
CRs-Fixed: 3201455
Add support for new HTT_T2H_MSG_TYPE_RX_ADDBA_EXTN and
HTT_T2H_MSG_TYPE_RX_DELBA_EXTN handling.
Change-Id: Ie06891092e5bf552bf721404222fb1b0b624ba36
CRs-Fixed: 3208118
Adding MLO timestamp offset reported from firmware to tsf time for
radiotap header.
Change-Id: I2947dacf6c37214e60d70fcb3df4a5f9897356ac
CRs-Fixed: 3211179
Update TLV length in peer map handler to correctly point to the next TLV
header.
Change-Id: Ie60c62040cb35b60a3bfbd302a176294903c94e6
CRs-Fixed: 3183057
Add function to setup/reset lite monitor filters
whenever lite monitor mode is enabled/disabled
respectively through cmd line.
Also add function to configure rx header tlv dma length.
Change-Id: Ia5d8bc36e1d033b3e15737bb6b9854f6a7cdd5df
CRs-Fixed: 3143570
In Beryllium architecture, PPDU_START_USER_INFO TLV carries
the user specific info for each user in a given ppdu.
Add subscription for this TLV by host for enhanced stats use case.
Change-Id: Ia12c5c3ab36198e7cd40dad0c0d92b945d2b49c6
CRs-Fixed: 3166305
Parse the tqm bypass frames packet count and byte count and consider
them for stats updation in the vdev.
Change-Id: I644eb9819b8a68fbf9da2e2f2588c80dfaa61fa5
CRs-Fixed: 3163215
Remove redundant field for rxmon global enable
and fix writing global enable field to correct
dword
Change-Id: I4efc0da559dce873bcb8721aeb0d7b7410b39dd9
CRs-Fixed: 3150784
Kiwi target does not used TX status ring.
Hence disable the tx status ring for Kiwi.
Change-Id: If3a39a0017a884bee2320188621b1f05e0c6d568
CRs-Fixed: 3150815
Kiwi target does not used TX cmd credit ring.
Hence disable the tx cmd credit ring for Kiwi.
Change-Id: Ibd5fe2905a7362ea2ab89e65d77c7aea6ab259ee
CRs-Fixed: 3150814
Add the DP HTT RxDMA and RxOLE data types and their
respective configuration APIs.
Change-Id: I4ce423a31eab84764666b7d0f11815f4895898af
CRs-Fixed: 3147720
As part of TX FW metadata V2 global sequence number based
and SVC ID based support added.
Change-Id: Iefee2c47ecbebf6edfec9a687ef67e0e270bbf06
CRs-Fixed: 3136931
As part of debug enhancement Print ring information in
htt srng init and htt srng cfg
Change-Id: I59a7831b6ded1028b3a8f246656e982ae7de5b86
CRs-Fixed: 3133836
Added change:
1. Set/reset RXDMA MON STATUS ring filter setting and send HTT
message to capture undecoded frame
2. Handle undecoded frame to update cdp_rx_indication_ppdu structure
from hal ppdu_info rx status and generate WDI event to deliver it
to upper layer
Change-Id: I14485f28333b113b5a2fab639611551c2b08af2b
Add default queue map config msg handler. This msg is sent by the target
in response to a default queue map request.
Change-Id: Id08e0b175172614514b9fb2dcabcc5f7f068896f
CRs-Fixed: 3126854
- Fixes for compilation issues after enabling
monitor 2.0 support.
- change copyright year for all files in the chain.
Change-Id: I885e257bd8ca83850656d8a1f408c1bc34920d7a
CRs-Fixed: 3086483
For WCN7850, the first mac (i.e.. MAC0) is capable of
2G/5G and 6G data transfer. Hence initialize and use
only on RXDMA monitor status ring.
Change-Id: Idb6e23a887a9ed32a52dd54765e5ed3c6a12df06
CRs-Fixed: 3094138
Multicast support for MLO
1. Following functions are newly added.
dp_rx_igmp_handler()
dp_tx_mlo_mcast_handler_be()
dp_rx_mlo_mcast_handler_be()
dp_mlo_get_mcast_primary_vdev()
Change-Id: If215f843369e6e2621ef302b924e524c86f0d30b
WCN7850 has only one RXDMA DST ring, as opposed to other
lithium family chipsets, which had 2 RXDMA DST ring.
Refactor the code to pick the number of rxdma destination
rings from CFG context.
Change-Id: I20d475c02690043e969bc7a78605809b8c6814ae
CRs-Fixed: 3084440
Offsets used by host for HTT stats are not aligned as per the
structure declaration given in file htt.h .
Make change to use the correct offsets to get the correct stats.
Also make change for byte count computation.
Also make cleanup changes for FR65817.
Change-Id: I8bc6164cc4994c49536d7277779f25b258be1592
CRs-Fixed: 3082742
